Human Touch HT-100 - Manual
Human Touch HT-100 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
X1103
REPLACING AN ARMREST
Sept 28, 2009
To ensure that Human Touch
®
products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
SERVICE LEVEL: 3
REMOVING THE ARMREST
Tools Required:
Flat-head or Phillips screwdriver. SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY
1. Using two hands, pull firmly outward on the rear side panel cover to remove it (Fig.1).
2. Using two hands, pull firmly outward on the front side panel cover to remove it (Fig.2).
3. Using a Phillips-head or flat-head screwdriver, remove the two rear armrest screws (Fig.3).
4. Using a Phillips-head or flat-head screwdriver, remove the two front armrest screws (Fig.4).
5. Pull up on the armrest to remove it (Fig.5).
(Fig.1)
(Fig.2)
(Fig.3)
(Fig.4)
(Fig.5)
Armrest
INSTALLING THE NEW ARMREST
1. Place the armrest into position, aligning the two tabs on the front end with the corresponding slots on the chair (Fig.6).
2. Replace the two front armrest screws.
3. Replace the two rear armrest screws.
4. Using two hands, align the rear side panel posts with the corresponding guides on the chair, then press the cover firmly into place.
5. Replace the front side panel cover in the same manner.
Tabs
Please send any questions or comments regarding these instructions to:
© 2009 Human Touch®, LLC.
HT-100/102/103/410/430/450/3200/3300
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
