GBC USP 13 - Manuals

GBC USP 13 – Manual in PDF format online.

Manuals:

Manual GBC USP 13

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17

Summary

Page 5 - SELECTING KNIFE SET-UP; CLAW

3 SELECTING KNIFE SET-UP 1. Turn power off. 2. Cycle the machine with the hand wheel until the claw reaches between 10 and 11 o’clock. (Figure 2) 3. Cam #115 sets when the separating knife will go into the stack. Adjust the cam so that the tip of the knife is about 1/8” (.13) from the trailing edge ...

Page 7 - OUTER BELT

5 USP 13 SET-UP INSTRUCTIONS: After the punching die is properly installed, position the back gauge rail (#108, Figure 7) slightly ahead of the punch die back gauge so that a piece of paper can slide freely into the throat of the die and not hit the back gauge of the punch die. Cam (#37) activates t...

Page 8 - SUPPLY STACK GUIDE

111 170 83 127 1.0 Figure 10 Figure 12 CLAW THESE SURFACES TO BE IN LINE 46 Place a sheet of paper against pusher (#111) in its home position (rear). Install the three paper support straps (#127 & #83, Figure 10) 1” away from the edge of the paper. Straps must be on top of transfer belts.Cycle t...

GBC Manuals