Hobart 3613 & 3713 - Manual

Page 2 - TABLE OF CONTENTS

– 2 – © HOBART CORPORATION 2007 TABLE OF CONTENTS GENERAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Accessories & Options . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 INSTALLATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....

Page 4 - INSTALLATION; UNPACKING

– 4 – PRODUCT TRAY The P RODUCT T RAY (Fig. 1) must be installed on the slicer. To install the P RODUCT T RAY on the slicer, lower the bottom of the S UPPORT A RM onto the C ARRIAGE H INGE P INS (Fig. 3). Tilt the P RODUCT T RAY toward the G AUGE P LATE . Press the K NOB on the S UPPORT A RM and rot...

Page 5 - ELECTRICAL; SHARPENER

– 5 – SHARPENER ROD & PIN SHARPENER MOUNT SLOT Fig. 4 ELECTRICAL This machine is provided with a three-prong grounding plug. The outlet to which this plug is connected must be properly grounded. If the receptacle is not the proper groundingtype, contact an electrician. CLEAN BEFORE USING The 361...

Page 6 - OPERATION; servicing or removing parts. Replace parts before use.

– 6 – Fig. 9 Fig. 8 Fig. 7 PARK PIN IN MEAT GRIP SLOT PRODUCT TRAY MEAT GRIPSLIDE ROD MEAT GRIP ARM TOP KNIFE COVER LATCH KNOB PRODUCT TRAY MEAT GRIP INDEXKNOB PRODUCT TRAY HANDLE MEAT GRIP SLOT GAUGE PLATE MEAT GRIPSLIDE ROD PARK PIN CARRIAGESLOT CONTROLS SIDE PANEL OPERATION Rotating knife. Use me...

Page 7 - To operate the slicer in Automatic mode

– 7 – SLICING — MODEL 3713 • Close the G AUGE P LATE by turning the I NDEX K NOB fully clockwise (Fig. 7). • Pull the P RODUCT T RAY (Fig. 7) all the way toward you until it reaches its stop (this is the home position). • Raise the M EAT G RIP to the top of the P RODUCT T RAY , and rest the P ARK P ...

Page 11 - Reassemble Slicer Parts

– 11 – To Reinstall the Knife . . . • Orient the R IDGE on the K NIFE H UB so it points to the P IN on the R ING G UARD at the 1 o'clock position (Fig. 24). • Place the K NIFE and T OOL so the P IN on the K NIFE R EMOVAL T OOL is at the 11 o'clock position (Fig. 23). The S LOTS on the K NIFE R EMOVA...

Page 12 - MAINTENANCE; close the gauge plate before doing any maintenance on the slicer.; LUBRICATION — Carriage Slide Rod

– 12 – FORM 35218 (Oct. 2007) MAINTENANCE U n p l u g t h e m a c h i n e p o w e r c o r d a n d t u r n t h e i n d e x k n o b f u l l y c l o c k w i s e to close the gauge plate before doing any maintenance on the slicer. KNIFE SHARPENING The CleanCut TM K NIFE will provide long service in norm...

Hobart 3613 & 3713 - Manual

Table of Contents:

Summary

Other Hobart Models