Page 2 - Correct use
Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com Contents Safety information 2 Product description 4 Control panel 5 First use 6 Set the water softener 6 Use of dishwasher salt 7 Use of rinse aid 8 Daily use 9 Load cutlery and dishes 10 Use of detergent 13 Multitab funct...
Page 4 - Product description
Product description 1 Upper basket 2 Water hardness dial 3 Salt container 4 Detergent dispenser 5 Rinse aid dispenser 6 Rating plate 7 Filters 8 Lower spray arm 9 Upper spray arm 10 Worktop 4 electrolux
Page 5 - Control panel; The digital display
Control panel 1 On/Off button 2 Programme selection buttons 3 Delay start button (Delay) 4 Indicator lights 5 Digital display 6 Function buttons Indicator lights Programme in progress Comes on when a washing programme is set andremains on for all the duration of the washing pro-gramme.Goes off when ...
Page 6 - First use
• the approximate remaining time of the run- ning programme, • activation/deactivation of the rinse aid dis- penser ( ONLY with 'Multitab function' ac- tive), • the end of a washing programme (a zero will appear in the digital display), • the countdown for the delay start,• fault codes concerning ma...
Page 7 - Use of dishwasher salt
Water hardness Adjusting the water hardness setting Use of salt °dH °TH mmol/l manually electronically 37 - 42 65 - 75 6,5 - 7,5 2 level 8 yes 29 - 36 51 - 64 5,1 - 6,4 2 level 7 yes 23 - 28 40 - 50 4,0 - 5,0 2 level 6 yes 19 - 22 33 - 39 3,3 - 3,9 2 level 5 yes 15 - 18 26 - 32 2,6 - 3,2 1 level 4 y...
Page 8 - Use of rinse aid
4. Replace the cap making sure that there is no trace of salt on the screw thread oron the gasket. 5. Replace the cap tightly turning it clock- wise until it stops with a click. Do not worry if water overflows from theunit when filling with salt, this is quitenormal. The salt indicator light on the ...
Page 9 - Daily use; Helpful hints and tips
Reduce it if there are sticky whitish streakson the dishes or a bluish film on glassware orknife blades. Daily use • Check if it’s necessary to refill with dish- washer salt or rinse aid. • Load cutlery and dishes into the dishwash- er. • Fill with dishwasher detergent.• Select a wash programme suit...
Page 10 - Load cutlery and dishes; The lower basket
Load cutlery and dishes The lower basket The lower basket is designed to take sauce-pan, lids, plates, salad bowls, cutlery ect.Service dishes and large lids should be ar-ranged around the edge of the basket, en-suring that the spray arms can turn freely. The rows of prongs in the lower basket canli...
Page 11 - NEVER PUT KNIVES IN THE
For best results we recommend that you usethe cutlery grid.If the size and dimensions of the cutlery donot allow the use of the grid, it can be easilyhidden. The upper basket The upper basket is designed for plates (des-sert plates, saucers, dinner plates of up to 24cm in diameter), salad bowls, cup...
Page 12 - Soft spikes; BEFORE CLOSING THE; Adjusting the height of the upper basket
The dimensions of the cutlery depend on theposition of the upper basket. Refer to the fol-lowing table. Cutlery dimensions for mini cutlery basket Upper basket in higherposition maximum 15 cm Upper basket in lowerposition maximum 20 cm Soft spikes Soft spikes impede glassware to move dur-ing the was...
Page 13 - Carefully lift both sides upwards until the; Use of detergent; Fill with detergent; All programmes with prewash need an
2. Carefully lift both sides upwards until the mechanism is engaged and the basket isstable. To lower the basket to the original posi-tion proceed as follows: 1. Pull out the basket until it stops.2. Carefully lift both sides upwards and then allow the mechanism to drop back downslowly, keeping hold...
Page 14 - Multitab function
4. Close the lid and press until it locks in place. Detergent tablets from different manu-facturers dissolve at different rates. Forthis reason, some detergent tablets donot attain their full cleaning power duringshort washing programmes. Therefore,please use long washing programmeswhen using deterg...
Page 15 - Select and start a washing programme
Rinse aid dispenser activated 4. To change the setting, press button B again, the digital display indicates thenew setting. 5. To memorize the operation, switch off the dishwasher by pressing the On/Off but-ton. If you decide to revert back to theuse of individual detergents we ad-vise that you: 1. ...
Page 16 - Unloading the dishwasher; Washing programmes
Cancel a delay start or a washingprogramme in progress • Simultaneously press and hold the two function buttons B and C until all the pro- gramme lights come on. • Cancelling a delay start will also cancel the washing programme. You have to selectthe washing programme again. • If a new washing progr...
Page 17 - Consumption values; Care and cleaning; Cleaning the filters; Before cleaning the filters
Programme Degree of soil Type of load Programme description Glass Normal or light soil Delicate crockery andglassware Main wash up to 45°C1 intermediate rinseFinal rinseDrying 1) During the Auto programme, the soil level of the dishes is given by how cloudy the water is. The programme duration and c...
Page 18 - What to do if...
7. Put the flat filter back in the base of the washing compartment and ensure that itfits perfectly. 8. Place the coarse filter ( A ) in the microfil- ter ( B ) and press together. 9. Put the filter combination in place and lock by turning the handle clockwise tothe stop. During this process ensure ...
Page 20 - Technical data; Testing in accordance with
The wash results are not satisfactory The dishes are notclean • The wrong programme has been selected.• The dishes are arranged in such a way as to stop water reaching all parts of a surface. The baskets must not be overloaded. • The spray arms do not rotate freely due to incorrect arrangement of th...
Page 21 - Installation; Any electrical and/or
Arrangement upper basket withoutsalad-bow Arrangement upper basket with salad-bowl Cup racks: position A Arrangement lower basket Arrangement cutlery basket Installation Warning! Any electrical and/or plumbing work required to installthis appliance should be carried outby a qualified electrician and...
Page 22 - • Remove the machine’s worktop by un-; Levelling; Water connection; Water inlet connection
By removing the machine's worktop, you caninstall it under a close fitting sink unit or a pre-existing top, providing the dimensions of therecess correspond to those shown in thepicture. Proceed as follows: • Remove the machine’s worktop by un- screwing the two rear retaining screws (1),pull the wor...
Page 23 - • If water inlet hose or the safety valve is; Water drain connection; To a stand pipe provided with venthole,; the entire plastic mem-
locknut. The locknut must be correctly fitted to avoid water leaks. Attention! NOT all dishwasher models ofhave inlet and drain hoses provided witha locknut. In this case, this facility is notavailable. If the appliance is connected to new pipes orpipes which have not been used for a longtime, you s...
Page 24 - Electrical connection; Safety standards require; Environment concerns; The symbol; Packaging material; When a unit is no longer being
Our appliances are supplied with a se-curity device to protect against the re-turn of dirty water back into the machine.If the spigot of your sink has a "no returnvalve" incorporated this can prevent thecorrect draining of your dishwasher. Wetherefore advise you to remove it. To avoid water ...
