Honeywell CT8611- Manual

Honeywell CT8611

Honeywell CT8611– Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
Page: / 16

Table of Contents:

  • Page 3 – WARNING; WHEN INSTALLING THIS PRODUCT...; PREPARATION
  • Page 4 – TOOLS REQUIRED FOR INSTALLATION
  • Page 5 – REMOVE OLD THERMOSTAT
  • Page 6 – RECYCLING THERMOSTAT
  • Page 7 – MOUNT THERMOSTAT SUBBASE
  • Page 8 – WIRE THERMOSTAT TERMINALS; NOTE: All wiring must comply with local codes and; NOTE: Keep all wiring restricted to ribbed area
  • Page 10 – COMPLETE INSTALLATION
  • Page 12 – to set the current time.
  • Page 13 – CAUTION; CHECK THERMOSTAT OPERATION
Loading the manual

1

69-0816

INSTALLATION MANUAL

IMPORTANT:

This thermostat may be programmed either

before or after installation. Refer to Owner’s Guide,
form 69-0398, for programming instructions.

CT8611

PROGRAMMABLE
HEAT PUMP THERMOSTAT

12-93 • Form Number 69-0816

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Other Manuals for Honeywell CT8611

Summary

Page 3 - WARNING; WHEN INSTALLING THIS PRODUCT...; PREPARATION

3 69-0816 Your new thermostat provides energy saving control for a 24 Vac multistage heat pump heating/cooling system direct from the control transformer. The CT8611 includes SYSTEM and ENRG SAV LEDs located near the top of the thermostat face.The SYSTEM LED lights when the thermostat issignaling fo...

Page 4 - TOOLS REQUIRED FOR INSTALLATION

4 TOOLS REQUIRED FOR INSTALLATION Assemble a flat blade screwdriver and othertools as needed (right). Test to make certain that your heating andcooling systems are working properly. If either does not work, contact your local heating/air condi-tioning dealer. To avoid compressor damage, donot operat...

Page 5 - REMOVE OLD THERMOSTAT

5 69-0816 2 REMOVE OLD THERMOSTAT Disconnect wires from old thermostat or subbase. Always label all wires as you disconnect them from your old thermostat. Use the CT8611 WireTags provided to label each wire with the appropriateterminal designation as you remove it. It is importantto note the termina...

Other Honeywell Models