Heat & Glo 8000TV-OAK - Manual

Heat & Glo 8000TV-OAK

Heat & Glo 8000TV-OAK – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
Page: / 46

Table of Contents:

  • Page 2 – Congratulations; Listing Label Information/Location; Owner’s Manual; Read this manual before installing or operating this appliance.; Homeowner Reference Information; NATURA L GAS; XXXXXXXX
  • Page 3 – Table of Contents; A. Maintenance Tasks
  • Page 4 – B. Glass Specifi cations; ANSI; A. Appliance Certifi cation; NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.; C. BTU Specifi cations; , and local Building Offi cials for; D. High Altitude Installations; Listing and Code Approvals; This installation must conform with local codes. In the; Models
  • Page 6 – A. Design and Installation Considerations; Where the appliance is to be installed.; See Sections 3; The vent system confi guration to be used.; See Sections; Framing and fi nishing details.; Getting Started
  • Page 7 – Negative pressure; combustion fumes and soot.; WARNING
  • Page 8 – Any such action may cause a fi re hazard.
  • Page 9 – • Vent Clearances and Framing; Framing and Clearances; A. Selecting Appliance Location
  • Page 10 – CLEARANCES TO COMBUSTIBLES; B. Constructing the Appliance Chase
  • Page 11 – D. Mantel Projections; TOP VIEW
  • Page 12 – * 3 foot minimum in snow regions; A. Vent Termination Minimum Clearances; • Do not pack air space with insulation or other; Termination Locations
  • Page 13 – Vent Information and Diagrams; B. Vent System Confi guration; Other vent
  • Page 14 – Maximum
  • Page 15 – This product MUST terminate vertically.; B. Vertical Penetration Framing; Fire Hazard; A. Pipe Clearances to Combustibles; Vent Clearances and Framing
  • Page 16 – Do NOT draw outside combustion air from:; B. Gas and Electrical Connections; Appliance Preparation; glasses during installation.; C. Securing and Leveling Appliance
  • Page 17 – • Do NOT notch into the framing around the appliance spacers.; E. Checking Pilot Plate; Straighten the tabs on the grate bracket (see Figure; Ensure pilot plate is in place. This will ensure pilot
  • Page 18 – A. Assembly of Vent Sections; Fire Risk; B. Attaching Vent to Firebox; Combustion Fume Risk.; C. Securing Vent Sections; SECURING; Installing Vent Pipe
  • Page 19 – Have the gas supply line installed in accordance; Gas Information; • If substituting for these components, please consult; Refer to; Reference Section 16; for location of gas line; The gap between supply piping and gas access hole; Pressure; Minimum inlet pressure
  • Page 20 – HIGH ALTITUDE INSTALLATIONS; • Ensure that gas line does not come in contact with outer
  • Page 21 – A. Recommendation for Wire; Electrical Information; National Electric Code ANSI/NFPA 70-latest; B. Connecting to the Appliance; Wire 110V to electrical junction box.; Wall Switch
  • Page 22 – C. Intellifi re Ignition System Wiring; Batteries cannot be placed in the battery pack; Optional Accessories Requirements; CAUTION; • Replace damaged wire with type 105o C rated
  • Page 23 – D. Standing Pilot Ignition System Wiring
  • Page 24 – If the box is being wired from the appliance:; E. Junction Box Installation; Do NOT wire
  • Page 25 – A. Mantel Projections; Finishing
  • Page 26 – A. Remove Shipping Materials; EMBER; DO NOT; Appliance Setup
  • Page 27 – F. Positioning the Logs; Carefully remove the logs from the packaging.; LOG TAB
  • Page 29 – Removing Glass Assembly; Shutter Settings; Fixed
  • Page 30 – B. Check Appliance Draft; If installing Intellifi re ignition battery backup:; HOT SURFACES
  • Page 31 – C. Lighting Appliance; NOT FOR USE; GAS; WHAT TO DO IF YOU SMELL GAS; Final inspection by
  • Page 32 – Standing Pilot Ignition
  • Page 33 – Initial Break-in Procedure; The appliance should be run three to four hours; D. After Appliance is Lit; ISSUE
  • Page 34 – A. Standing Pilot Ignition System; Troubleshooting; Symptom
  • Page 35 – Replace glass panel assembly.
  • Page 36 – B. Intellifi re Ignition System; Sympton; Verify that 110/VAC power is “ON” to junction box.
  • Page 38 – Maintaining and Servicing Appliance; Clean glass after initial 3-4 hours operation.; When cleaning glass door:
  • Page 40 – Reference Materials; A. Appliance Dimension Diagram; Location Inches
  • Page 41 – Service Parts; Service Parts Diagram; Log Set Assembly; Part number list on following page.
  • Page 42 – Addional service part numbers appear on following page; B. Service Parts List
  • Page 43 – Valve Assembly Parts List; IPI Valve Assembly; Stocked; ITEM
  • Page 44 – Standing Pilot Valve Assembly
  • Page 45 – C. Limited Lifetime Warranty; unless expressly authorized and approved by HEAT & GLO in writing.
  • Page 46 – D. Contact Information; For the location of your nearest Heat & Glo dealer,; DO NOT DISCARD THIS MANUAL; • Leave this manual with
Loading the manual

1

Heat & Glo • 8000TV-OAK, 8000TV-OAK-IPI, 8000TVLP-OAKIPI • 2058-900 Rev. L • 08/08

Models:
8000TV-OAK
8000TV-OAK-IPI
8000TVLP-OAKIPI

In the Commonwealth of Massachusetts:

• installation must be performed by a licensed plumber

or gas fi tter;

• a CO detector shall be installed in the room where the

appliance is installed.

