Page 3 - PRODUCT LABEL
3 3 Dear Customer, Thank you for having purchased and given your preference to our product. The safety precautions and recommendations reported below are for your own safety and that of others. They will also provide a means by which to make full use of the features offered by your appliance. Please...
Page 4 - IMPORTANT SAFETY PRECAUTIONS AND RECOMMENDATIONS; in this manual, including those for surface temperatures.; This film must be removed before using the; IMPORTANT: The use of suitable protective clothing/gloves is
4 4 IMPORTANT SAFETY PRECAUTIONS AND RECOMMENDATIONS IMPORTANT: This appliance is designed and manufactured solely for the cooking of domestic (household) food and is not suitable for any non domestic application and therefore should not be used in a commercial environment.The appliance guarantee wi...
Page 10 - The appliance must be housed in heat resistant units.; INSTALLATION
10 10 IMPORTANT: • The appliance is designed and approved for domestic use only and should not be installed in a commercial, semi commercial or communal environment. Your product will not be guaranteed if installed in any of the above environments and could affect any third party or public liability...
Page 11 - STANDARD INSTALLATION; Description
11 11 FLUSH INSTALLATION (MODELS WITHOUT METAL TRIM/S ONLY) If you wish to install the hob flush with the work surface, it is neccessary to execute/carry out a miling in the hole of the cut-out as indicated in figs. 1.1b. E 50 mm D A B C Fig. 1.1a E 50 mm D D1 E1 R7 5 A B C Fig. 1.1b STANDARD INSTAL...
Page 12 - FITTING REQUIREMENTS; min
12 12 FITTING REQUIREMENTS This cooktop can be built into a working surface from 20 mm thick and 600 mm deep. In order to install the ceramic hob into the kitchen fixture, a hole with the dimensions shown in figures 1.1a and 1.1b has to be made, keeping in consideration the following: • A 20 mm vent...
Page 13 - FASTENING THE COOKTOP; Adhesive side
13 13 FASTENING THE COOKTOP Each cooktop is provided with an installation kit including brackets and screws for fastening the cooktop to benches from 20 mm thick. Before you install the cooktop, make sure that the work surface is square and level, and no structural members interfere with space requi...
Page 14 - ELECTRICAL SECTION; ELECTRICAL REQUIREMENTS; multiple power points as these may overheat and catch fire.; VOLTAGE AND POWER CONSUMPTION
14 14 ELECTRICAL SECTION 2 IMPORTANT: Installation must be carried out according to the manufacturer’s instructions. Incorrect installation may cause harm and damage to people, animals or property, for which the manufacturer accepts no responsibility. Before carrying out any work on the electrical s...
Page 15 - CONNECTION OF THE POWER SUPPLY CABLE; The operations must be executed by a qualified technician.; MODELS SUPPLIED WITHOUT POWER CORD
15 15 CONNECTION OF THE POWER SUPPLY CABLE Important! This cooktop must be connected to the electricity supply only by an authorised person. To connect the feeder cable to the hob it is necessary to carry out the following operations: • Unhook the terminal board cover “ A ” by inserting a screwdrive...
Page 17 - MODELS SUPPLIED WITH POWER CORD 5x2,5 mm; agent or a similarly qualified person in order to avoid a hazard.
17 17 • The cooktop is supplied with a power cord already fitted to the appliance and it is suitable for a single-phase type electrical connection (fig. 2.3). • For the two-phase type electrical connection (fig. 2.4): – separate the black and brown wires by removing the metallic terminal; – remove a...
Page 19 - ELECTRIC DIAGRAM
19 19 ELECTRIC DIAGRAM ELECTRIC DIAGRAM KEY TC Touch control board TB Terminal block PE Earth connection LD1 Front-left inner heating element LD1d Front-left outer heating element LD2 Rear-left heating element LD3 Central circular heating element LD3d Central second heating element LD4 Rear-right in...
Page 21 - User guide
Page 22 - FEATURES AND TECHNICAL DATA
22 22 Fig. 1.1 FEATURES AND TECHNICAL DATA 1 13 8 11 12 10 7 5 6 3 2 4 1 14 9 Fig. 1.2 1 3 2 4 1 5 10 1 2 3 9 4 5 6 7 8 12 11 13 14
Page 24 - HI-LIGHT RADIANT ZONES; HOW TO USE THE HOB
24 24 The ceramic surface of the hob allows a fast transmission of heat in the vertical direction, from the heating elements underneath the ceramic glass to the pans set on it.The heat does not spread in a horizontal direction, so that the glass stays “cool” at only a few centimeters from the cookin...
Page 25 - ON
25 25 Fig. 2.4 Notes: • Each selection (by pressing one of the keys) is indicated by an acoustic signal (beep). Any time the cooktop is connected to the electrical supply or after a power failure, the safety key-lock protection will be automatically activated (indicator light ON above key ). • Befor...
