Dish Network DISH 351 - Manual
Dish Network DISH 351 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Chapter 2; Receiver Description and Installation; The Receiver Back Panel Connections; only; Signal Input; TV S; labels makes it
- Page 3 – Telephone Jack; Note; must; Remote Control; SAT
- Page 4 – Remote Control Batteries; Program
- Page 5 – Remote Control Settings; Change the Address; not; Checking the Remote Control Address
- Page 6 – Connecting Your Receiver; Connection Diagram Example
- Page 7 – Performing the QAM Frequency Scan; : When you turn your receiver on it may display the
- Page 8 – Installation; option on the; System Setup Menu; The; Installation and Setup Menu
- Page 9 – required
- Page 11 – Connecting Your Receiver to a Phone Line
- Page 12 – SELECT; Prefix Code
Page 9
Chapter 2
Receiver Description and Installation
The Receiver Front Panel
Smart Card Door
Behind this door is a slot for a future smart card. No smart card is included with
this receiver.
Up and Down Arrow Buttons
The
UP
and
DOWN
buttons change the channel on the receiver.
IR Sensor and IR Blaster
The
IR SENSOR
receives IR signals from the remote control. The
IR
BLASTER
transmits IR signals to control a VCR in order to perform automated
recordings
.
Power Button and Light
The
GREEN LIGHT
on the front panel lights up when you press the receiver’s
POWER
button ON and goes out when you press the
POWER
button OFF.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Page 10 Chapter 2 Receiver Description and Installation The Receiver Back Panel Connections Tighten the connections by hand only . If you use a wrench you might over-tighten the connections and cause damage that would not be covered by the Limited Warranty . The back panel of the receiver provides t...
Page 11 Remote Control Telephone Jack Connect a telephone cable with a standard RJ-11 telephone connector to the receiver here, and then connect the cable to an active telephone line. Note : The receiver must be connected at all times to an active telephone line. Remote Control The remote control gi...
Page 12 Chapter 2 Receiver Description and Installation Remote Control Batteries The remote control comes with AAA batteries, which need to be installed when you first receive your system. When you replace old batteries, you should replace all of the batteries. Use batteries of the same kind, for ex...