• Do not store or use gasoline or other fl am-

mable vapors and liquids in the vicinity of
this or any other appliance.

• What to do if you smell gas

- Do not try to light any appliance

- Do not touch any electrical switch. Do not

use any phone in your building.

- Immediately call your gas supplier from a

neighbor’s phone. Follow the gas suppli-
er’s instructions.

- If you cannot reach your gas supplier, call

the fi re department.

• Installation and service must be performed

by a qualifi ed installer, service agency, or the
gas supplier.

WARNING: If the information in these
instructions is not followed exactly, a

fi re or explosion may result causing prop-
erty damage, personal injury, or death.

Owner’s Manual

Installation and Operation

DO NOT DISCARD THIS MANUAL

CAUTION

Installation and service of this appliance should be
performed by qualifi ed personnel. Hearth & Home
Technologies suggests NFI certifi ed or factory trained
professionals, or technicians supervised by an NFI
certifi ed professional.

• Leave this manual with

party responsible for use
and operation.

DO NO

T

DISCARD

• Important operating

a n d m a i n t e n a n c e
instructions included.

• Read, understand and follow

these instructions for safe
installation and operation.

Para obtener un ejemplar en Español de este
Manual del propietario, visite www.heatnglo.com.

Pour demander un exemplaire en français de ce

Manuel du propriétaire, visitez www.heatnglo.com.

This appliance may be installed as an OEM installation in
manufactured home (USA only) or mobile home and must be
installed in accordance with the manufacturer’s instructions and
the manufactured home construction and safety standard,

Title

24 CFR, Part 3280

or

Standard for Installation in Mobile Homes,

CAN/CSA Z240MH.

This appliance is only for use with the type(s) of gas indicated
on the rating plate.

WARNING

This appliance has been supplied with an integral barrier
to prevent direct contact with the fi xed glass panel. DO
NOT operate the appliance with the barrier removed.

Contact your dealer or Hearth & Home Technologies if the
barrier is not present or help is needed to properly install one.

HOT SURFACES

!

Glass and other surfaces are hot during
operation AND cool down.

Hot glass will cause burns.

• Do not touch glass until it is cooled
• NEVER allow children to touch glass
• Keep children away

• CAREFULLY SUPERVISE children in same room as

fi replace.

• Alert children and adults to hazards of high temperatures.

High temperatures may ignite clothing or other fl ammable
materials.

• Keep clothing, furniture, draperies and other fl ammable

materials away.

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 2 - Congratulations; Listing Label Information/Location; Owner’s Manual; Read this manual before installing or operating this appliance.; Homeowner Reference Information; NATURA L GAS; XXXXXXXX

2 Heat & Glo • 8000TV-OAK, 8000TV-OAK-IPI, 8000TVLP-OAKIPI • 2058-900 Rev. L • 08/08 Congratulations Listing Label Information/Location Model Name: ___________________________________________ Date purchased/installed: __________________ Serial Number: __________________________________________ L...

Page 3 - Table of Contents; A. Maintenance Tasks

3 Heat & Glo • 8000TV-OAK, 8000TV-OAK-IPI, 8000TVLP-OAKIPI • 2058-900 Rev. L • 08/08 Î = Contains updated information. Table of Contents 1 Listing and Code Approvals A. Appliance Certifi cation . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4B. Glass Specifi cations . . . . . . . . . . ...

Page 4 - B. Glass Specifi cations; ANSI; A. Appliance Certifi cation; NOT INTENDED FOR USE AS A PRIMARY HEAT SOURCE.; C. BTU Specifi cations; , and local Building Offi cials for; D. High Altitude Installations; Listing and Code Approvals; This installation must conform with local codes. In the; Models

4 Heat & Glo • 8000TV-OAK, 8000TV-OAK-IPI, 8000TVLP-OAKIPI • 2058-900 Rev. L • 08/08 MODELS: 8000TV-OAK, 8000TV-OAK-IPI, 8000TVLP-OAKIPI LABORATORY: Underwriters Laboratories, Inc. (UL) TYPE: B-Vent Decorative STANDARD: ANSI Z21.50-2002 • CGA2.2 B. Glass Specifi cations Hearth & Home Technol...

Other Heat & Glo Models

All Heat & Glo Other