GE JGP945 - User Manual
GE JGP945 – User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – ELECTRICAL REQUIREMENTS; National Fire Protection Association; MATERIALS YOU MAY NEED
- Page 4 – All gas cooktop models require 7/16
- Page 5 – below the countertop.; ATTACH FOAM TAPE; Do not overlap the foam strips.; LOCATE MOUNTING PARTS
- Page 6 – INSTALL REGULATOR; Never reuse old
- Page 7 – Installation Instructions; CHECK FOR LEAKS; from the gas supply piping; Isolate the cooktop; from the gas supply
- Page 8 – EXTENSION CORDS; WARNING; Disconnect all
- Page 9 – Attaching the adaptor ground
- Page 11 – BURNER GRATES; Lighting gas burners; If the burner does not light within five; THE BURNER FLAMES; on the lowest setting and no greater than; If you attempt to
- Page 13 – The cooktop, as shipped; Snap the retainer back into position.
- Page 15 – The main orifice is located low in the
- Page 16 – ADJUST BURNER FLAMES; Testing Flame Stability:
- Page 17 – AVANT DE COMMENCER; IMPORTANT; Note à l’installateur –; Instructions; Table de cuisson scellée; d’installation; POUR VOTRE SÉCURITÉ; AVERTISSEMENT
- Page 18 – BESOINS D’ÉLECTRICITÉ
- Page 20 – tous les modèles de surface
- Page 21 – ATTACHEZ LA BANDE DE MOUSSE; Ne superposez pas
- Page 22 – INSTALLEZ LE RÉGULATEUR
- Page 23 – Instructions d’installation; du système de tuyau d’alimentation; IIsolez la table de cuisson; du système de
- Page 24 – RALLONGES; INSTALLATION—RACCORDS ÉLECTRIQUES; PRISE BIPHASÉE
- Page 25 – Si vous fixez; INSTALLATION—RACCORDS ÉLECTRIQUES (
- Page 27 – VÉRIFIEZ LES ALLUMEURS; Il est; ISi le brûleur ne s’allume pas en cinq
- Page 28 – GRILLES DE BRÛLEUR; réglage le plus haut.; Si vous
- Page 29 – Dévissez le capuchon.
- Page 31 – Le diaphragme principal est situé
- Page 32 – Essai de stabilité de la flamme :
1
31-10613-3
(11-06 JR)
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
•
IMPORTANT
—
Save these
instructions for local inspector’s use.
•
IMPORTANT
—
Observe all
governing codes and ordinances.
•
Note to Installer –
Be sure to leave these
instructions with the Consumer.
•
Note to Consumer –
Keep these
instructions for future reference.
•
Product failure due to improper installation
is not covered under the Warranty.
WARNING
—
This appliance must
be properly grounded.
•
IMPORTANT
—
Leak testing of the
appliance shall be conducted according to
the manufacturer’s instructions.
•
Proper installation is the responsibility
of the installer and product failure due to
improper installation is NOT covered under
warranty.
IN THE COMMONWEALTH OF
MASSACHUSETTS:
•
This product must be installed by a
licensed plumber or gas fitter.
•
When using ball-type gas shut-off valves,
they shall be the T-handle type.
•
A flexible gas connector, when used, must
not exceed 3 feet.
Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: ge.com
In Canada, call 1.800.361.3400 or Visit our Website at: www.geappliances.ca
Installation
30
″
Sealed Gas Cooktop
Instructions
JGP328, JGP330, JGP933,
JGP940, JGP945
FOR YOUR SAFETY:
WARNING
— If the information
in this manual is not followed exactly, a fire,
explosion or gas leak may result causing
property damage, personal injury or death.
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance!
WHAT TO DO IF YOU
SMELL GAS:
•
Do not try to light any appliance. Do not
touch any electrical switch; do not use any
phone in your building.
•
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
•
If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed
by a qualified installer, service agency or
the gas supplier.
This cooktop has been design certified
by CSA International. You’ll find safety
precautions in your Owner’s Manual.
Read them carefully.
•
Installation of this cooktop must conform
with local codes or in the absence of local
codes with the National Fuel Gas Code,
ANSI Z223.1/NFPA 54–Latest edition.
•
Be sure your cooktop is installed properly
by a qualified installer or service technician.
•
To eliminate reaching over surface burners,
cabinet storage above burner should be
avoided.
•
Do not install the unit near an outside door
or where a draft may affect its use.
WARNING
—
Disconnect all
electrical power at the main circuit breaker
or fuse box before installing.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Was this manual helpful?
About this manual
- Brand
- GE
- Model
- JGP945
- Document type
- User Manual
- Language(s)
- English, French
- Pages
- 32
- File size
- 1.4 MB
- Format
Summary
2 Installation Instructions IMPORTANT SAFETY INSTRUCTIONS ELECTRICAL REQUIREMENTS This appliance must be supplied with theproper voltage and frequency and connectedto an individual, properly grounded branchcircuit, protected by a circuit breaker or fusehaving amperage as noted on the rating plate. W...
4 Installation Instructions PREPARING THE OPENING MAINTAIN THE FOLLOWINGMINIMUM CLEARANCEDIMENSIONS 1 3 3/4 MIN. OVERALL COOKTOPDIMENSIONS 2 CUTOUT DIMENSIONS OFCOUNTERTOP To ensure accuracy, it is best to make a template when cutting the opening in the counter. 3 RECOMMENDED GAS SUPPLYLOCATION FROM...
5 Installation Instructions INSTALLING THE COOKTOP UNIT LOCATE ELECTRICAL OUTLETAND GAS SHUT-OFF VALVEBENEATH CABINET Install a manual shut-off valve in the gas linein an easily accessible location outside thecooktop. Be sure you know how and where toshut off the gas supply to the cooktop. Installth...
