Page 2 - WARNING; COPYRIGHT NOTICE; Impress Tryout; Preliminary - Subject To Change Without Notice
WARNING Prior to the export of this document, review for export license requirement is needed. COPYRIGHT NOTICE ©2002 Honeywell International Inc. Reproduction of this publication or any portion thereof by any means without the express written permission of Honeywell is prohibited. For further infor...
Page 3 - REVISION HISTORY; KT 73 Installation Manual
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page RH-1 REVISION HISTORY KT 73 Installation Manual Part Number: 006-10563-XXXX For each revision, add, delete, or replace pages as indicated. REVISION: Rev 0, October/2002 ITEM ACTION New manual No previous manual revision exists. Impress Tryout Pr...
Page 4 - THIS PAGE IS RESERVED
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page RH-2 THIS PAGE IS RESERVED Impress Tryout Preliminary - Subject To Change Without Notice
Page 5 - TABLE OF CONTENTS; SECTION I; SECTION II
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page TC-1 TABLE OF CONTENTS SECTION I GENERAL INFORMATION PARAGRAPH PAGE 1.1 INTRODUCTION 1-1 1.2 EQUIPMENT DESCRIPTION 1-1 1.2.1 GENERAL DESCRIPTION 1-1 1.2.2 HARDWARE 1-1 1.2.3 FEATURES 1-2 1.3 TECHNICAL CHARACTERISTICS 1-3 1.3.1 KT 73 TECHNICAL CH...
Page 7 - TABLES; TABLE
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page TC-3 FIGURES (cont). FIGURE PAGE 3-6 KT 73 STANDBY MODE 3-10 3-7 KT 73 GROUND MODE 3-10 3-8 KT 73 ON MODE 3-11 3-9 KT 73 ALTITUDE MODE 3-12 3-10 KT 73 FLIGHT ID MODE 3-13 3-11 KT 73 TEST MODE 3-13 TABLES TABLE PAGE 2-1 INSPECTION/CHECK PROCEDURE...
Page 9 - INTRODUCTION; General Description
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 1-1 SECTION I GENERAL INFORMATION 1.1 INTRODUCTION This manual contains information relative to the physical, mechanical, and electrical characteris-tics of the Honeywell KT 73 Mode S Transponder. Installation and operating procedures are also i...
Page 10 - Features
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 1-2 The KT 73 has an Air/Ground discrete which, when connected to a strut switch on the aircraft, can disable ATCRBS and Mode S All-Call replies when the aircraft is on the ground. A front panel switch position, ’GND’, can also be used by the pi...
Page 11 - TECHNICAL CHARACTERISTICS
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 1-3 1.3 TECHNICAL CHARACTERISTICS 1.3.1 KT 73 TECHNICAL CHARACTERISTICS NOTE: All measurements are made with a 2.0 dB cable lossat the antenna end. TSO COMPLIANCE: SEE ENVIRONMENTAL QUALIFICATIONS APPENDIX PHYSICAL DIMENSIONS: See figure 2-4 WEI...
Page 14 - UNITS AND ACCESSORIES SUPPLIED; CONFIGURATIONS AVAILABLE
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 1-6 1.4 UNITS AND ACCESSORIES SUPPLIED 1.4.1 CONFIGURATIONS AVAILABLE P/N 066-01164-0101 is the only version of the KT 73 that is currently available. Included with the KT 73 is the mounting rack and the configuration module. The configuration m...
Page 15 - ACCESSORIES REQUIRED, BUT NOT SUPPLIED
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 1-7 1.5 ACCESSORIES REQUIRED, BUT NOT SUPPLIED The following parts are recommended for a cable setup with dimensions of 4.5 feet to 11 feet: (See Figure 2-12, Sheet 1 of 2). The following parts are recommended for a cable setup with dimensions o...
Page 17 - GENERAL INFORMATION; GENERAL
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-1 SECTION II INSTALLATION 2.1 GENERAL INFORMATION This section contains suggestions and factors to consider before installing the KT 73 Mode S Tran-sponder. Close adherence to these suggestions will assure a more satisfactory performance from ...
