Hobart HR5 - Manual

– 7 – INSTALLATION Immediately after unpacking the oven, check for possible shipping damage. If oven is found to bedamaged after unpacking, save the packaging material and contact the carrier within 15 days ofdelivery. Prior to installation, test the electrical service to assure that it agrees with ...

– 8 – Assembling the Rotor (HR7 only) You should have: (2) rotor end plates; (1) rotor shaft; (12) screws 1. Face the two rotor end plates against each other to make sure the holes match. This is done to ensure you have a matched set of rotor end plates. If holes do not match, the accessories willno...

– 10 – ELECTRICAL CONNECTIONS WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THEAPPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCALELECTRICAL CODES. WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE DISCONNECTSWITCH INDICATING THAT YOU ARE WORKING ...

– 11 – ELECTRICAL DATA MODEL VOLTS HERTZ PHASE CIRCUIT SIZE* (AMPS) HR5 208 60 1 35 208 60 3 20 240 60 1 35 240 60 3 20 HR7 208 60 1 60 208 60 3 35 240 60 1 60 240 60 3 35 HW5 208 60 1 15 208 60 3 10 240 60 1 15 240 60 3 10 HW7 208 60 1 15 208 60 3 15 240 60 1 20 240 60 3 15 STACKED MODELS (2) HR5 2...

– 12 – BEFORE FIRST USE WARNING: DISCONNECT ELECTRICAL POWER BEFORE CLEANING. Oven must be "burned in" to release any odors that might result from heating the new oven surfaces. 1. Clean oven, accessories, and warmer (if present), both inside and outside, with warm soapy water. Refer to "...

– 15 – PROGRAMMABLE CONTROLS (Fig. 6) All programming must be done with all dials in the "P" position (Thermostat , Rotisseries, and MainPower dials). If all dials are not set to "P", the manual controls override the programmable controls. The programmable control allows you to progr...

– 18 – Turning the Buzzer Off Press . Setting the End Time (Delayed Start) Assume roasting time is one hour and fifteen minutes and it is currently 2 o'clock. If you want to finishroasting at 4:00, program as follows: 1. Press and hold while pressing or to adjust the time to 4:00. • Colon in display...

– 21 – AUTOMATIC CONTROLS (Fig. 8) Fig. 8 Automatic Controls can regulate roasting temperature, stop cooking at a preset time, or allow buzzerto be timed. If no temperature or roasting time has been programmed, the Automatic Control recalls the values forthe previous Automatic Cooking Operation. The...

– 22 – Setting an Early Warning Buzzer Assume roasting time is one hour and fifteen minutes and it is currently 2 o’clock. The cycle completesand the buzzer will sound at 3:15. If you want an early warning buzzer for basting or whatever reason,program as follows: DISPLAY TIME Press 3:15 — Displays t...

– 24 – PREPARING THE PRODUCT • Oven is not designed to roast frozen foods.• Use only fresh or previously thawed product.• Clean all work areas before and after preparing poultry.• Maintain proper sanitation at all times. LOADING PRODUCTS ONTO ACCESSORIES Make sure the product weight is evenly balanc...

– 25 – Fork Spit (Optional) Skewer spits into whole poultry so that point goes through the chest and thighs (Fig. 11). • Leave approximately 1 ⁄ 2 " (1.2 cm) between each chicken to permit proper browning. Fig. 11 Turkey Spit (Optional) You must remove the rotor assembly from the oven and replac...

– 27 – LOADING ACCESSORIES INTO THE OVEN If you are loading an HR5, skip steps 2-7. 1. Turn Main Power dial to . 2. Turn Rotisserie dial to to rotate rotor. 3. Turn Rotisserie dial to "0/P" to stop rotation when the hole pattern (Fig. 17) is located at the bottom of the oven. 4. Verify that ...

– 30 – SUGGESTED ROASTING GUIDELINES The chart indicates suggested cooking times and temperatures. Initial product temperature, size,shape, and other factors may require adjustment to suit your operation. Internal Capacity Thermostat Time Temperature Product (°F) (°C) (HH:MM) (°F) (°C) HR5 HR7 Chick...

– 31 – EMPTYING GREASE DRAWER Empty the grease drawer when necessary. • Be careful if grease is warm. 1. Open door and slide grease drawer out about 5" (13 cm) (Fig. 21). 2. Provide a suitably large bucket or vessel under drain valve and open valve handle (Fig. 21). 3. Close drain valve when emp...

– 33 – CLEANING WARNING: DISCONNECT ELECTRICAL POWER BEFORE CLEANING. Proper cleaning prolongs the life and productivity of the oven. The oven should be routinely cleanedthroughout the day and thoroughly cleaned at the end of the day. Allow oven to cool before cleaning. CAUTION: Do not use oven clea...

– 36 – MAINTENANCE W A R N I N G : D I S C O N N E C T E L E C T R I C A L P O W E R S U P P L Y B E F O R E P E R F O R M I N G A N YMAINTENANCE. WARNING: HOT GLASS, GREASE, AND PARTS CAN CAUSE BURNS. USE CARE WHENOPERATING AND SERVICING THE OVEN. MODEL HR5 OVEN ONLY Should the rotisserie become ou...