GE JGP990SEL - Manual

For answers to your Monogram,

®

GE Profile

™

or

GE

®

appliance questions, visit our website at

ge.com or call GE Answer Center

®

service,

800.626.2000.

Listed by

Underwriters

Laboratories

R

Specification Created 12/05

230281

*Note: A 8" minimum spacing to adjacent side wall is required

Wall Installation:

Wall installations require 25”

countertop depth. When cabinet is flush against
the wall, the fan housing can be rotated to the
horizontal position for direct venting through
rear wall. Make a countertop cutout in the
range cabinet according to unit dimensions
and installation type. Duct hole is positioned in
back of cabinet for through-the-wall ducting.
Requires special offset adapter JXRW89.

Peninsula or Island Installation:

For peninsula/

islands a minimum 26” countertop depth is suggested.
Blower should be in vertical position. Island or
peninsula cabinets may require adjustment in cutout
depth and/or location within the width dimensions.
Duct hole is positioned in bottom of cabinet for island
or peninsula installation.

Slab Installation:

For peninsula or island installation

and rear wall ducting,

6” PVC duct or locally

approved piping should be used if installing under

a poured concrete slab.
Installation Information:

Before installing, consult

installation instructions, packed with product, for
current dimensional data.

Note: These cooktops are approved for indoor use only.

30

3-1/4 x 10

4-3/16

28-3/4

21-3/4

20-1/2

22

Tie down bolt

on each end

Select appropriate

duct cutout

(see ducting installation instructions.)

Pressure regulator

Wiring box cover

Grease

container

9-1/2

29 +

_ 1/16

1-7/8"

Min.

15/16"

Min.

clearance

Blower can be swiveled 90

°

14-3/16

9

30

21-3/4

21 +

_ 1/16

JGP990SEL

GE Profile

™

30" Downdraft Gas Cooktop

Dimensions and Installation Information (in inches)