Honeywell 19546GM1- User Manual

Notices and Trademarks Copyright 2009 by Honeywell International Inc. Release D July 2009 While this information is presented in good faith and believed to be accurate, Honeywell disclaims the implied warranties of merchantability and fitness for a particular purpose and makes no express warranties ...

Page 3 - CAUTION

About This Document World Wide Web The following Honeywell web sites may be of interest. Honeywell Organization WWW Address (URL) Corporate www.honeywell.com Honeywell Analytics www.honeywellanalytics.com Manning Gas Detection www.manningsystems.com Telephone Contact us by telephone at the numbers l...

Page 4 - Contents; Serial

Contents Serial number: Section Title Page 1 System Description 5 2 Installation 7 3 Operation 10 4 Limited Warranty 13 Introduction This manual has been prepared to help in the use and installation of the Manning GM-1 Gas Monitoring Alarm System. This manual will convey the operating details of the...

Page 5 - System Description

1 System Description The Manning GM-1 is designed to accept a single 4/20 mA current input signal, plus provide a regulated 24 VDC supply to operate all sensors manufactured by Honeywell Analytics. The Manning GM-1 is housed in a rugged 14 gauge gasketed steel enclosure. Behind the clear plexiglass ...

Page 6 - continued; DC Power available for sensors:

1 System Description continued System Specifications Electrical Power: 120 VAC, 50/60 Hz at 0.35 amp (230 VAC 50/60 Hz is available as an option) Signal input: 4/20 mA DC Power available for sensors: Heavy-duty internal 24 VDC, 1 amp maximum regulated supply Display: 20-segment LED bargraph Light Ou...

Page 7 - Installation; Locating the Manning GM-1; NOT; DO NOT

2 Installation A Locating the Manning GM-1 Figure 1: Mounting dimensions for the Manning GM-1 Gas Monitoring Alarm System When unpacking the unit, inspect all boxes and contents for shipping damage. If any screws or other metal parts are missing, these must be found to ensure that the printed circui...

Page 8 - Wiring

2 Installation continued B Wiring Relay Wiring: All three relays have Form C, dry contacts. Any required power source must be within the 3 amp rating and fused or current limited to keep from damaging the contacts. Electrical wiring must comply with all applicable codes. Plant equipment that may be ...

Page 10 - Operation; Display; Reset and Silence Switches

3 Operation A Display Panel C DIP Switch Setting A 20-segment Bargraph Display indicates the gas concentration level. The bottom LED is always lit to indicate power to the display. The two position DIP switch in the center of the bottom board controls the latching of the alarm light and alarm relay....

Page 11 - Signal and Setpoints

3 Operation continued D Signal and Setpoints The voltage between TP Gnd and TP Sig indicates the current signal received from the sensor. The normal range is 0.4 volts to 2.0 volts, which corresponds with 4/20 mA. This manual will use the voltage at TP Sig to describe the input signal. When this sig...

Page 12 - Maintenance; mVDC

3 Operation continued G Maintenance The Manning GM-1 is designed for long life and high reliability. Honeywell Analytics recommends checking signal voltages monthly and logging them on the data sheet included with your Manning GM-1. Additionally, the sensor being monitored should be exposed to the t...

Page 13 - Limited Warranty; Warranty

4 Limited Warranty 1. Limited Warranty Honeywell Analytics, Inc. warrants to the original purchaser and/or ultimate customer (“Purchaser”) of Manning products (“Product”) that if any part thereof proves to be defective in material or workmanship within eighteen (18) months of the date of shipment by...

Honeywell 19546GM1- User Manual

Table of Contents:

Other Manuals for Honeywell 19546GM1

Summary

Other Honeywell Models