GE 45605 GE Z-Wave Duplex Receptacle User Manual

Page 4 - control system and is

Introduction:Thank you for your purchase of a GE Z-Wave ® control device. Z-Wave technology is designed to automate lighting/home control and provide easy remote operation of all your Z-wave enabled devices. The GE Z-Wave product family includes a variety of devices to control lighting in your home....

Page 5 - CAUTION; Manual/Program Button

The device plugged into the Z-Wave controlled outlet on this module must not exceed 600 watts (Incandescent); 15 Amps, 1800W (Resistive); or ½ HP (Motor). The maximum rating for both outlets combined is 1800W (15A) Resistive. There are no user serviceable parts in this unit . This device is intended...

Page 6 - WARNING; Controlling Appliances:

RISK OF FIRE RISK OF ELECTRICAL SHOCK RISK OF BURNS WARNING Controlling Appliances: Exercise extreme caution when using Z-Wave devices to control appliances. Operation of the Z-Wave device may be in a different room than the controlled appliance, also an unintentional activation may occur if the wro...

Page 8 - Effects of Home Construction on Wireless Range Between; Type of Construction; Number

Effects of Home Construction on Wireless Range Between Z-Wave Enabled Devices.Note: The distances shown in the table below are typical examples. Actual performance in your home will vary.From the Remote (or repeating Z-Wave module) to destination device: * For Plug-in Modules or In-Wall Devices Inst...

Page 9 - Please Note: Z-Wave home control networks are designed to work; Installation

Please Note: Z-Wave home control networks are designed to work properly alongside 802.11 wireless computer networks, Bluetooth and other 2.4GHz or 5.8GHz devices. Some baby cams, wireless video devices and older cordless phones using the 900MHz frequency range may cause interference and limit Z-Wave...

Page 12 - Important: The wire connectors included with this receptacle; Wire Connector / Combination Chart

Important: The wire connectors included with this receptacle are intended to only be used with copper wire. Consult a qualified electrician if you have aluminum wiring.Instructions: Strip insulation 3/8” for 12 or 14 AWG wire. Strip insulation 7/16” for 16 or 18 AWG wire.Hold stripped ends together ...

Page 13 - The connected light can be turned ON in two ways:; Remote Control

Key Features - One Z-wave remote controlled AC outlet- Remote ON/OFF control via the Z-Wave controller/network- Manual ON/OFF control with the front panel pushbutton- One Always-ON pass through AC outlet Basic Operation The connected light can be turned ON in two ways: With a remoteManually with the...

Page 14 - LED Indicator

Manual ControlThe Pushbutton on the 45605 receptacle allows the user to: Manually turn the connected equipment ON or OFF by pressing the button. - This is a toggle switch; if the device is OFF, pressing the button turns the device ON and vice versa. 2. Include or exclude the receptacle from the Z-Wa...

Page 15 - ADVANCED OPERATION; The four possible responses are:

ADVANCED OPERATION The following Advanced Operation parameters require that you have an advanced controller like the GE model 45601 Advanced remote. Advanced remotes from other manufacturers may also be able to change these settings; however, basic remotes do not have this capability. All-ON and All...

Page 18 - FCC; Operation is subject to the following two conditions:

FCC U2Z45605 T he Federal Communication Commission Radio Frequency Interference Statement includes the following paragraph:The equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason...