Furuno IF-NMEA2K2 - Manual
Furuno IF-NMEA2K2 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – System Configuration; Specifications of NMEA Data Converter; Name Type
- Page 3 – Installation; Mounting Considerations; up inside the cabinet.; Mounting; Wiring; Connection to Furuno CAN bus device; Connect the Furuno CAN bus cable to the Furuno CAN bus device. See; Connection to NMEA0183 device; interconnection diagram as below.
- Page 4 – Conversion Mode; Check the applicable checkbox on the nameplate according to the; Action; No action
- Page 5 – Turning Power On; Power LED; Input/Output Comparing
- Page 11 – PACKING LIST
INSTALLATION MANUAL
NMEA DATA CONVERTER
Model
IF-NMEA2K2
WARNING
Do not install the unit where it may get
wet from rain or water splash.
Water in the unit can result in fire, electrical
shock or damage the equipment.
Do not disassemble or modify the
equipment.
Fire, electrical shock or serious injury can
result.
Observe the following compass safe
distances to prevent interference to a
magnetic compass:
CAUTION
IF-NMEA2K2
standard
compass
steering
compass
0.30m
0.30m
www.furuno.com
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 System Configuration The NMEA Data Converter IF-NMEA2K2 converts Furuno CAN bus format data to NMEA0183 format data and vice versa. NMEA0183 device* Furuno CAN bus device Furuno CAN bus cable NMEA DATA CONVERTER NMEA0183 cable PC, etc.* (RS-232C) Mode Conversion *: NMEA0183 cable can not be connec...
3 Installation Mounting Considerations • Locate the data converter well away from areas subject to water splash and rain. • Keep the data converter out of direct sunlight because of heat that can build up inside the cabinet. Mounting Fix the data converter to the mounting location with two self tapp...
4 After the connection, cut the unused cable cores and wind vinyl tape around the each edge of the wires and fix them so that they do not touch other signal cores or ground. Vinyl tape Conversion Mode PORT1 (ORG), PORT2 (PPL), GND (BLK) signal cores of the NMEA0183 cables are short-circuited (defaul...
