Dewalt DCS370- User Manual

Page 3 - Fence; For Attaching Front & Rear Rail to Non Delta Saws

1. T-Square ® Fence 2. Support Leg (2)3. Leveling Foot (2)4. 3/8-16 Hex Nut (2)5. #8 x 5/8” Pan HD Screw (12)6. #10-32 X 3/8” RND HD Screw (2)7. Flat Washer (2)8. Hairline Pointer9. Knob For Attaching Front Rail to Delta Unisaw/ContractorSaw/Hybrid Saw 10. 5/16-18 x 1-1/4” Flat HD Screw (2)11. 3/8 L...

Page 4 - FOR DELTA CONTRACTORS & HYBRID SAWS ONLY

CONSTRUCTING EXTENSION TABLE ASSEMBLY (DELTA SAWS ONLY) FOR ALL OTHER SAWS, PROCEEDDIRECTLY TO PAGE 7, STEP 1. DISCONNECT THE SAW FROMTHE POWER SOURCE! FRONT RAIL TO SAW 1. Assemble front rail (A) Fig. 5 to the front edge of the sawtable using the two 5/16-18 x 1-1/4” long flat head Phillipsscrew, f...

Page 5 - REAR RAIL FOR DELTA SAWS; NOTE: Do not use template to set rear rail.; Fasten rail to the; For Delta Hybrid Saw and Left-tilting Contractor’s Saw; TABLE LEGS TO TABLE BOARD; Height adjustment will be made later.

REAR RAIL FOR DELTA SAWS NOTE: Do not use template to set rear rail. 3. Align the two non-countersunk holes in the rear rail with thetwo holes in the rear edge of the saw table. The two cutouts inthe rear rail need to be below the bottom of the two miter slotsin the saw table. Fasten rear rail to th...

Page 6 - Lay the table upside down on the floor or on a bench.; NOTE: The guide tube should

6. Lay the table upside down on the floor or on a bench. 7. Position the table leg (I) to the closed in corner of the extensiontable (J) as shown in Fig. 11. 8. Attach the table leg to the table board with six 5/8” long woodscrews (K). Repeat this process for the remaining leg. IMPORTANT: If your sa...

Page 7 - ASSEMBLE FRONT RAIL

ASSEMBLY (FOR ALL OTHER SAWS) DISCONNECT THE SAW FROM THE POWERSOURCE! ASSEMBLE FRONT RAIL 1. Raise saw blade (A) Fig. 15. Place a straight edge (B)against the right side of saw blade extending out over thefront of the saw as shown. Position front rail (C) againstthe edge of saw table and lightly cl...

Page 8 - Lay the extension table upside down on a floor or bench.

IMPORTANT: If your saw fence system will be usedwith a mobile base underneath the saw base and tablelegs, the position of the legs will have to be changedto fit the mobile base extension. 9. Lay the extension table upside down on a floor or bench. 10. Position table leg (K) to the closed in corner o...

Page 12 - TWO YEAR LIMITED NEW PRODUCT WARRANTY

Delta will repair or replace, at its expense and at its option, any new Delta machine,machine part, or machine accessory which in normaluse has proven to be defective in workmanship or material, provided that the customer returns the product prepaid to a Delta factoryservice center or authorized ser...

Table of Contents:

Other Manuals for Dewalt DCS370

Summary

Other Dewalt Models