Epson TM-U375 - Manual

Table of Contents:

• Page 2 – Printer Part Names; Control Panel
• Page 4 – ii; EMC and Safety Standards Applied; Class; WARNING
• Page 5 – iii; CE Marking; The printer conforms to the following Directives and Norms; FCC Compliance Statement; For American Users; This Class A digital apparatus complies with Canadian ICES-003.
• Page 6 – iv; GEREÄUSCHPEGEL
• Page 7 – Introduction; Features; Chapter 1
• Page 8 – Reference; Chapter 4; contains specifications.
• Page 9 – Contents; Connecting the Printer to Your Direct Connection Display Module; Chapter; vii
• Page 10 – viii
• Page 11 – Setting Up the Printer
• Page 12 – Unpacking; The illustration below shows the items included for the standard; Ribbon cassette; Removing the Protective Materials; be removed before you turn on the printer.
• Page 13 – . Insert the projections on the protective material A into the; ship or store your printer.
• Page 14 – you ever ship or store your printer.; Connecting the Printer to Your Computer; intelligent module, refer to the; IT-U Series User’s Manual; Tighten the screws on both sides of the cable connector.
• Page 15 – Plug the other end of the cable into the computer.; Setting Up the Printer 1-5
• Page 16 – Connecting the Printer to Your Drawer; User’s Manual; Use a drawer that matches the printer specification.; - 6 Setting Up the Printer
• Page 17 – Setting Up the Printer 1-7
• Page 18 – Anschließen des Druckers an lhre Geldlade; Stellen Sie sicher, d a ß der Drucker ausgeschaltet ist.; -8 Setting Up the Printer
• Page 20 – Connecting the Printer to Your Direct Connection Display; Series User’s Manual; Make sure that the printer is turned off.
• Page 21 – Grounding the Printer
• Page 22 – Ground the other end of the ground wire.; Connecting the Power Supply; supplied by the intelligent module. Refer to; the IT-U Series User’s Manual; Using an incorrect power supply may cause fire or
• Page 23 – Plug the power supply’s power cord into an electrical outlet.; To remove the DC cable connector, grasp the connector at the arrow
• Page 24 – Installing the Ribbon Cassette; Use the EPSON ERC-38 ribbon cassette for your printer.; Turn on the printer and open the printer cover.
• Page 25 – ribbon mask without wrinkles or creases, as shown below.; I f; Setting Up the Printer 1 - 1 5
• Page 26 – Installing the Paper Roll; The printer must be turned on before installing the paper roll.; PAPER LOAD
• Page 27 – roll into the groove on the spool as the illustration below.; When the printer cover is open, the; PAPER FEED; button is
• Page 28 – PAPER FEED; Running the self-test with the slip paper; RELEASE
• Page 29 – Running the self-test with validation paper; If you want to pause the self-test for the paper roll, slip paper, or
• Page 30 – Setting the DIP Switches; Remove the screw from the DIP switch cover. Then take off the DIP
• Page 31 – DIP Switch Set 1; S W F u n c t i o n; of; Setting Up the Printer 1-21
• Page 32 – S W F u n c t i o n O N; -1 Auto line feed Enabled; OFF; Disabled; DIP Switch Set 2; S W Function; font; ON OFF; buffer full receive buffer full; Up; the Printer
• Page 33 – Adjusting the Paper Roll End Sensing Position; ESC c 4; command to stop printing when the paper is almost gone.; If; may; Setting Up the Printer 1-23
• Page 34 – There may be some difference between the measured distance A; Distance A Adjustment position number; Loosen the detector screw with a coin or screwdriver.
• Page 35 – Using the Power Switch Cover; You can turn the power on or off with the switch cover attached by; If an accident occurs when the power switch cover is; Setting
• Page 36 – Chapter 2; Using the Printer; Using the Printer 2-1
• Page 37 – -2 Using the Printer
• Page 39 – Slip Paper Handling; When the; Validation Paper Handling; that matches the specifications.
• Page 40 – When the; Replacing the Paper Roll; To change the paper roll, follow the steps below.; Using the Printer 2-5
• Page 41 – Reinstall a new paper roll by following; the; steps in; Installing the Paper; Replacing the Ribbon Cassette; -6 Using the Printer
• Page 42 – ways; Removing the ribbon cassette
• Page 43 – Installing the ribbon cassette; arrow, to take up any slack in the ribbon.; two or three more times. This is necessary to place the ribbon in the; -8 Using the Printer
• Page 44 – Remove the ribbon; from the printer when you store the
• Page 45 – Chapter 3; Troubleshooting
• Page 46 – Read this section if you have a printer problem.; General problems; The lights on the control panel do not come on.; Printing problems; ERROR; If the; The; ERROR; light is flashing and the printer does not print.
• Page 47 – light is off but nothing is printed.; later in this section. If the self-test does not work, contact your; Running the; The printer sounds like it is printing, but nothing is printed.; The ribbon cassette may not be installed properly. See; Replacing the
• Page 49 – pull the paper out in the direction of the arrow as shown in the; Never pull out the jammed paper in the opposite direction from; Pull out the paper gently in the paper feeding direction, and; printer, bring it to the center by holding the base of the print head.
• Page 50 – The remaining amount of paper roll is not detected correctly.; Adjusting the Paper Roll End; Hexadecimal Dumping; PAPER; “. ” is printed if no character corresponds to; and DLE ENQ are disabled.
• Page 51 – Example printing; Ending hexadecimal dumping
• Page 52 – Reference Information; Reference Information 4-1
• Page 53 – Printing Specifications; Serial impact dot matrix; Characters per line:; Character Specifications; Number of characters:; Extended graphics: 128; Character structure:; -2 Reference Information
• Page 54 – Paper Specifications; Friction feed
• Page 55 – Relationship between Ambient Temperature and Number of Copies; Use cut sheets with a paper roll loaded.
• Page 56 – Glue Location of Slip paper; Slip paper; Printing noise may change depending on paper thickness. Noise may
• Page 58 – Environmental Specifications; temperature; Vibration resistance:; Package: Epson standard package
• Page 59 – Interface Specifications; Refer to the; Printing on Cut Sheets; S t e p H o s t Operation; -8 Reference Information
• Page 61 – Example print control for cut sheet; -10 Reference Information
• Page 62 – movement; from; Transmit Status Identification; shown in the following table.; Command Status Replay
• Page 63 – Notes On Number of Printable Columns