Honeywell GSMX - Manual

Honeywell GSMX

Honeywell GSMX – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
Page: / 2
Loading the manual

GSM-EAA External Antenna Accessory – Quick Installation Guide

For Online Support visit: http://www.security.honeywell.com/hsc/resources/MyWebTech/

INTRODUCTION:

The Honeywell GSM-EAA External Antenna Accessory (referred to as the Antenna Accessory) enables the GSMX and GSMVLP
products to use an external antenna. Coax Cable K14207LF is required for any external antenna. This cable is not included

with the Antenna Accessory.

Installation Instructions for the GSMX

1.

Open the cover. Ensure power is removed by disconnect-

ing the ECP cable. Refer to diagram below.

Note:

If the MAC/SIM label was placed on the internal

antenna, carefully peel this off, and place on the enclo-
sure where it would be visible.

2.

Remove three [3] screws that secure the PC board, and

lift out.

3.

From the back of the PC board, remove one [1] screw that
secures the antenna, then remove the internal antenna.

4.

From the front of the PC board, orient the hook on the

Antenna Accessory over the right side of the PC board
and swing it into position.

5.

From the back of the PC board, fasten the Antenna

Accessory with the screw provided (long).

6.

Remove the plug at the top of the enclosure.

7.

Attach the MMCX end of the coax cable to the Antenna
Accessory ensuring the connector snaps into position.

8.

Route the SMA end of the coax cable to the hole at the top

of the enclosure, and secure with the lock washer and nut.

9.

Replace the PC board into the enclosure, and fasten with

three [3] short screws.

10.

Connect the ECP cable.

11.

Close the GSMX cover and secure with screw. Attach an

external antenna.

GSM-EAA-004-V0

COAX CABLE
K14207LF
(NOT SUPPLIED)

GSM-EAA

ANTENNA

ACCESSORY

INTERNAL ANTENNA

(REMOVE)

SMA
CONNECTOR

MMCX
CONNECTOR

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other Honeywell Models