Dimplex BLF7451-AU - Manuals

IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS The heater carries the Warning Symbol indicating that it must not be covered WARNING: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance must not be supplied through an external switching device, such a...

7 Quick Reference Guide Figure 1 [7.1 in.] 467 mm [18.4 in.] 1883 mm [74.1 in.] 493 mm [19.4 in.] 187 mm [7.3 in.] 1844 mm [72.6 in.] ① The electrical information regarding your electric fireplace can be found on the rating label located on the front of the unit, behind the glass.Before installation...

Site Selection Review and consider all of the following conditions for installation: • Dimensions of the unit: 188.3cm x 49.5cm • Unit requires a minimum of three (3) wall studs in order to ensure a secure installation Three possible installation methods: • Installation method: Surface mount; In-wal...

9 Fireplace Installation The fireplace is packaged with a three prong plug installed for plug-in convenience. Hard wiring the fireplace is also an option by removing the plug from the factory fitted cord and completing the wiring according to National and Local Elecrical Codes. WARNING: Do not attem...

In-wall Recessed Installation - 100mm Deep CAUTION: Two people may be required for various steps of this procedure. 1. Prepare a wall with a framed opening of 185.7cm wide x 47 cm high (Figure 4). ! NOTE: The sizing has allowed for 6.4mm around the fireplace insert for ease of installation. This fir...

11 Fireplace Installation Ensure that the 3-Position Switch is set to the Off position ("O") and that the circuit on which the fireplace is to be installed has the power cut off at the service panel until installation is complete.3. Lift fireplace and insert into opening (Figure 5). 4. Use b...

Fireplace Installation additional venting.2. Choose your method of supplying power to the unit: • Plug in (you may run the power cord out of the framed wall opening to an existing outlet or install an outlet on a nearby wall stud within the wall). • Hard wire the fireplace. ! NOTE: Hard wiring can b...

13 fireplace chassis, into wall studs (Figure 8). 6. Refer to Front Glass Installation section, for final installation procedures. Front Glass Installation 1. Evenly distribute supplied glass rock on the front tray of the fireplace (Figure 9). 2. Carefully mount front glass assembly so that the fron...

Fireplace Installation Figure 9 Front tray Front glass assembly Figure 10 Hooks (4) Mounts (4) Figure 11 Tab

15 Operation functions that it was set to when it was turned Off and the intake temperature will be indicated on the Floating Display TM . ! NOTE: When any button is pressed the intake temperature will be displayed on the Floating Display TM for 5 seconds. B. Flame Effects Turns the flame effect On ...

Operation d i s p l a y e d o n t h e F l o a t i n g Display TM , for 5 seconds before turning off. ! NOTE: After the heater is switched off, there is a 60 second f a n d e l a y, w h e r e t h e f a n w i l l continue running before turning off. ! NOTE: The unit can be operated in Heat Only Mode ....

19 Maintenance WARNING: Disconnect power before attempting any maintenance or cleaning to reduce the risk of fire, electric shock or damage to persons. Partially Reflective Glass Cleaning The partially reflective glass is cleaned in the factory during the assembly operation. During shipment, install...