Honeywell RLV450- Manual
Honeywell RLV450– Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Daylight Savings Time; Setpoint; Configuration
- Page 3 – Schedule; Power Outage
- Page 4 – Warranty
- Page 5 – PIÈCES FOURNIES; Description; Installation à 2 fils; Guide de l’utilisateur; Thermostat programmable
- Page 6 – Passage automatique à l’heure avancée/normale; Consigne; Réglages de l’heure et du jour
- Page 7 – Horaire; Panne de courant
- Page 8 – Garantie
RLV450
69-2201EF-03 2009-08-04 1/4
*
LP
appears only for the first two minutes when the thermostat is without power. This
can occur during a power outage or when the thermal protection device inside the base-
board heater is opened.
This programmable thermostat can be used to control an electric
heating system such as an electric baseboard heater, a radiant ceil-
ing, a radiant floor, a convector or a fan-forced heater.
The thermostat cannot be used with:
•
a resistive load over 16.7 A
•
a resistive load under 2 A
•
a system driven by a contactor or relay (inductive load)
•
a central heating system
SUPPLIED PARTS:
•
One (1) thermostat
•
Two (2) 6-32 screws
•
Two (2) solderless connectors
TURN OFF POWER TO THE HEATING SYSTEM AT THE MAIN
POWER PANEL TO AVOID ELECTRICAL SHOCK. THE INSTAL-
LATION MUST BE PERFORMED BY AN ELECTRICIAN.
All cables and connections must conform to the local electrical
code.
Special CO/ALR solderless connectors must be used when con-
necting with aluminum conductors.
Install the thermostat onto an electrical box.
Install the thermostat about 1.5 m (5 feet) high, on an inside wall
facing the heater.
Avoid locations where there are air drafts (such as the top of a
staircase or an air outlet), dead air spots (such as behind a
door), or direct sunlight.
Do not install the thermostat on a wall that conceals chimney or
stove pipes.
The thermostat wires are not polarized; either wire can be con-
nected to the load or to the power supply.
NOTE:
Always keep the thermostat's vents clean and unobstructed.
n
o
Connect the thermostat wires to the line wires and to the load
wires using solderless connectors for copper wires.
p
Push any excess wire back into the electrical box.
NOTE:
If necessary, before re-installing the front component, config-
ure the thermostat (see section 3).
q
Return power to heating system.
n
Description
1.
o
Installation
2.
Select the mode
of operation
Set the time
Time and day
Temperature
Indicates the current
mode of operation
Skip a period
Program the schedule
Temperature
preset icon
Temperature
adjustment
buttons
Temperature
preset buttons
Indicates the
heating power
Indicates the current
period (appears in
automatic mode only)
Indicates that the
temperature setpoint
is displayed
Set the day
Indicates that the
thermostat is configured
for a fan-forced heater
Indicates that the ther-
mostat is without power *
Indicates that the
settings are locked
2-wire installation
4-wire installation
RLV450
User Guide
Programmable Thermostat
400-106-021-D_69-2201EF-03 (RLV450 Honeywell TH106B) ENG.fm Page 1 Tuesday, August 4, 2009 4:33 PM
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Honeywell RLV450
Summary
RLV450 69-2201EF-03 2009-08-04 2/4 The configuration switches are on the back ofthe thermostat. The factory settings are indi-cated by the grey cells in the following table. n Press the Hour button to set the hour. o Press the Min button to set the minutes. p Press the Day button to set the day. q P...
RLV450 69-2201EF-03 2009-08-04 3/4 The schedule consists of 4 periods per day which represents a typi-cal weekday. You can program the thermostat to skip the periods thatdo not apply to your situation. For example, you can skip periods 2and 3 for the weekend. The Comfort ( ) temperature is used in p...
RLV450 69-2201EF-03 2009-08-04 4/4 Honeywell warrants this product, excluding battery, to be free fromdefects in the workmanship or materials, under normal use and ser-vice, for a period of one (1) year from the date of purchase by theconsumer. If at any time during the warranty period the product i...