Page 26 - HOW TO SWITCH ON/OFF THE COOKTOP; Increase
26 26 HOW TO SWITCH ON/OFF THE COOKTOP Switching ON Touch the key until the touch control system is lit (fig. 2.5). The displays of the cooking zones read “ 0 ”. Notes: • If the safety key-lock protection is active, the touch control can be turned ON only after having deactivated this protection. • ...
Page 27 - AFTERHEAT IN COOKING ZONE/S; OFF
27 27 FUNCTIONING OF THE DOUBLE COOKING ZONE The double cooking zone consists of two circuits, which may be used in the following modes: • Reduced cooking zone: only the first heating unit is switched ON . • Extended cooking zone: the first and second heating circuits are both switched ON . Turn on ...
Page 28 - BOOSTER FUNCTION
28 28 SAFETY KEY-LOCK TO PROTECT CHILDREN This function locks the touch-control keys against unwanted activation. To activate the key-lock press the key ; the indicator light close to the lock symbol will light up. • Cooking zone/s operating (power level already set) - with the key-lock protection a...
Page 30 - “FAST HEATING” FUNCTION; PAUSE MODE
30 30 “FAST HEATING” FUNCTION To activate the “Fast Heating” function: • Press the key and keep it pressed until the touch control is lighted. • Select a cooking zone by touching the relevant display of the cooking zone to be used. • Select a setting on the selector (between “ 1 ” and “ 9 ” ): touch...
Page 31 - COOKING HINTS; Knob; Heating
31 31 1 2 3 4 5 6 7 8 9 10 11 12 Fig. 2.16 After a short period of use, experience will teach you which setting is the right one for your needs. COOKING HINTS Knob setting TYPE OF COOKING 0 Switched OFF 1 2 For melting operations (butter, chocolate). 3 To maintain food hot and to heat small quantiti...
Page 32 - SAFETY HINTS
32 32 DISTORTEDPANBASE WRONG DISTORTEDPANBASE WRONG LEVELPANBASE CORRECT WRONG WASTINGPOWER WRONG WASTINGPOWER WRONG WASTINGPOWER CORRECT COMPLETE USEOF THE HEAT DO NOT USE GLASSWARE ON CERAMIC HOBS. DO NOT USE PANS WITH ROUGHT CIRCULAR MACHINED BASE. Fig. 2.17 Fig. 2.18 SAFETY HINTS • Before you sw...
Page 33 - ERROR CODE ON THE DISPLAY/S
33 33 Power level of Cooking zones Operation time limit 10 hours 5 hours 5 hours 4 hours 3 hours 2 hours 2 hours 2 hours 1 hour 10 minutes OPERATION TIME LIMIT OF COOKING ZONES Each cooking zone is automatically switched OFF after a maximum preset time if no operation is performed.The maximum preset...
Page 34 - MAXIMUM POWER MANAGEMENT; POWER MANAGEMENT WHEN USING THE COOKTOP
34 34 MAXIMUM POWER MANAGEMENT The cooktop maximum power limit (8500 W) can be reduced to a minimum of 2500 W. To change the maximum power limit (only within 30 seconds from the electrical connection): • Connect the appliance to the electrical power supply. • Press at the same time the and keys cont...
Page 35 - CLEANING AND MAINTENANCE; GENERAL ADVICE; and disconnected from the electrical power supply.; Do not scratch the cooktop with cutting or sharp objects.
35 35 CLEANING AND MAINTENANCE 3 GENERAL ADVICE • Before you begin cleaning, you must ensure that the appliance is switched off and disconnected from the electrical power supply. • It is advisable to clean when the appliance is cold. • Avoid leaving alkaline or acidic substances (lemon juice, vinega...
Page 36 - CLEANING THE CERAMIC HOB
36 36 CLEANING THE CERAMIC HOB • Remove spillages and other types of incrustations. • Dust or food particles can be removed with a damp cloth. • If you use a detergent, please make sure that it is not abrasive or scouring. Abrasive or scouring powders can damage the glass surface of the hob. • All t...
Page 37 - SERVICE AND MAINTENANCE; Servicing the appliance:
37 37 SERVICE AND MAINTENANCE Servicing the appliance: Service may be obtained by contacting our Customer Service Centre to locate the nearest Authorised ELBA APPLIANCES Service Agent shared services with Fisher and Paykel Australia PTY LTD (ELBA Appliances AUS, a division of F&P AUS PTY LTD).: ...
Page 40 - w w w . d e l o n g h i c o o k i n g a p p l i a n c e s . c o m . a u
w w w . d e l o n g h i c o o k i n g a p p l i a n c e s . c o m . a u C o d . 11 0 6 3 5 2 - ß 0 D e s c r i p t i o n s a n d i l l u s t r a t i o n s i n t h i s b o o k l e t a r e g i v e n a s s i m p l y i n d i c a t i v e .T h e m a n u f a c t u r e r r e s e r v e s t h e r i g h t , c ...
