Honeywell HMR4007- Manual
Honeywell HMR4007– Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – SENSOR PRODUCTS; INTRODUCTION; Radial mode magnet
- Page 3 – SPECIFICATIONS; must be configured by the user.
- Page 4 – PIN CONFIGURATION; Pin Number; Digital Interface; CIRCUIT DESCRIPTION
- Page 5 – PHYSICAL CHARACTERISTICS; -40NF mounting holes; Figure 1 – Sensor board layout and connector pin designations
- Page 6 – APPLICATION NOTES; USING THE HMR4007 AS A STAND ALONE SENSOR; ONE; Analog Outputs; Status Pin
- Page 7 – USING THE HMR4007 IN DIGITAL COMMUNICATIONS MODE; Connector J1 General Description
- Page 8 – normal position response; where 1024 represents full scale response.; communications failure.; The sensor failed to respond to the PC quickly enough. This is; position error; at the sensor
HMR4007
SENSOR PRODUCTS
HMR4007
Linear Position Sensor
User’s Guide
Solid State Electronics Center
•
www.magneticsensors.com
•
(800) 323-8295
•
Page 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Honeywell HMR4007
Summary
HMR4007 SENSOR PRODUCTS INTRODUCTION The Honeywell HMR4007 is an electronic linear position sensing solution for use in commercial and industrialapplication environments. A stationary array of Honeywell’s magnetoresistive (MR) sensors is utilized to quickly andaccurately monitor the position of a sm...
HMR4007 SENSOR PRODUCTS SPECIFICATIONS Characteristics Conditions Min Typ Max Units General Accuracy 0.2 0.1 mm Resolution 0.1 mm Hysteresis 0.01 mm Repeatability 0.01 0.1 mm Update Rate 10 30 Hz Standoff Distance (gap) between the target magnet and the sensor board 0.1 5 (note 1) mm Magnetic Field ...
HMR4007 SENSOR PRODUCTS PIN CONFIGURATION Pin Number Pin Name Description Digital Interface 1 RTS Serial Clock Output 2 Data_Out Serial Data Output 3 Data_In Serial Data Input 4 CTS Serial Clock Input 5 Power Unregulated Power Input (+6 to +28 VDC) (see note 1) 6 GND Power and Signal Ground Analog I...
