Epson HWDV080DV(N- User Manual
Epson HWDV080DV(N– User Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – TABLE OF CONTENTS; SECTION
- Page 3 – INCLUDED IN THE BOX
- Page 6 – UNIT DIMENSIONS; MAKE SURE THAT APPLIANCE IS SUITABLE FOR THE GAS SUPPLY AVAILABLE:; NATURAL GAS; OR
- Page 7 – IMPORTANT SAFETY INFORMATION; Follow State and Local codes for installation.
- Page 8 – SAFETY INFORMATION FOR USERS OF LP-GAS
- Page 9 – INTRODUCTION
- Page 10 – REQUIREMENTS FOR MASSACHUSETTS
- Page 11 – TERMINATION CLEARANCES
- Page 12 – GAS SUPPLY
- Page 13 – CLEARANCES
- Page 14 – INSTALLATION INSTRUCTIONS OVERVIEW
- Page 15 – INSTALLATION AND ASSEMBLY; accessibility for purposes of servicing and proper operation.
- Page 16 – INSTALLATION OF HOUSEWARMER PRODUCT
- Page 17 – INTERIOR PREPARATION AND INSTALLATION OF THE BACK OF THE UNIT
- Page 20 – INTERIOR INSTALLATION OF THE FRONT OF THE UNIT
- Page 21 – CUTTING THE VENT TUBES
- Page 23 – EXTERIOR INSTALLATION OF THE VENTING
- Page 26 – REASSEMBLY AND RESEALING VENT-AIR INTAKE SYSTEM
- Page 29 – INSTALLATION OF OPTIONAL BLOWER KIT HW125SCB
- Page 33 – BEFORE OPERATING APPLIANCE; CHECK THE FOLLOWING BEFORE OPERATING APPLIANCE; ATTENTION INSTALLER: INSTRUCT YOUR CUSTOMER ABOUT THE CORRECT
- Page 37 – OPERATING INSTRUCTIONS; FOR YOUR SAFETY READ BEFORE LIGHTING
- Page 40 – MAINTENANCE INSTRUCTIONS; CLEANING BURNER AND PILOT
- Page 42 – PARTS LIST
- Page 44 – PARTS VIEW
- Page 45 – SERVICE NOTES
- Page 48 – EMPIRE
DIRECT VENT
WALL FURNACE
STANDARD MODELS:
HWDV080DV(N,P)-1
HWDV181DV(N,P)-1
MODELS WITH BLOWER:
HWDV080BDV(N,P)-1
HWDV181BDV(N,P)-1
This appliance may be installed in an after-
market, permanently located, manufactured
home (USA only), or mobile home, where not
prohibited by state or local codes.
This appliance is only for use with the type of
gas indicated on the rating plate. This appliance
is not convertible for use with other gases.
INSTALLATION
INSTRUCTIONS AND
OWNER'S MANUAL
WARNING: If not installed, operated, and
maintained in accordance with the manufactur-
er's instructions, this product could expose you
to substances in fuel or from fuel combustion
which can cause death or serious illness.
Installer: Leave this manual with the ap-
pliance.
Consumer: Retain this manual for future
reference.
— Do not store or use gasoline or other flam-
mable vapors and liquids in the vicinity of
this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor’s phone. Follow the
gas supplier’s instructions.
• If you cannot reach your gas supplier,
call the fire department.
— Installation and service must be performed
by a qualified installer, service agency or
the gas supplier.
WARNING: If the information in these in-
structions are not followed exactly, a fire
or explosion may result causing property
damage, personal injury or loss of life.
DO NOT RETURN THIS PRODUCT TO
THE STORE WHERE YOU PURCHASED
IT. IF YOU ARE MISSING PARTS, OR
HAVE ANY PROBLEMS, CONTACT
EMPIRE COMFORT SYSTEMS INC. AT
(877) 459-1583.
GAS-FIRED
Page 1
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Other Manuals for Epson HWDV080DV(N
Summary
24632-0-0508 Page 2 TABLE OF CONTENTS SECTION PAGE Included in the Box .................................................................................................. 3 Hardware Packets .................................................................................................... 4 Tools Ne...
24632-0-0508 Page 3 INCLUDED IN THE BOX DIRECT VENT HEATER (INSIDE WALL MOUNTING PLATE ATTACHED ON BACK) INLET & OUTLET TUBES INSTALLATION TEMPLATE (TEMPLATE FOR HWDV080 ON REVERSE SIDE) OUTSIDE WALL MOUNTING PLATE & VENT CAP VENT KIT HARDWARE PACKET VENT SHIELD HEATER HARDWARE PACKET
24632-0-0508 Page 6 UNIT DIMENSIONS MAKE SURE THAT APPLIANCE IS SUITABLE FOR THE GAS SUPPLY AVAILABLE: NATURAL GAS OR PROPANE/LP.