Human Touch Remote Control with Cable - Manual
Human Touch Remote Control with Cable – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Human Touch Confidential
Page 1
Human Touch
iJoy-100 Replacing the Remote Control
Initiator: MG
Replaces:
07/22/2003
Revision date: 08/03/2003
Title:
Replacement of the iJoy 100 Remote with Cable
Purpose: To provide end users with the procedure for replacement of the iJoy-100 Remote Controller AND
Cable assembly.
Tools/Parts Required: Phillips Screwdriver, diagonal cutters
Requires PN
iJoy Remote Assembly complete with Cable
Procedure:
1)
Turn off and unplug your iJoy
2)
As an option, you can carefully tip your unit onto its Right Side (the side opposite the
AC cord). This will make it easier to access the assembly and side cover.
3)
Locate The Side Panel Assembly. This is the plate that both the AC cord and
remote cord enter. This assembly also incorporates the ON/OFF switch.
4)
You will need to either remove the SN/Model information label from the Side Panel
Assembly, or locate the single screw hole covered by the label. You can find the
hole by feeling the sticker for a depression. Using the Phillips Screwdriver, gently
poke a hole to access the screw. See photo for screw location.
5)
Remove all Three (3) screws securing the Side Panel Assembly to the chair frame.
6)
Carefully lower the Side Panel Assembly. Caution: The Side Panel Assembly
remains connected via cables to the chair.
7)
Locate the white
11-pin
plug attaching the Remote Control to the Chair. Carefully
disconnect.
8)
Locate the four (4) screws securing the Remote Cable Clamp. Remove the four
screws, noting the position of the clamp and the Remote Cable Strain Relief.
9)
Slide the Controller Cable out of its holder. Slide the new Controller and cable into
position.
10)
Slide the Remote Cable Clamp back into position. Ensure the tab on the cable
clamp aligns with the insert slot in the cable/cable strain relief.
11)
Reinsert the four (4) screws removed in step 8.
12)
Reinstall the side panel assembly with the three screws removed in step 5.
13)
Plug the iJoy back into the wall outlet, and turn the Main Power Switch on.
14)
Test the chair for proper operation.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
