GE 45610WB GE Z-Wave Add On Auxiliary Switch User Manual

Page 3 - Controlling Appliances:

This device is intended for installation in accordance with the National Electric Code and local regulations in the United States, or the Canadian Electrical Code and local regulations in Canada. If you are unsure or uncomfortable about performing this installation consult a qualified electrician. R...

Page 5 - IMPORTANT NOTE ABOUT 3-WAY CIRCUITS

IMPORTANT NOTE ABOUT 3-WAY CIRCUITS The term “3-way circuit” refers to a circuit with two switches and one load (light) like you find at the top and bottom of a stairway. There are many ways to physically wire a 3-way circuit and it is important to understand how the circuit you wish to upgrade to Z...

Page 8 - It can not be used by itself for 2-way control; The Auxiliary switch(s) must be wired to; -Way Wiring Schematic using one 45610 and one

INSTALLATION This switch may be used in new installations or to replace an existing wall switch when converting a 3 or 4 way circuit to Z-Wave. It can not be used by itself for 2-way control (one switch & one load). Please note: The Auxiliary switch(s) must be wired to the same Neutral as the Z-...

Page 10 - ! Warning: Verify power is OFF to switch box before; The

Z-Wave 45607, 45609 or 45612 1. Shut off power to the circuit at fuse box or circuit breaker. 2. Remove wall plate. ! Warning: Verify power is OFF to switch box before continuing. 3. Remove the switch mounting screws. 4. Carefully remove the switch from the switch box. DO NOT disconnect the wires. 5...

Page 11 - DO NOT connect the 45610 auxiliary switch to the

10. Connect the black wire that comes from the electrical service panel (Hot) to the lead or terminal marked LINE. 11. Connect the Traveler wire (usually Red) to the wire or screw terminal marked TRAVELER. The other end of this Traveler wire connects to the TRAVELER wire on the 45610 Auxiliary Switc...

Page 12 - only be used with copper wire.

Observe Important Wiring Information Important: This switch is rated for and intended to only be used with copper wire. Models 45609 and 45612 ONLY: The home’s electrical wires may be attached to the screw terminals or inserted into the holes in the back of the switch enclosure and clamped in place ...

Page 13 - When installed with the 45609 switch:

the brightness level of the connected lighting. Release when the desired level is attained. When installed with the 45609 switch: • Press and release the top of the 45610’s rocker to turn the connected lighting ON. • Press the bottom of the 45610’s rocker to turn the connected lighting OFF.

Page 14 - WARRANTY

WARRANTY JASCO Products warrants this product to be free from manufacturing defects for a period of two years from the original date of consumer purchase. This warranty is limited to the repair or replacement of this product only and does not extend to consequential or incidental damage to other pro...