Page 2 - CONTENTS; READ BEFORE OPERATION
1 CONTENTS READ BEFORE OPERATION Safety precautions ......................................... 2Names of parts ............................................... 4Preparation Before Operation ........................ 7 OPERATION AUTO · DRY · COOL · HEAT · FAN Operation .....................................
Page 3 - Safety precautions; WARNING
2 READ BEFORE OPERATION Safety precautions • Keep this manual where the operator can easily find them. • Read this manual attentively before starting up the unit. • For safety reason the operator must read the following cautions carefully. • This manual classifies precautions into WARNING and CAUTIO...
Page 4 - Consider nuisance to your neighbours from noises.
3 • Do not place anything under the indoor or outdoor unit that must be kept away from moisture. In certain conditions, moisture in the air may condense and drip. • After a long use, check the unit stand and fittings for damage. • Do not touch the air inlet and alminum fins of outdoor unit. It may c...
Page 5 - Names of parts; Indoor Unit
4 Names of parts ■ Indoor Unit 1 2 4 3 9 10 8 6 7 13 11 12 14 5 01_En_3P232468-5.fm Page 4 Wednesday, June 4, 2008 9:28 AM
Page 6 - Outdoor Unit
5 ■ Outdoor Unit ■ Indoor Unit 1. Air filter 2. Titanium Apatite Photocatalytic Air-Purifying Filter 3. Air inlet4. Front panel5. Panel tab6. Room temperature sensor: • It senses the air temperature around the unit. 7. Display8. Air outlet9. Flap (horizontal blade): (page 12.) 10. Louvers (vertical ...
Page 7 - Remote Controller
6 ■ Remote Controller 1. Signal transmitter: • It sends signals to the indoor unit. 2. Display: • It displays the current settings. (In this illustration, each section is shown with all its displays ON for the purpose of explanation.) 3. POWERFUL button: POWERFUL operation (page 13.) 4. TEMPERATURE ...
Page 8 - Preparation Before Operation; To set the batteries; ATTENTION
7 Preparation Before Operation ■ To set the batteries 1. Slide the front cover to take it off. 2. Set two dry batteries (AAA). 3. Set the front cover as before. ATTENTION ■ About batteries• When replacing the batteries, use batteries of the same type, and replace the two old batteries together. • Wh...
Page 9 - Choose a place from where the
8 Preparation Before Operation ■ To operate the remote controller • To use the remote controller, aim the transmitter at the indoor unit. If there is anything to block signals between the unit and the remote controller, such as a curtain, the unit will not operate. • Do not drop the remote controlle...
Page 10 - To set the clock; Press “TIMER setting button”; Turn the breaker ON; NOTE
9 ■ To set the clock 1. Press “CLOCK button”. is displayed. blinks. 2. Press “TIMER setting button” to set the clock to the present time. Holding down “ ” or “ ” button rap- idly increases or decreases the time dis-play. 3. Press “CLOCK button”. blinks. ■ Turn the breaker ON • Turning ON the breaker...
Page 11 - AUTO · DRY · COOL · HEAT · FAN Operation; To start operation; Press “MODE selector button”; To stop operation; Press “TEMPERATURE adjustment button”.
10 OPERATION AUTO · DRY · COOL · HEAT · FAN Operation The air conditioner operates with the operation mode of your choice.From the next time on, the air conditioner will operate with the same operation mode. ■ To start operation 1. Press “MODE selector button” and select a operation mode. • Each pre...
Page 12 - To change the air flow rate setting
11 ■ To change the air flow rate setting 5. Press “FAN setting button”. NOTE DRY mode AUTO or HEAT or COOL or FAN mode The air flow rate setting is not variable. Five levels of air flow rate setting from “ ” to “ ” plus “ ” are available. ■ Note on HEAT operation• Since this air conditioner heats th...
Page 13 - Adjusting the Air Flow Direction; When the flap have reached the; Notes on flaps and louvers angles.
12 Adjusting the Air Flow Direction You can adjust the air flow direction to increase your com-fort. ■ To adjust the horizontal blade (flap) 1. Press “SWING button”. • “ ” is displayed on the LCD and the flaps will begin to swing. 2. When the flap have reached the desired position, press “SWING” but...
Page 14 - POWERFUL Operation; Press “POWERFUL button”
13 POWERFUL Operation POWERFUL operation quickly maximizes the cooling (heating) effect in any operation mode. You can get the maximum capacity. ■ To start POWERFUL operation 1. Press “POWERFUL button”. • POWERFUL operation ends in 20 minutes. Then the system automatically operates again with the se...
Page 15 - TIMER Operation; Press “TIMER Setting button”; To cancel the OFF TIMER Operation
14 TIMER Operation Timer functions are useful for automatically switching the air conditioner on or off at night or in the morning. You can also use OFF TIMER and ON TIMER in combination. ■ To use OFF TIMER opera-tion • Check that the clock is correct.If not, set the clock to the present time. (page...
Page 16 - To use ON TIMER operation; To cancel ON TIMER operation
15 ■ To use ON TIMER operation • Check that the clock is correct. If not, set the clock to the present time (page 9.). 1. Press “ON TIMER button”. is displayed. blinks. 2. Press “TIMER Setting button” until the time setting reaches the point you like. • Every pressing of either button increases or d...
Page 17 - Care and Cleaning; CAUTION; Units
16 CARE Care and Cleaning CAUTION ■ Indoor unit, Outdoor unit and Remote controller 1. Wipe them with dry soft cloth. ■ Front panel 1. Open the front panel. • Hold the panel by the tabs on the two sides and lift it unitl it stops with a click. 2. Remove the front panel. • Open the front panel furthe...
Page 19 - Check; Operate the “FAN only” for several hours on a fine day to dry out the
18 NOTE Check ■ Before a long idle period 1. Operate the “FAN only” for several hours on a fine day to dry out the inside. • Press “MODE button” and select “FAN” operation. • Press “ON/OFF button” and start operation. 2. After operation stops, turn off the breaker for the room air conditioner. 3. Cl...
Page 20 - Trouble Shooting; These cases are not troubles.
19 TROUBLE SHOOTING Trouble Shooting The following cases are not air conditioner troubles but have some reasons. You may just continue using it. These cases are not troubles. Case Explanation Operation does not start soon.• When ON/OFF button was pressed soon after operation was stopped. • When the ...
Page 22 - Disposal requirements; Call the service shop immediately.
21 WARNING ■ When an abnormality (such as a burning smell) occurs, stop operation and turn the breaker OFF. Continued operation in an abnormal condition may result in troubles, electric shocks or fire.Consult the service shop where you bought the air conditioner. ■ Do not attempt to repair or modify...
Page 23 - MEMO
22 MEMO 01_En_3P232468-5.fm Page 22 Wednesday, June 4, 2008 9:28 AM
(H)-Specifications/webp/1.webp){kind=small}
(H)-Service-Manual/webp/1.webp){kind=small}
