HP T1120 - Manual
HP T1120 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Clips facing; the flap on the end, and then lift the lid off.; Description; scanner fixing; Learning Products Barcelona - Hewlett Packard Company
- Page 3 – Torx M5x25 scanner fixing screws. Insert; the back and its flat edge facing the
- Page 7 – Your scanner screen will flash on and
- Page 8 – NOT FINAL IMAGE; NOT FINAL IMAGE; PROVISIONAL; NOT FINAL IMAGE; Define one or more initial destinations; Enter your network settings to join your
Read these instructions carefully...
What you will need for this procedure:
Because the scanner is heavy, you will
need two people to unpack and set it up.
When two people are needed, the symbol
at the foot of this box is displayed.
You are required to clean the scan area
glass plate during the assembly procedure:
To do so you will need clean lint free
cloths and a mild, streak-free glass cleaner.
These are not provided with the scanner.
HP Designjet T1120 SD-MFP
Assembly Instructions
©
2009
Hewlett-Packard Company
Inkjet Commercial Division
Avenida Graells 501 · 08174
Sant Cugat del Vallès
Barcelona · Spain
All rights reserved
Printed in Germany Imprimé en Allemagne Stampato in Germania
Your printer should already be assembled
and working before starting this proce-
dure. For instructions on how to assemble
the printer, please refer to the assembly
poster included with the printer.
Assembly poster
EN
Learning Products Barcelona - Hewlett Packard Company
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Raise the flap, and lift the lid off Unpacking stand Take the 2 feet out of the box. Take the leg structure from the box and place it, with the clips forward up, on the floor. Clips facing forward Take one of the feet from the box. Align the foot with the leg on the leg structure, making sure it is ...
Turn the legs upside down, and attach the two feet to the left and right legs using four M6×30 screws (two for each foot). Tighten the screws with the T-handle Torx driver T30 found in the assembly kit. 9 Using 2 people; lift the scanner from the box and place it on the Top Tray. Align the scanner’s...
bb 37 Feed the power extension cable through the leg: Insert the end of the cable in the top hole (a) and pull it out of the bottom hole (b). Push the hole covers back down and tighten the screws (c). Connect the power extension cable’s plug end to the scanner. 38 Connect the scanner power cable to ...
