Foster 7120 043 - Manual - manualsarea.com

Page 4 - correct use of our products.; TECHNICAL DATA; can be found on the right side of the oven face.

Thank you for choosing one of our products. It will offer you many years of excellent performance. Please carefully read the instructions and suggestions contained in this manual for correct use of our products. TECHNICAL DATA Dimensions: Height: 591mm Width: 597mm Depth: 547mm Voltage regulations: ...

Page 7 - Preparation of the oven and pre-use; Important notices for the installation

All work on the appliances must be carried out by qualified personnel. For maintenance, moving, installation and cleaning of the appliance use suitable prevention and protection equipment (gloves, etc.). Lifting and moving of appliances weighing more than 25 kg must be carried out using proper equip...

Page 9 - Installation scheme for the oven with reversable door

85-90 85-90 592-593 550 min. 550 min. 85-90 600 564 564 Pics. 1c-1d : Installation scheme for the oven with reversable door Pic. 1c 8

Page 11 - Control panel

Control panel 1. Thermostat 2. Selector3. Electronic timer4. End of cooking 4 5 6 2 1 1 5/6 3 6/5 2 5. Green light6. Yellow light7. Minute minder 8. Analog programmer and Analog timer 7 5 6 2 1 1 6 8 5 2 1 0

Page 13 - SEMI FORCED AIR CONVECTION WITH LOWER HEATING ELEMENT; VENTILATED GRILL + TURNSPIT

LIGHT ONLY BOTTOM ELEMENT ONLY Select the desired temperature between 50 ° C and 250 ° C. Suitable for very slow cooking and warming up of food. TOP HEATING ELEMENT Select the thermostat temperature from 50 ° C to 250 ° C. For keeping cooked food warm or gently reheating. GRILL + TURNSPIT By turning...

Page 14 - Cooking table

Suggested Personal 175 2 55 - 65 175 3 60 - 70 175 3 60 - 70 200 3 8 - 10 200 3 25 - 35 200 3 25 - 35 180 3 30 - 45 200 3 25 - 35 200 3 10 - 15 200 2 35 - 45 200 3 15 - 20 225 2 40 - 50 200 2 120 - 150 200 2 60 - 90 200 2 30 - 40 200 2 120 - 180 200 2 150 - 210 200 2 60 - 90 175 2 about 240 200 2 60...

Page 15 - How to use the grill; CAUTION: WHILE THE GRILL IS OPERATING, THE ACCESSIBLE PARTS; Under are few suggestions for cooking with the grill:; Cooking time in minutes; How to use the turnspit (where available)

How to use the grill Lay the food in the wire shelf or in a tray in case of small pieces. The rack must be positioned in the highest runner possible and the grease drip pan in the runner below. Close the door and turn on the grill. CAUTION: WHILE THE GRILL IS OPERATING, THE ACCESSIBLE PARTS ARE VERY...

Page 16 - Programming your oven with mechanical

Pic. 3 Pic. 4 Programming your oven with mechanical 60 minutes timer - Pic. 3 The regulating knob (pic. 3) must be turned in a clockwise direction until it reaches the 60 minutes position and then turned to the desired time by turning the knob in a counter clockwise direction. The oven will not be t...

Page 17 - B A

Analog timer - Pic. 6 Setting the clock: to set the clock, press and turn the knob “A” in a clockwise or anticlockwise direction. Analog programmer - Pic. 5 Regulate time by pressing and turning the knob "A" anti-clockwise. Select the beginning of cooking time by pulling and turning the knob...

Page 19 - Digital clock

Digital clock Clock numbers show hours (0-24) andminutes.Upon immediate hooking up of the oven orafter a blackout, three zeros will flash onthe programmer panel.To set the hour it is necessary to pushsimultaneously the + buttons andAT THE SAME TIME to push the [+] buttonor [-] until you have set the...

