Page 2 - CONTENTS; READ BEFORE OPERATION
1 CONTENTS READ BEFORE OPERATION Safety precautions ......................................... 2Names of parts ............................................... 4Preparation Before Operation ........................ 7 OPERATION AUTO · DRY · COOL · HEAT · FAN Operation .....................................
Page 3 - Safety precautions; WARNING
2 READ BEFORE OPERATION Safety precautions • Keep this manual where the operator can easily find them.• Read this manual attentively before starting up the unit.• For safety reason the operator must read the following cautions carefully.• This manual classifies precautions into WARNINGS and CAUTIONS...
Page 4 - Consider nuisance to your neighbours from noises.
3 • Do not stand or sit on the outdoor unit. Do not place any object on the unit to avoid injury, do not remove the fan guard.• Do not place anything under the indoor or outdoor unit that must be kept away from moisture. In certain conditions, moisture in the air may condense and drip. • After a lon...
Page 5 - Names of parts; Indoor Unit
4 Names of parts ■ Indoor Unit 14 13 12 11 1 3 4 5 8 9 10 7 6 2 01_EN_3P175973-2A.fm Page 4 Monday, February 20, 2006 3:02 PM
Page 6 - Outdoor Unit
5 ■ Outdoor Unit ■ Indoor Unit 1. Air filter 2. Titanium Apatite Photocatalytic Air-Purifying Filter: • These filters are attached to the inside of the air filters. 3. Air inlet4. Front panel5. Panel tab6. Room temperature sensor: • It senses the air temperature around the unit. 7. Display8. Air out...
Page 7 - Remote Controller
6 ■ Remote Controller 1. Signal transmitter: • It sends signals to the indoor unit. 2. Display: • It displays the current settings. (In this illustration, each section is shown with all its displays ON for the purpose of explanation.) 3. POWERFUL button: POWERFUL operation (page 14.) 4. TEMPERATURE ...
Page 8 - Preparation Before Operation; To set the batteries; ATTENTION
7 Preparation Before Operation ■ To set the batteries 1. Slide the front cover to take it off. 2. Set two dry batteries (AAA). 3. Set the front cover as before. ATTENTION ■ About batteries • When replacing the batteries, use batteries of the same type, and replace the two old batteries together. • W...
Page 9 - Place the remote controller in the
8 Preparation Before Operation ■ To operate the remote controller • To use the remote controller, aim the transmitter at the indoor unit. If there is anything to block signals between the unit and the remote control-ler, such as a curtain, the unit will not operate. • Do not drop the remote controll...
Page 10 - To set the clock; Press “TIMER setting button” to; Turn the breaker ON; NOTE
9 ■ To set the clock 1. Press “CLOCK button”. is displayed. blinks. 2. Press “TIMER setting button” to set the clock to the present time. Holding down “ ” or “ ” button rapidly increases or decreases the time display. 3. Press “CLOCK button”. blinks. ■ Turn the breaker ON • Turning ON the breaker op...
Page 11 - AUTO · DRY · COOL · HEAT · FAN Operation; To start operation; Press “MODE selector button” and; To stop operation; Press “TEMPERATURE adjustment button”.
10 OPERATION AUTO · DRY · COOL · HEAT · FAN Operation The air conditioner operates with the operation mode of your choice.From the next time on, the air conditioner will operate with the same operation mode. ■ To start operation 1. Press “MODE selector button” and select a operation mode. • Each pre...
Page 12 - To change the air flow rate setting
11 ■ To change the air flow rate setting 5. Press “FAN setting button”. NOTE DRY mode AUTO or COOL or HEAT or FAN mode The air flow rate setting is not variable. Five levels of air flow rate setting from “ ” to “ ” plus “ ” are available. ■ Note on HEAT operation • Since this air conditioner heats t...
Page 13 - Adjusting the Air Flow Direction; When the flaps have reached the
12 Adjusting the Air Flow Direction You can adjust the air flow direction to increase your comfort. ■ To adjust the horizontal blades (flaps) 1. Press “SWING button”. • “ ” is displayed on the LCD and the flaps will begin to swing. 2. When the flaps have reached the desired position, press “SWING bu...
