Honeywell R841C-E- User Manual
Honeywell R841C-E– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TRADELINE MODELS; TRADELINE MODELS A VA; STANDARD MODELS; COMPLETE ORDERING NUMBER, OR
- Page 3 – IN
- Page 6 – TYPIC
- Page 7 – H O N E Y W E L L
Honeywell
THE R841 ELECTRIC HEATING RELAY IS
USED WITH A 2-WIRE, 24V THERMOSTAT
TO PROVIDE CONTROL OF ELECTRIC
HEATING EQUIPMENT. IT IS A DIRECT-
FOLLOWING RELAY WHICH OPERATES
WITH EACH CYCLE OF THE THERMO-
STAT (4 TO 6 CYCLES PER HOUR).
❑
models are used to control one
load.
❑
is used either with one thermostat
to control two loads simultaneously, or with
two thermostats to control two independent
loads.
❑
and E models include an integral
transformer; R841 D model must be powered
from a remote 24V transformer.
❑
and D models have a 1/2 inch male
conduit bushing.
❑
The
and E models are for instal-
lation on a wireway or J-box.
❑
R841 E has a 1/2 inch male conduit bushing
and includes an enclosure with a low voltage
wiring compartment.
❑
Special
with 10 second minimum
timing between stages is available.
❑
Each relay switches up to a 5,000 watt load.
❑
Spst MICRO SWITCH snap switches are
actuated by ambient-compensated
strips.
❑
Leadwires are provided for both line voltage
and low voltage connections.
❑
Small size and silent operation allow instal-
lation in living area, utility room, or basement,
❑
May be mounted in any convenient position.
REV. 10-79 (.11)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Honeywell R841C-E
Summary
IMPORTANT THE SPECIFICATIONS GIVEN IN THIS PUBLICATION DO NOT INCLUDE NORMAL MANUFACTURING TOLERANCES.THEREFORE, THIS UNIT MAY NOT MATCH THE LISTED SPECIFICATIONS EXACTLY .ALSO, THIS PRODUCT IS TESTEDAND CALIBRATED UNDER CLOSELY CONTROLLED CONDITIONS, AND SOME MINOR DIFFERENCES IN PERFOR-MANCE CAN B...
LEADWIRE LENGTH (NOMINAL): Line voltage–18 in. [457.2 mm].Low voltage–7-l/2 in. [ 190.5 mm]. Line voltage–8 in. [203.2 mm]. Low voltage–4 in. [ 101.6 mm]. CASE FINISH: Zinc bichromate.CONDUIT BUSHING: have a 1/2 in. [12.7 7/8 in. [22. 2 mm] knockouts in back and sides of case for 1/2 in. [ 12.7 mm] ...
2 - W I R E 24 V — (L3 FOR 208, 240, OR 277 V] DISCONNECT REQUIRED 2-WIRE 24 V 24 V THERMOSTAT THERMOSTAT NO NO. 2 RED - (L3 FOR 208,240, OR V) RE Q U I R E D . T H E R M O S T A T FIG. IO–TYPICAL WIRING HOOKUP FOR R841E FIG. II–TYPICAL WIRING HOOKUP FOR R841E WITH ONE THERMOSTAT OPERATING WITH TWO ...
