GBC USP 13 - Manual
GBC USP 13 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 5 – SELECTING KNIFE SET-UP; CLAW
- Page 7 – OUTER BELT
- Page 8 – SUPPLY STACK GUIDE
- Page 10 – USP 13 Universal Speed Punch; QUICK REFERENCE INSTRUCTIONS
- Page 11 – MAINTENANCE INSTRUCTIONS
- Page 12 – IMPORTANT
- Page 13 – OPTIONS & ACCESSORIES; Optional assemblies that can be purchased separately include:
USP 13
UNIVERSAL SPEED PUNCH
Operator Manual
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
3 SELECTING KNIFE SET-UP 1. Turn power off. 2. Cycle the machine with the hand wheel until the claw reaches between 10 and 11 o’clock. (Figure 2) 3. Cam #115 sets when the separating knife will go into the stack. Adjust the cam so that the tip of the knife is about 1/8” (.13) from the trailing edge ...
5 USP 13 SET-UP INSTRUCTIONS: After the punching die is properly installed, position the back gauge rail (#108, Figure 7) slightly ahead of the punch die back gauge so that a piece of paper can slide freely into the throat of the die and not hit the back gauge of the punch die. Cam (#37) activates t...
111 170 83 127 1.0 Figure 10 Figure 12 CLAW THESE SURFACES TO BE IN LINE 46 Place a sheet of paper against pusher (#111) in its home position (rear). Install the three paper support straps (#127 & #83, Figure 10) 1” away from the edge of the paper. Straps must be on top of transfer belts.Cycle t...
