Heat & Glo fb-grand - Manual
Heat & Glo fb-grand – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Congratulations; Listing Label Information/Location; Owner’s Manual; Read this manual before installing or operating this appliance.; Homeowner Reference Information; NATURAL
- Page 3 – Table of Contents
- Page 4 – Note; Listing and Code Approvals; Vented Gas Appliance Heaters; Models; fl; WARNING; NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.
- Page 5 – Getting Started; C. Inspect Appliance and Components; • Read all of the instructions before starting the insta-; CAUTION; Any such action may cause a
- Page 6 – Fireplace Size Requirements; A. Minimum Fireplace Opening; TOP VIEW
- Page 8 – A. Vent Termination Minimum Clearances; es minimum vent heights for various; Termination Locations
- Page 9 – C. Measuring Standards; • Vertical terminations are measured to top of chimney.; B. Horizontal Venting; Horizontal venting is NOT allowed.; Vent Information and Diagrams; Symbol
- Page 10 – Installation Preparation; D. Hearth or Hearth Extension; • Install gas line into
- Page 11 – A. Venting Components; Installing Vent Pipe and Appliance; The vertical vent termination system installed on this model; B. Connecting Vent Pipe; Reference instructions in the termination kit.
- Page 12 – • Trim chimney top plate to minimize excess overhang or
- Page 13 – D. Installing Adaptor and Termination Cap; For installation of termination cap see minimum vent; Damper Flashing Kit; : Damper may have to be removed to use this kit.; system REQUIRES this insulation.; Masonry; OR
- Page 14 – Gas Information; ed technician using Hearth & Home Technologies; • If substituting for these components, please consult; Refer to; Reference Section 16; for location of gas line; Pressure
- Page 15 – HIGH ALTITUDE INSTALLATIONS; • A small amount of air will be in the gas supply lines.
- Page 16 – A. Wiring the Appliance; Electrical Information; National Electric Code ANSI/NFPA 70-latest; • An ON/OFF switch is included with appliance and should; Appliance Requirements; • This appliance DOES NOT require 110-120 VAC to
- Page 17 – B. Junction Box Installation; Optional Accessories; replace. Place the outlet in the lower, back corner of
- Page 19 – A. Mantel Projections; Finishing; B. Installing Trim Surrounds; MUST NEVER
- Page 20 – Appliance Setup; A. Remove Shipping Materials; Remove shipping materials from inside or underneath the; B. Clean the Appliance; rebox or underneath in the control cavity.; Placing the Ember Material; • Place Mystic Ember over burner surface and around
- Page 21 – Logs are fragile! Carefully remove the logs from the packaging.
- Page 23 – STRUCTIONS; Carefully remove the logs from the packaging.; GRATE ASSEMBLY; Push log back until it rests against locating tabs A and B.
- Page 25 – Removing Glass Assembly; • To release glass assembly, pull latch forward and allow; Replacing Glass Assembly; G. Air Shutter Setting; Optimal; NG; Full open
- Page 26 – A. Before Lighting Appliance; This appliance has a Standing Pilot Ignition.; Operating Instructions
- Page 27 – B. Lighting Appliance; Standing Pilot Ignition; NOT FOR USE; Also Certi; WHAT TO DO IF YOU SMELL GAS
- Page 28 – C. Check Pilot Flame Appearance; Pilot; D. After Appliance is Lit; Initial Break-in Procedure; : The appliance should be run three to four hours; • If adjustment is needed remove cap screw from gas valve; • Do NOT turn adjustment screw counter-clockwise too far
- Page 29 – E. Frequently Asked Questions; ISSUE
- Page 30 – A. Standing Pilot Ignition System; Troubleshooting; ed service person in the diagnosis of a problem and the; Symptom
- Page 32 – Maintaining and Servicing Appliance; ed; When cleaning glass door:
- Page 34 – Reference Materials; A. Appliance Dimension Diagram
- Page 35 – B. Vent Kits Components; ex liner; ashing kit for use
- Page 36 – Service Parts; Service Parts Diagram; Part number list on following page.; Log Set Assembly
- Page 40 – D. Limited Lifetime Warranty; vicing by an authorized HEAT & GLO dealer.