Page 14 - Notes on flaps and louvers angles
13 ■ To adjust the vertical blades (louvers) Hold the knob and move the louvers.(You will find a knob on the left-side and the right-side blades.) • When the unit is installed in the corner of a room, the direction of the louvers should be facing away from the wall.If they face the wall, the wall wi...
Page 15 - POWERFUL Operation; Press “POWERFUL button”
14 POWERFUL Operation POWERFUL operation quickly maximizes the cooling (heating) effect in any operation mode. You can get the maximum capacity. ■ To start POWERFUL operation 1. Press “POWERFUL button”. • POWERFUL operation ends in 20 minutes. Then the system automatically operates again with the se...
Page 16 - TIMER Operation; Press “TIMER Setting button”; To cancel the OFF TIMER operation
15 TIMER Operation Timer functions are useful for automatically switching the air conditioner on or off at night or in the morning. You can also use OFF TIMER and ON TIMER in combination. ■ To use OFF TIMER operation • Check that the clock is correct. If not, set the clock to the present time. (page...
Page 17 - To use ON TIMER operation; To combine ON TIMER and OFF TIMER
16 ■ To use ON TIMER operation • Check that the clock is correct. If not, set the clock to the present time (page 9.). 1. Press “ON TIMER button”. is displayed. blinks. 2. Press “TIMER Setting button” until the time setting reaches the point you like. • Every pressing of either button increases or d...
Page 18 - Care and Cleaning; CAUTION; Units
17 CARE Care and Cleaning CAUTION ■ Indoor unit, Outdoor unit and Remote controller 1. Wipe them with dry soft cloth. ■ Front panel 1. Open the front panel. • Hold the panel by the tabs on the two sides and lift it unitl it stops with a click. 2. Remove the front panel. • Lift the front panel up, sl...
Page 19 - Air Filter; Wash the air filters with water or clean them with; Filters
18 1. Open the front panel. (page 17.)2. Pull out the air filters. • Push a little upwards the tab at the center of each air filter, then pull it down. 3. Take off the Titanium Apatite Photo- catalytic Air-Purifying Filter. • Hold the recessed parts of the frame and unhook the four claws. 4. Clean o...
Page 20 - Check; Operate the “FAN only” for several hours on a fine day to dry out the
19 NOTE Check ■ Before a long idle period 1. Operate the “FAN only” for several hours on a fine day to dry out the inside. • Press “MODE” button and select “FAN” operation.• Press “ON/OFF” button and start operation. 2. After operation stops, turn off the breaker for the room air conditioner. 3. Cle...
Page 21 - Trouble Shooting; These cases are not troubles.
20 TROUBLE SHOOTING Trouble Shooting The following cases are not air conditioner troubles but have some reasons. You may just continue using it. These cases are not troubles. Case Explanation Operation does not start soon. • When ON/OFF button was pressed soon after operation was stopped. • When the...
Page 22 - Case
21 Please check again before calling a repair person. Check again. Case Check The air conditioner does not operate.(OPERATION lamp is off.) • Hasn’t a breaker turned OFF or a fuse blown?• Isn’t it a power failure?• Are batteries set in the remote controller?• Is the timer setting correct? Cooling (H...
Page 23 - Disposal requirements; Call the service shop immediately.
22 WARNING ■ When an abnormality (such as a burning smell) occurs, stop operation and turn the breaker OFF. Continued operation in an abnormal condition may result in troubles, electric shocks or fire.Consult the service shop where you bought the air conditioner. ■ Do not attempt to repair or modify...
Page 24 - MEMO
23 MEMO 01_EN_3P175973-2A.fm Page 23 Monday, February 20, 2006 3:02 PM
(H)-Specifications/webp/1.webp){kind=small}
(H)-Service-Manual/webp/1.webp){kind=small}
