Heat & Glo GEM36 - Manual
Heat & Glo GEM36 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installers Guide; DO NOT; Owners Guide; ALERTED; SAFETY AND WARNING INFORMATION
- Page 3 – TABLE OF CONTENTS
- Page 4 – Service Parts; Log set assembly
- Page 5 – ACCESSORIES / ACCESSOIRES; Service Parts List / Liste des pièces de rechange; L'information fournie dans cette brochure
- Page 6 – Intermittent Pilot Ignition
- Page 7 – Appliance Certification; The Heat & Glo fireplace model discussed in this; Certification; Underwriters Laboratories; Installation Codes
- Page 8 – Getting Started; Introducing the Heat & Glo Gas Fireplaces; Pre-install Preparation; Do not install any
- Page 9 – Figure 1. Diagram of the GEM36
- Page 10 – Installing the Fireplace; Step 1. Locating the Fireplace; Vertical Sections; Constructing the Fireplace Chase; TREATMENT OF FIRESTOP SPACERS AND
- Page 11 – Framing Dimensions; Step 2. Framing the Fireplace; MEASURE FIREPLACE DIMENSIONS AND
- Page 13 – Step 3. Installing the Vent System
- Page 14 – Pilot Shield Adjustment; When venting this unit with high vertical (8 feet or; Figure 9; When venting this unit with long horizontal runs; Flue Restrictor Instructions; Figure 8. Flue Restrictor; STRAIGHT UP; VERTICAL VENTING; On vertical venting; DIAMETER
- Page 15 – Must have a one; Figure 12. Venting with Two 90° Elbows; H + H
- Page 16 – Figure 13. Venting with three 90° elbows
- Page 17 – B. Installing Vent Components; Venting Out the Top Vent; • Make sure that the fiberglass rope ring supplied in the; Figure 14. Fiberglass Rope Ring; Continue Adding Vent Components; • Continue adding vent components snap-locking, locking; Install Support Brackets
- Page 20 – = AREA WHERE TERMINAL IS NOT PERMITTED; Figure 21. Vent Termination Minimum Clearances; public
- Page 22 – Step 5. Installing the Optional Heat-Out; There must be NO INSULATION or other com-; NOTE; Do this; FORE; final positioning of the fireplace.; Step 6 The Gas Control System; The type of gas control system used with this model is; Intermittent Pilot Ignition System
- Page 23 – Pressure
- Page 24 – Ignition module, valve, pilot and wall switch operate on 3 volts.; Wall Switch; Volt Transformer; Step 9. Wiring the Fireplace
- Page 25 – FINISH WALL MATERIAL
- Page 26 – Facing Requirements; Figure 31. Facing Template Dimensions; IMPORTANT INSTALLATION NOTE
- Page 28 – Step 12. Before Lighting the Fireplace; Step 13. Lighting the Fireplace; Step 14. Climate Control
- Page 29 – Maintaining and Servicing Your Fireplace; Fireplace Maintenance; Placing Ember Material
1
Heat & Glo • GEM36 • 370-900 Rev. O • 2/05
- Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of this
or any other appliance.
-
What to do if you smell gas
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
• If you cannot reach your gas supplier, call
the fire department.
- Installation and service must be performed by a
qualified installer, service agency, or the gas
supplier.
Installers Guide
W A R N I N G : I M P R O P E R I N S TA L L A -
TION, ADJUSTMENT, ALTERATION,
S E R V I C E O R M A I N T E N A N C E C A N
CAUSE INJURY OR PROPERTY DAM-
AGE. REFER TO THIS MANUAL. FOR
ASSISTANCE OR ADDITIONAL INFOR-
MATION CONSULT A QUALIFIED IN-
STALLER, SERVICE AGENCY, OR THE
GAS SUPPLIER.
Underwriters
Laboratories Listed
READ THIS MANUAL BEFORE INSTALLING OR
OPERATING THIS APPLIANCE. THIS
INSTALLERS
GUIDE
MUST BE LEFT WITH APPLIANCE FOR
FUTURE REFERENCE.
1. This appliance may be installed in an af-
termarket, permanently located, manufac-
tured (mobile) home, where not prohibited
by local codes.
2. This appliance is only for use with the type
of gas indicated on the rating plate. This
appliance is not convertible for use with
other gases, unless a certified kit is used.
Please contact your Heat & Glo dealer with any
questions or concerns. For the number of your nearest
Heat & Glo dealer, please call 1-888-427-3973.
Printed in U.S.A. Copyright 2005,
Heat & Glo, a brand of Hearth & Home Technologies Inc.
20802 Kensington Boulevard, Lakeville, MN 55044
WARNING: IF THE INFORMATION
IN THESE INSTRUCTIONS IS NOT
FOLLOWED EXACTLY, A FIRE OR
EXPLOSION MAY RESULT CAUS-
ING PROPERTY DAMAGE, PER-
SONAL INJURY, OR DEATH.
Model:
GEM36
This product may be covered by one or more of the following patents: (United States) 4593510, 4686807, 4766876, 4793322, 4811534, 5000162, 5016609, 5076254, 5113843, 5191877, 5218953, 5263471,
5328356, 5341794, 5347983, 5429495, 5452708, 5542407, 5601073, 5613487, 5647340, 5688568, 5762062, 5775408, 5890485, 5931661, 5941237, 5947112, 5996575, 6006743, 6019099, 6048195,
6053165, 6145502, 6170481, 6237588, 6296474, 6374822, 6413079, 6439226, 6484712, 6543698, 6550687, 6601579, 6672860, 6688302B2, 6715724B2, 6729551, 6736133, 6748940, 6748942, D320652,
D445174, D462436; (Canada)1297749, 2195264, 2225408; or other U.S. and foreign patents pending.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Heat & Glo • GEM36 • 370-900 Rev. O • 2/05 These units MUST use one of the vent systems described in the Installing the Fireplace section ofthe Installers Guide . NO OTHER vent systems or components MAY BE USED . This gas fireplace and vent assembly MUST be vented directly to the outside and M...
3 Heat & Glo • GEM36 • 370-900 Rev. O • 2/05 TABLE OF CONTENTS Safety and Warning Information ................................................ 2 Service Parts Lists ..................................................................... 4 Section 1: Approvals and Codes ...............................
4 Heat & Glo • GEM36 • 370-900 Rev. O • 2/05 * Part number list on following page. * La liste des numéros de pièce se trouve à la page suivante. 4 2 3 (NG, LP) Exploded Parts Diagram(GN, PL) Vue éclatée des pièces Service Parts GEM36 Beginning Manufacturing Date: 7-02 Ending Manufacturing Date: ...