- Page 41 – E. Contact Information; For the location of your nearest Heat & Glo dealer,; DO NOT DISCARD THIS MANUAL
Heat & Glo • FB-IN, FB-GRAND • 783-908 Rev. J • 2/07
1
HOT! DO NOT TOUCH
.
SEVERE BURNS MAY RESULT.
CLOTHING IGNITION MAY RESULT.
Model(s):
FB-GRAND
FB-IN
• Do not store or use gasoline or other
fl
am-
mable vapors and liquids in the vicinity of
this or any other appliance.
• What to do if you smell gas
- Do not try to light any appliance
- Do not touch any electrical switch. Do not
use any phone in your building.
- Immediately call your gas supplier from a
neighbor’s phone. Follow the gas suppli-
er’s instructions.
- If you cannot reach your gas supplier, call
the
fi
re department.
• Installation and service must be performed
by a quali
fi
ed installer, service agency, or the
gas supplier.
WARNING: If the information in these
instructions is not followed exactly, a
fi
re
or explosion may result causing property
damage, personal injury, or death.
Owner’s Manual
Installation and Operation
DO NOT DISCARD THIS MANUAL
CAUTION
This appliance may be installed as an OEM installation in
manufactured home (USA only) or mobile home and must be
installed in accordance with the manufacturer’s instructions and
the manufactured home construction and safety standard,
Title
24 CFR, Part 3280
or
Standard for Installation in Mobile Homes,
CAN/CSA Z240MH.
This appliance is only for use with the type(s) of gas indicated
on the rating plate.
• Leave this manual with
party responsible for use
and operation.
DO NO
T
DISCARD
WARNING
• Important operating
a n d m a i n t e n a n c e
instructions included.
• Read, understand and follow
these instructions for safe
installation and operation.
In the Commonwealth of Massachusetts:
• installation must be performed by a licensed plumber
or gas
fi
tter;
• a CO detector shall be installed in the room where the
appliance is installed.
Installation and service of this appliance should be
performed by quali
fi
ed personnel. Hearth & Home
Technologies suggests NFI certi
fi
ed or factory trained
professionals, or technicians supervised by an NFI
certi
fi
ed professional.
This appliance has been supplied with an integral barrier
to prevent direct contact with the
fi
xed glass panel. Do
NOT operate the appliance with the barrier removed.
Contact your dealer or Hearth & Home Technologies if the
barrier is not present or help is needed to properly install one.
• CAREFULLY SUPERVISE children in same room as
appliance.
• Alert children and adults to hazards of high temperatures.
• Do NOT operate with protective barriers open or
removed.
• Keep clothing, furniture, draperies and other
combustibles away.
Glass and other surfaces are hot during
operation and cool down.
• Keep
children
away.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Heat & Glo • FB-IN, FB-GRAND • 783-908 Rev. J • 2/07 2 Congratulations Listing Label Information/Location Model Name: ___________________________________________ Date purchased/installed: __________________ Serial Number: __________________________________________ Location on appliance: ________...
Heat & Glo • FB-IN, FB-GRAND • 783-908 Rev. J • 2/07 3 Table of Contents 1 Listing and Code Approvals A. Appliance Certi fi cation . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 B. BTU Speci fi cations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 C. High Altitude In...
Heat & Glo • FB-IN, FB-GRAND • 783-908 Rev. J • 2/07 4 Note : To assure top performance, safety and ef fi ciency, inserts must be installed with an approved fl ue liner as per CAN/CGA B-149 or National Fuel Gas Code ANSI Z223 and these instructions. Note: This installation must conform with loca...
