Epson ELPMB27- Installation Manual

5 English Package Contents Use only the supplied bolts to install the wall mount. Do not substitute these bolts with any other types. You need to use commercially available M8 x 50 mm anchors (at least 3) to attach the wall plate to the wall. Gather the tools and parts you need before you begin inst...

6 Specifications Weight Approx. 10 kg (22 lbs.) Maximum load capacity 5.5 kg (12.13 lbs.) Arm length 1510 mm (15.45 inches) (from wall plate attachment point to arm cover point) Vertical slide adjustment range 0 to 134 mm (0 to 5.27 inches) (arm length minimum)0 to 230 mm (0 to 9.05 inches) (arm len...

7 English Screen Size and Projection Distance Refer to the tables on the following pages and install the mount and projector to project images at the appropriate size. The values are only a guide.The recommended projection distance is 70 to 119 cm (27.55 to 46.85 inches). Center of lens Projected im...

12 Assembly and Installation Make sure you follow the instructions below to install the wall mount. Otherwise, the wall mount may fall and result in personal injury or property damage. 1. Installing the wall plate 1) Check the position where you want to install the wall plate, and then mark that pos...

14 2. Assembling the wall mount 1) Attach the adjustment unit to the arm unit. 2) Secure temporarily using the hexagonal wrenches (M4 and M8) and M4 x 12 mm hexagon socket head cap bolt and M8 x 15 mm hexagon socket head cap bolt. 3) Attach the arm plate using a hexagonal wrench (M8) and four M8 x 1...

15 English 3. Routing the cables through the arm unit If you are installing ELPIU03 (sold separately), you also need to route the USB cable supplied with ELPIU03 through the arm unit. 4. Attaching the wall mount to the wall plate 1) Attach the hook on the arm plate to the bar on the wall plate.Be ca...

16 5. Attaching the attachment plate to the projector 1) Place the projector upside down. 2) Attach the attachment plate to the projector using the hexagonal wrench (M4) and five M4 x 12 mm bolts with washers/spring washers. 6. Attaching the projector to the adjustment unit 1) Slide the attachment p...

17 English 7. Extending the arm, adjusting the length, and securing temporarily 1) Loosen the screw on the arm.( ) 2) Adjust the length of the arm using the measure on the bottom to match the projection distance recommended in "Screen Size and Projection Distance" on page 7.( ) 3) After adju...

18 10. Turning on the projector and checking the screen 1) Plug in the projector. 2) Turn on the projector. 3) Loosen the screws on the adjustment unit (A, B, C, and D) as shown below to adjust the screen position. 4) Adjust the vertical slide (arm angle) using screw (E) on the bottom of the arm pla...

19 English 11. Attaching the interface cover bracket Attach the interface cover bracket using the hexagonal wrench (M4) and two M4 x 12 mm bolts with washers. 12. Attaching the cable cover Take up the cable slack, and then secure the cable cover with the screws as shown below. Interfacecover bracket...

20 13. Attaching the wall plate cover Secure the wall plate cover with a hexagonal wrench (M4) and three M4 x 12 mm hexagon socket head cap bolts. Installation, removal, and servicing of the projector should only be performed by a qualified technician. See the User’s Guide included with your project...