Page 24 - DO NOT OVERTIGHTEN THE LOCKING FASTENER; Aircraft Address Programming Options
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-8 2.3.5 KT 73 INSTALLATION The mounting tray for the transponder should be mounted using the dimensions specified in the outline and mounting drawing, Figure 2-4. The mounting tray should be wired according to the system interconnect diagram, ...
Page 35 - Description; LIGHTING; FIGURE 2-3 KT 73 Pinout Diagrams
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-19 Main Connector - JKT73-1 Front View Pin # I/O ............................ Description 1 O ........................... AIRCRAFT GROUND 2 I............................. +14 V DC LIGHTING 3 I............................. +28 V DC LIGHTING 4 I...
Page 37 - Pin
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-21 External Connector - JKT73-4 Front View Pin I/O ......................... Description A I............................. AUDIO INHIBIT B O ........................... AIRCRAFT GROUND C I............................. ARINC429 RX 1A/RS232 RX D ...
Page 39 - FIGURE 2-4 KT 73 INSTALLATION DRAWING
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-23 FIGURE 2-4 KT 73 INSTALLATION DRAWING (Dwg. 155-06046-0000 Rev. D) Impress Tryout Preliminary - Subject To Change Without Notice
Page 41 - FIGURE 2-5 SINGLE KT 73 BASIC INTERCONNECTION DRAWING
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-25 FIGURE 2-5 SINGLE KT 73 BASIC INTERCONNECTION DRAWING (Dwg. 155-01689-0001 Rev. -) Impress Tryout Preliminary - Subject To Change Without Notice
Page 43 - FIGURE 2-6 SINGLE KT 73 WITH TIS INTERCONNECTION DRAWING
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-27 FIGURE 2-6 SINGLE KT 73 WITH TIS INTERCONNECTION DRAWING (Dwg. 155-01689-0002 Rev. -) Impress Tryout Preliminary - Subject To Change Without Notice
Page 45 - FIGURE 2-7 SINGLE KT 73 WITH ADLP OR ADS-B INTERCONNECTION DRAWING
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-29 FIGURE 2-7 SINGLE KT 73 WITH ADLP OR ADS-B INTERCONNECTION DRAWING (Dwg. 155-01689-0003 Rev. -) Impress Tryout Preliminary - Subject To Change Without Notice
Page 49 - FIGURE 2-9 DUAL KT 73 BASIC INTERCONNECTION DRAWING
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-33 FIGURE 2-9 DUAL KT 73 BASIC INTERCONNECTION DRAWING (Dwg. 155-01689-0005 Rev. -, Sheet 1 of 2) Impress Tryout Preliminary - Subject To Change Without Notice
Page 59 - FIGURE 2-11 RF CONNECTOR DRAWING
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-43 FIGURE 2-11 RF CONNECTOR DRAWING Impress Tryout Preliminary - Subject To Change Without Notice
Page 61 - FIGURE 2-12 ACCEPTABLE CABLE CONNECTIONS DRAWING
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-45 FIGURE 2-12 ACCEPTABLE CABLE CONNECTIONS DRAWING (Sheet 1 of 2) Impress Tryout Preliminary - Subject To Change Without Notice
Page 63 - FIGURE 2-13 CABLE CONNECTOR DRAWING
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-47 FIGURE 2-13 CABLE CONNECTOR DRAWING Impress Tryout Preliminary - Subject To Change Without Notice
Page 64 - FIGURE 2-14 TYPE “N” AND “C” CONNECTOR ASSEMBLY DRAWING; PART NUMBER SIZE DIMENSION
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-48 FIGURE 2-14 TYPE “N” AND “C” CONNECTOR ASSEMBLY DRAWING PART NUMBER SIZE DIMENSION RG/U CABLE A B C D 024-00075-0000 393 9/32 1/8 5/32 3/64 024-00051-0060 400 9/32 1/8 5/32 3/64 Impress Tryout Preliminary - Subject To Change Without Notice
Page 65 - FIGURE 2-15 BNC CONNECTOR ASSEMBLY DRAWING
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-49 FIGURE 2-15 BNC CONNECTOR ASSEMBLY DRAWING Impress Tryout Preliminary - Subject To Change Without Notice
Page 69 - TABLE 2-2 RAMP TESTS
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 2-53 1) Rotate ident code selector knob. Verify the most significant digit increas-es from zero to seven with clockwise rotation and decreases with a counter-clockwise rotation. 2) Repeat step 1) for the remaining three digits of the squawk code...
