Honeywell CT87N - User Manual
Honeywell CT87N Thermostat – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Label wires and remove old wallplate
- Page 3 – Electrical Ratings; Mount thermostat base; Existing wires Connect to:; Connect wires
- Page 4 – Finish installation; Set cycle rate switches
- Page 5 – Operation; Temperature setting; -year limited warranty; Temperature
- Page 6 – Vérifier le contenu de; Retrait de l'ancien thermostat
- Page 7 – Étiquetage des fils et retrait de l'ancienne plaque murale; Installation de la plaque de raccordement
- Page 8 – Installation de la plaque murale et de la plaque de raccordement; Les étiquettes ne; Fils existants; Raccordement; Caractéristiques Électriques
- Page 9 – Réglages du nombre de cycles; Montage du thermostat
- Page 10 – Garantie limitée de un an; Sélecteur du ventilateur; Fonctionnement
- Page 11 – Lista de comprobación previa a la instalación; Owner’s Manual; Remueva su viejo termostato
- Page 12 – Rotule los cables y retire la vieja placa de montaje; Repérez la position de montage
- Page 13 – Instalación de placa de montaje; Cableado CT87N; Cableado CT87K; ¿Los rótulos no coinciden?; Cables existentes; Conecte los cables; Regímenes eléctricos
- Page 14 – Finalice la instalación; Ajuste de funcionamiento del ventilador (CT87N)
- Page 15 – Interruptor del ventilador; Instrucciones de funcionamiento; Ajuste de temperatura; POLIZA DE GARANTIA
Owner’s Manual
English: Page 1
Mode d’emploi
Français : Page 6
Manual de Uso
Español: Página 11
CT87N/CT87K
The Round
®
® U.S. Registered Trademark. U.S. Patents 7,159,789;
7,159,790; 7,476,988 and other patents pending.
Copyright © 2019, Resideo Technologies, Inc.
All rights reserved.
M37778
69-1959EFS-04
The Round
®
1.
CAUTION
TURN OFF POWER to system at the furnace, or at the fuse/circuit
breaker panel before you begin.
2. Remove cover and thermostat, but leave wallplate with wires attached.
MERCURY NOTICE
If your old thermostat contains
mercury, contact your local waste
management authority for proper
disposal instructions.
Is there a sealed tube containing
mercury? If so, see mercury notice
below.
Leave wallplate in place.
Old thermostat
Cover
Check package contents:
• Thermostat
• Coverplate
• Wall anchors & screws (2 each)
• Wire labels
Before you begin, make sure
you have:
• No. 2 Phillips & small pocket
screwdrivers
• Hammer
• Level (optional)
• Pencil
• Drill and bit (3/16” for drywall, 7/32”
for plaster)
Getting started
Remove your old thermostat
CT87K
(24 Vac heating systems) •
CT87N
(24 Vac heating and cooling systems)
This thermostat contains a Lithium battery which
may contain Perchlorate material.
Perchlorate Material—special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/perchlorate
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Honeywell CT87N
Summary
CT87N/CT87K • Owner's Manual 69-1959EFS—04 2 Wrap supplied labels securely around each wire. Do not let wires fall into wall opening! IGNORE WIRE COLORS: Use only letter designations to identify wire types. For CT87N : If your old thermostat has 7 or more wires (not counting terminals C or C1 ), you...
English: Page 1 • Français : Page 6 • Español: Página 11 3 69-1959EFS—04 Wiring CT87N [1] If wires will be connected to both R and Rc terminals, remove the metal jumper. [2] Do not connect both O and B if you have a heat pump. Connect only the O wire. Wrap B wire with electrical tape and do not use....
CT87N/CT87K • Owner's Manual 69-1959EFS—04 4 1. Align the slots on the base with tabs on the thermostat, then push gently until the thermostat snaps into place. 2. Restore electrical power at the heating/ cooling system, or at the fuse/circuit- breaker panel. Move the switch to the proper setting fo...