Page 20 - Semi-automatic cooking

Timer = buzzer The timer program consists only of a buzzerwhich may be set for a maximum period of23 hours and 59 min.To set the timer, push the button and,at the same time, [ + ] or [ - ] until you readthe desired time on the display.After the setting, the clock hour and thesymbol will appear. The ...

Page 21 - select; Manual operation; previously

USING THE ELECTRONIC PROGRAMMER (pic. 8) F UNC T I O N Timer Minus setting Temperature Setting the clock Switch the oven on ; 00.00 will appear in blinking mode on the display. the display. To set the clock, simultaneously press the durationand end of cooking keys together. Using the +/- keys on the...

Page 22 - Semiautomatic operation with cooking duration; ime of day = cooking end time the r ela y output and the cookpot; Semiautomatic operation with cooking end time

Semiautomatic operation with cooking duration Select cooking duration function and set required duration withthe +/- keys on the right . “AUTO” (B) and cookpot (C) symbols appear. If t ime of day = cooking end time the r ela y output and the cookpot symbol (C) are switched off. The audible signal so...

Page 23 - Minute counter; on the right; Audible signal; on; Program start and control; A program can be cancelled pushing at the same time the

At 13.15 h. (14.00 h. minus 45 minutes ) the oven turns onautomatically. During cooking time the cookpot button (C) and“AUTO” (B) switch on. At 14.00 h. the oven turns off automatically, “AUTO” (B)flashes. The cookpot button (C) switches off and a buzzer goeson until it is stopped. Minute counter Se...

Page 24 - on the left

Switch functions The following functions can be set by turning the switch knob. The following will be shown on the display: Light 190°C 50°C 190°C 250°C 165°C 165°C 165°C Defrost The temperature shown on the display can be changed via the keys+/- on the left . Increase or decrease is in 5°C steps, f...

Page 25 - ELECTRONIC PROGRAMMER

TEMPERATURE DISPLAY TIMER DISPLAY COOKING FUNCTIONS DISPLAY ELECTRONIC PROGRAMMER 2 4

Page 31 - flange with motor; Always put the food container in the middle of the round shelf.; there is a risk of burns and scalds.; Before cleaning the turning plate, wait until it has cooled down.; Handle with care the glass plate, to avoid the risk of cracks.

The turning plate (pics. 10-13) The turning plate works combined with the radial fan, as it can be found in the oven functions descriptions. On the bottom of the oven cavity is fixed the flange with the motor ofthe turning plate (pic. 10); The appliance is equipped with the following parts: - a supp...

Page 33 - WARNING; hinges with movable bolt; remember to rotate

Replacing the oven light - Pic. 14 The oven is equipped with a lamp having thefollowing features: 25W screw cap E-14 T 300 ° C WARNING : disconnect the appliance from the power supply.lf the oven light needs to be replaced, theprotective cover «A» must be removed byturning it anticlockwise. After th...

Page 35 - REMOVING THE OVEN DOOR

REMOVING THE OVEN DOOR INNER GLASS PANEL (pics. 16-17) Pic. 16 Pic. 17 34

Page 36 - The door can be hooked on both sides

The door can be hooked on both sides REMOVING AND REFITTING THE OVEN DOOR (pics. 18-23) Release position Block position Setting screw 18 19 20 35 35

Page 37 - Warning: once completed; can cause damage to the hinges.

21 22 23 Release position Block position Warning: once completed the operation, check the door is correctly hooked. NOTE: Do not place heavy objects on (max 20 Kg)or lean on the oven door when open as this can cause damage to the hinges. 3 6

Page 39 - Cleaning and maintenance; Do not use abrasives, bleach or coarse cleaning material.

Cleaning and maintenance Important: before carrying out maintenance on the oven, it must always be unplugged from the power supply or disconnected from the mains via the electrical system master switch. Wait the appliance to cool down before proceeding with any cleaning operation. Do not use abrasiv...

Foster 7120 043 - Manual

Table of Contents:

Summary

Other Foster Models