Dimplex BLF5051-AU - User Manual

IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS The heater carries the Warning Symbol indicating that it must not be covered WARNING: In order to avoid overheating, do not cover the appliance. Do not place material or garments on the appliance, or obstruct the air circulation around the applia...

7 Quick Reference Guide Figure 1 ① The electrical information regarding your electric fireplace can be found on the rating label located on the front of the unit, behind the glass.Before installation, please record your fireplace's serial number below for future reference. ② If you have any technica...

Site Selection Review and consider all of the following conditions for installation: • Dimensions of the unit: 128cm x 49.5cm • Unit requires a minimum of two (2) wall studs in order to ensure a secure installation Three possible installation methods: • Installation method: Surface mount; In-wall Re...

9 Fireplace Installation The fireplace is packaged with a plug installed for plug-in convenience. Hard wiring the fireplace is also an option by removing the plug from the factory fitted cord and completing the wiring according to National and Local Elecrical Codes. WARNING: Do not attempt to wire y...

wall anchors are used and at least one is located into a stud. 6. Remove fireplace from wall and store in a safe place away from traffic. 7. Screw all four (4) supplied #8, 3.8 cm square head mounting screws and washers into the wall and/or wall anchors leaving 6.5 mm of thread. 8. Align chosen key-...

11 Fireplace Installation I n - w a l l R e c e s s e d Installation - 100mm Deep CAUTION: Two people may be required for various steps of this procedure. 1. Prepare a wall with a framed opening of 118.1 cm wide x 42 cm high (Figure 4). ! NOTE: The sizing has allowed for 6.4mm around the fireplace i...

Fireplace Installation Ensure that the 3-Position Switch is set to the Off position ("O") and that the circuit on which the fireplace is to be installed has the power cut off at the service panel until installation is complete.3. Lift fireplace and insert into opening (Figure 5). 4. Use bubb...

13 outlet or install an outlet on a nearby wall stud within the wall). • Hard wire the fireplace. ! NOTE: Hard wiring can be done by removing the plug from the factory fitted cord and completing the wiring according to National and Local Elecrical Codes. WARNING: Do not attempt to wire your own new ...

Fireplace Installation 3-Position Switch is switched to the Off position ("O"). 5. If unit is not hard-wired, plug fireplace into a 13 Amp, 230 Volt outlet (refer to NOTE 1). Figure 9 Front tray Front glass assembly Figure 10 Hooks (4) Mounts (4) Figure 11 Tab

15 Operation Figure 18 WARNING: This electric firebox must be properly installed before it is used. The unit can be controlled by either the manual controls which are located on the upper right of the fireplace or the remote (Figure 18 & 19). The fireplace is supplied with an IR multifunction re...

Operation displayed on the On Screen Display, for 5 seconds before turning off. ! NOTE: A f t e r t h e h e a t e r i s switched off, there is a 60 second f a n d e l a y, w h e r e t h e f a n w i l l continue running before turning off. ! NOTE: The unit can be operated in Heat Only Mode . When the...

17 Operation combinations of colours of the flame base and media lighting. ! NOTE: The last theme of the cycle is a prism where the unit cycles through a variety of colours. Pressing the button stops the cycling and holds the unit on the preferred color, indicated by a "U" - Unfreeze or a &#...

Maintenance WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. Partially Reflective Glass Cleaning The partially reflective glass is cleaned in the factory during the assembly operation. During shipment, installati...