Elica EAI430SS - User Manual

Page 2 - ENGLISH; Contents; APPROVED FOR RESIDENTIAL APPLIANCES; PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.

2 ENGLISH Contents Important safety notice................................................................................................................................................................................................. 3 Electrical & installation requirements ......................

Page 3 - IMPORTANT SAFETY NOTICE

3 I IMPORTANT SAFETY NOTICE I CAUTION FOR GENERAL VENTILATING USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VAPOURS. I WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: A. Use this unit only in the manner intended by the manufactur...

Page 4 - ELECTRICAL & INSTALLATION REQUIREMENTS; IMPORTANT; BEFORE INSTALLING THE HOOD; DIMENSIONS AND CLEARANCES

4 ELECTRICAL & INSTALLATION REQUIREMENTS IMPORTANT Observe all governing codes and ordinances. It is the customer’s responsibility: • To contact a qualified electrical installer.• To assure that the electrical installation is adequate and in conformance with National Electrical Code, ANSI/NFPA 7...

Page 5 - LIST OF MATERIALS; CAUTION

5 LIST OF MATERIALS Removing the packaging. I CAUTION Remove carton carefully, Wear gloves to protect against sharp edges. I WARNING Remove the protective film covering the product before putting into operation. Supplied Part Pieces Supplied Part Pieces Hood assembly and LED lamps already installed ...

Page 6 - Ducting Options; Preparation

6 Ducting Options Closely follow the instructions set out in this manual. All responsability, for any eventual inconveniences, damages or fires caused by not complying with the instructions in this manual, is declined. Ductless (Recirculating) Horizontal Discharge NOTE: In cases where it should not ...

Page 7 - Installation- Ducting Version; ATTENTION

7 Installation- Ducting Version After having choosen the vent option, proceed as follows: 1 Remove the grease filters. 2 Remove the junction box cover. Remove either the top or the back wiring knockout according the preference and install an approved wiring clamp. J-Box cover Wiring clamp 3 Remove t...

Page 9 - Electrical Connection; WARNING; Complete Installation

9 Electrical Connection I WARNING ELECTRICAL SHOCK HAZARD. I WARNING TURN OFF POWER CIRCUIT AT THE SERVICE PANELBEFORE WIRING THIS UNIT.120 VAC, 15 OR 20 AMP CIRCUIT REQUIRED. ELECTRICAL GROUNDING INSTRUCTIONS THIS APPLIANCE IS FITTED WITH AN ELECTRICAL JUNCTION BOX WITH 3 WIRES, ONE OF WHICH (GREEN...

Page 10 - Control; Mainteinance

10 Control CFM REDUCTION SYSTEM 1 2 3 4 5 6 1. Button ON/OFF motor (stand by) 2. Button for low speed (suction power) selection When flashing, it indicates that you must wash the grease filter. 3. Button for medium speed (suction power) selection 4. Button for high speed (suction power) selection 5....

Page 11 - NOTE

11 NOTE : When removing for replacing for a new one do not remove Fixing Springs, simply pull out one and rotate outwards. Fixing spring Charcoal filter Grease filter top side

Page 12 - ELICA North America; TWO-YEARS LIMITED WARRANTY; TO OBTAIN SERVICE UNDER WARRANTY; Damage or failure to the product caused by operator abuse.; WHO IS COVERED

12 ELICA North America TWO-YEARS LIMITED WARRANTY TO OBTAIN SERVICE UNDER WARRANTY Owner must present proof of original purchase date. Please keep a copy of your dated proof of purchase (sales slip) in order to obtain service under warranty. PARTS AND SERVICE WARRANTY For the period of two (2) years...

Elica EAI430SS - User Manual

Table of Contents:

Summary

Other Elica Range Hoods Models