Heat & Glo Cosmo-130 - Manual
Heat & Glo Cosmo-130 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Listing Label Information/Location; Owner’s Manual; Homeowner Reference Information; NA; Read this manual before installing or operating this appliance.
- Page 3 – Safety Alert Key:; Used to address practices not related to personal injury.; Table of Contents; User Guide
- Page 4 – B. Limited Lifetime Warranty
- Page 6 – Models; NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.; Listing and Code Approvals; Standard Test Method for Behavior of Materials in a
- Page 7 – Operating Instructions; WARNING! DO NOT operate fi; A. Gas Fireplace Safety; WARNING; HOT SURFACES; Keep media out of reach
- Page 8 – E. Fixed Glass Assembly; barrier to prevent direct contact with the; F. Remote Controls, Wall Controls and Wall; G. IPI Battery Tray/Battery Installation
- Page 9 – I. Before Lighting Fireplace; have a; H. Control Module Operation; Module Reset
- Page 10 – tery life, remove them when using the transformer.; LIGHTING; NOT FOR USE; GAS; WHAT TO DO IF YOU SMELL GAS; DO NOT CONNECT LINE VOLT-; Also Certifi ed for Installation in a; Final inspection by
- Page 11 – K. After Appliance is Lit; ISSUE
- Page 12 – Glass Cleaning; Tools Needed; CAUTION! Handle fi xed glass assembly with care.; Note; Maintenance and Service; The appliance should be; Tools needed; Remote Control
- Page 14 – Burner Ignition and Operation
- Page 15 – A. Typical Appliance System; Illustrations and photos re; Getting Started; Installer Guide
- Page 16 – Read all of the instructions before starting the instal-; C. Tools and Supplies Needed; Any such action may cause a fi re hazard.; DO NOT use this appliance if any part has been under
- Page 17 – Fireplace Size Requirements; A. Minimum Fireplace Opening; Provide adequate
- Page 18 – B. Mantel and Wall Projections; • Use leveling legs to raise insert minimum 1/4 inch (6 mm); TOP VIEW
- Page 19 – A. Vent Termination Minimum Clearances; Termination Locations; DO NOT
- Page 20 – Installation Preparation; A. Inspection and Cleaning
- Page 21 – B. Venting Components; Installing Vent Pipe and Appliance; C. Connecting Vent Pipe; • May impair safe operation of this appliance or other; Description; CAUTION! ALL vent specifi cations MUST be followed.
- Page 22 – ance; • Connect exhaust vent pipe ONLY to exhaust starting
- Page 23 – F. Installing Adaptor and Termination Cap; For installation of termination cap see minimum vent; Wear protective gloves and safety glasses during instal-; Damper Flashing Kit; : Damper may have to be removed to use this kit.; Masonry; OR; To help eliminate cold air drafts, it may be necessary to place non-; system REQUIRES this insulation.
- Page 24 – Gas Information; • If substituting for these components, please consult; D. High Altitude Installations; Gas Pressure
- Page 25 – A. Wiring Requirements; National Electric Code; Electrical Information; B. IntelliFire PlusTM Ignition System Wiring; WARNING! Risk of Shock or Explosion! DO NOT
- Page 26 – C. Optional Accessories Requirements; Label all wires prior to dis-
- Page 27 – D. Fan Wiring with Remote; This appliance may be used with an RC200 or RC300; E. Control Module Operation; See Section 2.H for control module operation instructions.
- Page 28 – Finishing; A. Mantel and Wall Projections
- Page 29 – WARNING! Risk of Fire and Electric Shock!; Appliance Setup; E. Glass Panel Instructions
- Page 30 – G. Air Shutter Setting; F. Fixed Glass Assembly; DO NOT operate; Removing Fixed Glass Assembly; Air Shutter Settings; NG
- Page 31 – Troubleshooting; arrange a service call by a qualifi ed technician.; A. IntelliFire PlusTM Ignition System; Symptom
- Page 32 – IntelliFire PlusTM Ignition System
- Page 33 – Reference Materials; A. Appliance Dimension Diagram
- Page 34 – B. Vent Kits Components; GK to connect collinear fl ex vent to SL-D vent pipe to
- Page 35 – D. Contact Information; For the location of your nearest Heat & Glo dealer,; DO NOT DISCARD THIS MANUAL; NOTICE
1
Heat & Glo • Cosmo-I30, Cosmo-I35 • 2239-900 Rev. H • 1/11
Models:
Cosmo-I30
Cosmo-I35
•
DO NOT
store or use gasoline or other fl am-
mable vapors and liquids in the vicinity of this
or any other appliance.
• What to do if you smell gas
-
DO NOT
try to light any appliance.
-
DO NOT
touch any electrical switch.
DO
NOT
use any phone in your building.
- Immediately call your gas supplier from a
neighbor’s phone. Follow the gas suppli-
er’s instructions.
- If you cannot reach your gas supplier, call
the fi re department.
• Installation and service must be performed
by a qualifi ed installer, service agency, or the
gas supplier.
WARNING: If the information in these
instructions is not followed exactly, a fi re
or explosion may result causing property
damage, personal injury, or death.
Owner’s Manual
Installation and Operation
DO NOT DISCARD THIS MANUAL
NOTICE
This appliance may be installed as an OEM installation in
manufactured home (USA only) or mobile home and must be
installed in accordance with the manufacturer’s instructions
and the manufactured home construction and safety standard,
Title 24 CFR, Part 3280
or
Standard for Installation in Mobile
Homes, CAN/CSA Z240MH, in Canada.
This appliance is only for use with the type(s) of gas indicated
on the rating plate.
Installation and service of this appliance should be
performed by qualifi ed personnel. Hearth & Home
Technologies suggests NFI certifi ed or factory trained
professionals, or technicians supervised by an NFI
certifi ed professional.
• Leave this manual with
party responsible for use
and operation.
DO NOT
DISCARD
WARNING
• Important operating
a n d m a i n t e n a n c e
instructions included.
• Read, understand and follow
these instructions for safe
installation and operation.
In the Commonwealth of Massachusetts installation must be
performed by a licensed plumber or gas fi tter.
A CO detector shall be installed in the room where the appliance
in installed.
This appliance has been supplied with an integral barrier
to prevent direct contact with the
fi
xed glass panel. DO
NOT operate the appliance with the barrier removed.
Contact your dealer or Hearth & Home Technologies if the
barrier is not present or help is needed to properly install one.
HOT SURFACES
!
Glass and other surfaces are hot during
operation AND cool down.
Hot glass will cause burns.
•
DO NOT
touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away
• CAREFULLY SUPERVISE children in same room as
fi replace.
• Alert children and adults to hazards of high temperatures.
High temperatures may ignite clothing or other fl ammable
materials.
• Keep clothing, furniture, draperies and other fl ammable
materials away.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Heat & Glo • Cosmo-I30, Cosmo-I35 • 2239-900 Rev. H • 1/11 2 Listing Label Information/Location Model Name: ___________________________________________ Date purchased/installed: __________________ Serial Number: __________________________________________ Location on fi replace: __________________...
3 Heat & Glo • Cosmo-I30, Cosmo-I35 • 2239-900 Rev. H • 1/11 Safety Alert Key: • DANGER! Indicates a hazardous situation which, if not avoided will result in death or serious injury. • WARNING! Indicates a hazardous situation which, if not avoided could result in death or serious injury. • CAUTI...
Heat & Glo • Cosmo-I30, Cosmo-I35 • 2239-900 Rev. H • 1/11 4 B. Limited Lifetime Warranty
