GE ZGU36N6 Manual - Free PDF Download

Page 2 - Installation Instructions; Standard countertop and island installations:; BEFORE YOU BEGIN; • IMPORTANT; Note to Installer

Installation Instructions CAUTION: THESE COOKTOPS SHOULD BE INSTALLED IN CONJUNCTION WITH A SUITABLE OVERHEAD VENT HOOD. Due to the high heat capacityof this unit, particular attention should be paid to thehood and duct work installation to assure it meetslocal building codes. MISE EN GARDE : CES CU...

Page 3 - CONTENTS; MODELS AVAILABLE; Design Information

22" High Backsplash WithWarming Shelf 12" High Backsplash INSTALLATION NOTE: A custom backspash may be constructed of non-combustible back wall materials such as ceramic tile, brick, marbleor other stone. CONTENTS Design Information Models Available .............................................

Page 5 - Installation Preparation

26-5/8" 12" 1/2" 8-7/16" Countertop Level 22-3/4" 23-1/4" 4" to Center Line of Gas Inlet on the Left Allow Additional Clearance Below the Burner Box for Gas Connections 2-1/2" Cabinet Face - Projecting Control Panel Cabinet Face - Flush Control Panel 1/2" 12" ...

Page 6 - POWER SUPPLY LOCATIONS; TOOLS REQUIRED

POWER SUPPLY LOCATIONS Gas Supply: • The pressure regulator must be connected in series with the manifold of the cooktop and must remain in series with thesupply line regardless of the type of gas being used. • The natural gas models are designed to operate at 5" water column pressure. A regulat...

Page 7 - OR

Measure carefully when cutting the countertop. Make sure sides of the opening are parallel.• These cooktops require 8" free space below the countertop to house the cooktop burner box. • Allow additional clearances below the burner box to install the regulator and make house supplyconnections. Us...

Page 8 - INSTALL COOKTOP; Assure that gas is turned off at the shut-off valve.; Installation

Alternate BracketScrew Holes “L” Bracket 8 INSTALL COOKTOP • Lower the cooktop into the opening. Make sure the cooktop is evenly seated and supported. A side framegasket will seal the cooktop to the countertop. • “L” brackets with screws are provided to secure the cooktop to the countertop or to adj...

Page 9 - CONNECT ELECTRICAL

Assemble burners as shown. Check to be sure that burner heads and caps are securely seated. Pin(s) mustcompletely engage holes to ensure proper assembly. • Check for proper ignition: – Push in one control knob and turn 90° to Lite position. – The igniter will spark and the burner will light; the ign...

Page 10 - FINALIZE INSTALLATION; INSTALLATION CHECKLIST; Make sure all controls are left in the OFF position.

10 FINALIZE INSTALLATION Place the burner grates over the burners. Press corner of the grate to the cooktop. The grates should be seatedand should not rock. The grill and griddle are secured with screws at thefront. They are designed to be stationary and should notbe removed. The griddle has two lev...