Human Touch HT-5320 - Manual
Human Touch HT-5320 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
X1103
H T -5320
06/01/08
REMOVING THE REMOTE CONTROL
1. Power off the chair and unplug it.
2. Locate the remote control connection to the backrest cover (Fig.1).
3. Using a Phillips-head screwdriver, remove the two screws that
secure the remote control cord to the backrest cover.
4. Pull the remote control cables through the backrest cover, then
disconnect the cables.
INSTALLING THE NEW REMOTE CONTROL
1. Connect the new remote control cables to the backrest remote control
cables, then push the cables into the backrest.
2. Using a Phillips-head screwdriver, replace the two screws that secure
the remote control cord to the backrest cover.
3. Power on the chair and verify that the new remote control works properly.
Tools Required: Phillips-head screwdriver
NOTE: SAVE ALL SCREWS FOR USE DURING REASSEMBLY.
Please send any questions or comments regarding these instructions to: [email protected]
© 2008 Human Touch
®
, LLC.
(Fig.1)
Remote control cable
REPLACING THE REMOTE CONTROL
To ensure that Human Touch
®
products are repaired in a manner that is fully consistent with the practices used during the manufacturing process, Human Touch requires that all
product repairs are performed using only factory-new parts and in accordance with these product repair instructions.
SERVICE LEVEL: 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
