Dish Network DISH 351 - Manuals

Page 2 - Chapter 2; Receiver Description and Installation; The Receiver Back Panel Connections; only; Signal Input; TV S; labels makes it

Page 10 Chapter 2 Receiver Description and Installation The Receiver Back Panel Connections Tighten the connections by hand only . If you use a wrench you might over-tighten the connections and cause damage that would not be covered by the Limited Warranty . The back panel of the receiver provides t...

Page 3 - Telephone Jack; Note; must; Remote Control; SAT

Page 11 Remote Control Telephone Jack Connect a telephone cable with a standard RJ-11 telephone connector to the receiver here, and then connect the cable to an active telephone line. Note : The receiver must be connected at all times to an active telephone line. Remote Control The remote control gi...

Page 4 - Remote Control Batteries; Program

Page 12 Chapter 2 Receiver Description and Installation Remote Control Batteries The remote control comes with AAA batteries, which need to be installed when you first receive your system. When you replace old batteries, you should replace all of the batteries. Use batteries of the same kind, for ex...

Page 5 - Remote Control Settings; Change the Address; not; Checking the Remote Control Address

Page 13 Remote Control Settings Remote Control Settings Change the Address The remote control and receiver can operate on any one of 16 addresses; however, they must both be on the same address for the remote to control the receiver. This section explains how to change the address in both devices. N...

Page 6 - Connecting Your Receiver; Connection Diagram Example

Page 14 Chapter 2 Receiver Description and Installation Connecting Your Receiver Connection Diagram Example The diagram below is an example of how to connect your receiver, TV, and VCR. Typical Connection Procedure Tighten all the coaxial cable connections only by hand. Using a wrench may over-tight...

Page 7 - Performing the QAM Frequency Scan; : When you turn your receiver on it may display the

Page 15 Performing the QAM Frequency Scan Performing the QAM Frequency Scan Note : When you turn your receiver on it may display the QAM Frequency Scan and Signal Strength screen automatically. If it does, then skip down to Step 5. 1. Press the MENU button to open the Main Menu . 2. Select the Syste...

Page 8 - Installation; option on the; System Setup Menu; The; Installation and Setup Menu

Page 16 Chapter 2 Receiver Description and Installation 3. Select the Installation option on the System Setup Menu . The Installation and Setup Menu screen is displayed. 4. Select the QAM Scan/Signal option. The QAM Fre- quency Scan and Signal Strength screen is displayed.

Page 9 - required

Page 17 Performing the QAM Frequency Scan 5. Select the Scan option. While scanning, the receiver displays the QAM Frequency Scan Progress screen. The scan can take a few minutes. Note : The receiver creates a table of available satellite transponders with the corresponding QAM frequencies. This tab...

Page 11 - Connecting Your Receiver to a Phone Line

Page 19 Connecting Your Receiver to a Phone Line Connecting Your Receiver to a Phone Line You must keep your receiver connected to an active telephone line. Otherwise, you may not be able to order pay per view programs or use all of the DISH Interactive features. Run the RJ-11 telephone cable suppli...

Page 12 - SELECT; Prefix Code

Page 20 Chapter 2 Receiver Description and Installation Note : Usually, you need a telephone number prefix only for business installations. For most residential installations, all you need to do is set the telephone system type. 6. Move the highlight to the Outside Line Prefix list. Press the SELECT...