Honeywell CT87N - Manual
Honeywell CT87N Thermostat – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Label wires and remove old wallplate; Mount thermostat base
- Page 3 – Existing wires; Wiring; Subbase and base installation
- Page 4 – For gas or oil heating systems, leave; Fan operation settings
- Page 5 – Operation; CO; -year limited warranty
- Page 6 – Owner’s Manual; Retirer l’ancien thermostat
- Page 7 – Étiqueter les fils et retirer l’ancienne plaque murale.; Installation de la plaque de raccordement
- Page 8 – Les étiquettes ne; Raccordement; Installation de la plaque murale et de la plaque de raccordement
- Page 9 – Montage du thermostat
- Page 10 – Cool; Fonctionnement
- Page 11 – Lista de comprobación previa a la instalación; Remueva su viejo termostato
- Page 12 – Rotule los cables y retire la vieja placa de montaje; Repérez la position de montage
- Page 13 – Conecte los cables; ¿Los rótulos no coinciden?; Cables existentes; Instalación de placa de montaje
- Page 14 – Finalice la instalación; Fije el interruptor para su sistema:; Fije los interruptores de la tarifa del ciclo; Ajuste de funcionamiento del ventilador
- Page 16 – Automation and Control Solutions
Owner’s Manual
English: Page 1
Mode d’emploi
Français: Page 6
Manual de Uso
Español: Página 11
CT87N
Easy-To-See
TM
The Round
®
® U.S. Registered Trademark. U.S. Patents 7,159,789;
7,159,790; 7,476,988 and other patents pending.
Copyright © 2009, Honeywell International Inc.
All rights reserved.
CO
OL
• O
FF
• H
EAT FAN O
N•
• A
UT
O
6
7
8
69-1919EFS-04
The Round
®
Easy-To-See
TM
CAUTION: TURN OFF POWER
Turn off power to system at the furnace, or at the fuse/circuit breaker panel
before you begin.
Remove cover and thermostat, but leave wallplate with wires attached.
MERCURY NOTICE
If your old thermostat contains
mercury, contact your local waste
management authority for proper
disposal instructions.
Is there a sealed tube containing
mercury? If so, see mercury notice
below.
Leave wallplate in place.
Old thermostat
Cover
Check package contents:
• Thermostat
• Large print subbase switch labels
• Coverplate
• Wall anchors & screws (2 each)
• Wire labels
• Braille Card
Thermostat is for 24 Vac heating and
cooling systems
Before you begin, make sure
you have:
• No. 2 Phillips & small pocket
screwdrivers
• Hammer
• Level (optional)
• Pencil
• Drill and bit (3/16” for drywall, 7/32”
for plaster)
Getting started
Remove your old thermostat
This thermostat contains a Lithium battery which may contain Perchlorate material.
Perchlorate Material—special handling may apply,
See www.dtsc.ca.gov/hazardouswaste/perchlorate
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Honeywell CT87N
Summary
CT87N Easy-To-See TM • Owner's Manual 69-1919EFS—04 2 1. Pull wires through base.2. Level base if desired.3. Mark positions of both screw holes. Label wires and remove old wallplate Use a screwdriver to disconnect wires one by one. As you disconnect each wire, wrap it with the label matching the let...
English: Page 1 • Français: Page 6 • Español: Página 11 3 69-1919EFS—04 1. Match each labeled wire with same letter on terminal. 2. Use a screwdriver to loosen screw terminals, insert bare wire into slots, then tighten screws. 3. Push any excess wire back into the wall opening. Labels don't match? I...
CT87N Easy-To-See TM • Owner's Manual 69-1919EFS—04 4 1. Align the slots on the base with tabs on the thermostat, then push gently until the thermostat snaps into place. 2. Restore electrical power at the heating/cooling system, or at the fuse/circuit-breaker panel. Move the switch to the proper set...