Page 73 - FIGURE 3-1 KT 73 FRONT PANEL; PROGRAMMING MODE; The programming mode is entered using the following procedure:
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 3-1 SECTION III OPERATION 3.1 GENERAL Section 3 describes the operation of the KT 73. Where applicable, illustrations of the displays are furnished to assist the operator in understanding the operation of the unit and also provide a visual aide ...
Page 75 - FIGURE 3-2 KT 73 CONFIGURATION MENU
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 3-3 FIGURE 3-2 KT 73 CONFIGURATION MENU Impress Tryout Preliminary - Subject To Change Without Notice
Page 77 - FIGURE 3-3 KT 73 FIRST 4 OCTAL DIGITS OF THE AIRCRAFT ADDRESS
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 3-5 3.2.1 PROGRAMMABLE PARAMETERS 3.2.1.1 Programmable Parameters The following parameters must be programmed prior to installation: A/C ADDR: When the unit is in the A/C ADDR (Aircraft Address) program menu: (a) The aircraft address is programm...
Page 78 - FIGURE 3-5 KT 73 LOWER AND UPPER MAXIMUM AIRSPEED; The ALT SRC (altitude source) is programmable to the following:
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 3-6 MAX AIR: When the unit is in the MAX AIR (Maximum Airspeed (knots)) program menu the maximum air-speed is programmable to one of the following ranges: (a) 0 to 75 (b) 75 to 150 (c) 150 to 300 (d) 300 to 600 (e) 600 to 1200 (f) --- to 1200 FI...
Page 81 - DETAILED OPERATING MODES
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 3-9 (c) Category set “C” code: 0 No ADS-B Emitter Category Information 1 Surface Vehicle - Emergency Vehicle 2 Surface Vehicle - Surface Vehicle 3 Fixed Ground or Tethered Obstruction 4-7 Reserved (d) Category set “D” code: 0 No ADS-B Emitter Ca...
Page 82 - FIGURE 3-6 KT 73 STANDBY MODE; The 4096 code will be displayed in the Ident window.; FIGURE 3-7 KT 73 GROUND MODE
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 3-10 SBY: (see below) FIGURE 3-6 KT 73 STANDBY MODE When the unit is in the SBY (Standby) mode: (a) The unit is energized but inhibited from replying to any interrogation. (b) "SBY" will be annunciated in the Altitude window. (c) The 409...
Page 84 - FIGURE 3-9 KT 73 ALTITUDE MODE; The unit will display the 4096 Code in the Ident window.
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 3-12 ALT: (see below) FIGURE 3-9 KT 73 ALTITUDE MODE When the unit is in ALT (Altitude) mode: (a) The unit will transmit altitude information according to DO-181C paragraph 2.2.13.1.2(a)(1) in response to accepted Mode C interrogations. (b) The ...
Page 90 - TABLE 3-1 BITE FAULT CODES
BENDIX/KING KT 73 Rev 0, October/2002 10563I00.JA Page 3-18 TABLE 3-1 BITE FAULT CODES Primary Fault Fault Code(X) Secondary Fault Fault Code(YY) SEVERITY Acquisition Squitter 1 Squitter Data 01 Critical Acquisition Squitter 1 Squitter Rate 02 Critical Extended Squitter 1 Squitter Data 03 Critical E...