Cypress CY7C1354C - Manual
Cypress CY7C1354C – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Selection Guide; Unit
- Page 3 – Pin Configurations
- Page 5 – TMS
- Page 6 – Pin Definitions
- Page 7 – Functional Overview
- Page 8 – ZZ Mode Electrical Characteristics
- Page 10 – Disabling the JTAG Feature; through a pull-up resistor. TDO should be; TAP Controller State Diagram; Performing a TAP Reset; A RESET is performed by forcing TMS HIGH (V; TAP Registers; Instruction Register
- Page 11 – ) when the BYPASS instruction is executed.; TAP Instruction Set; and t
- Page 12 – TAP Timing; Test Clock
- Page 14 – Scan Register Sizes; Register Name; Identification Codes; Instruction
- Page 17 – Electrical Characteristics
- Page 18 – Capacitance; Thermal Resistance; AC Test Loads and Waveforms
- Page 19 – Switching Characteristics
- Page 20 – Switching Waveforms
- Page 21 – NOP,STALL and DESELECT Cycles
- Page 22 – ZZ Mode Timing
- Page 23 – Ordering Information; Commercial
- Page 24 – visit
- Page 25 – Package Diagrams
- Page 28 – Document History Page; Issue Date
9-Mbit (256K x 36/512K x 18)
Pipelined SRAM with NoBL™ Architecture
CY7C1354C
CY7C1356C
Cypress Semiconductor Corporation
•
198 Champion Court
•
San Jose
,
CA 95134-1709
•
408-943-2600
Document #: 38-05538 Rev. *G
Revised September 14, 2006
Features
• Pin-compatible and functionally equivalent to ZBT
™
• Supports 250-MHz bus operations with zero wait states
— Available speed grades are 250, 200, and 166 MHz
• Internally self-timed output buffer control to eliminate
the need to use asynchronous OE
• Fully registered (inputs and outputs) for pipelined
operation
• Byte Write capability
• Single 3.3V power supply (V
DD
)
• 3.3V or 2.5V I/O power supply (V
DDQ
)
• Fast clock-to-output times
— 2.8 ns (for 250-MHz device)
• Clock Enable (CEN) pin to suspend operation
• Synchronous self-timed writes
• Available in lead-free 100-Pin TQFP package, lead-free
and non lead-free 119-Ball BGA package and 165-Ball
FBGA package
• IEEE 1149.1 JTAG-Compatible Boundary Scan
•
Burst capability
–
linear or interleaved burst order
• “ZZ” Sleep Mode option and Stop Clock option
Functional Description
[1]
The CY7C1354C and CY7C1356C are 3.3V, 256K x 36 and
512K x 18 Synchronous pipelined burst SRAMs with No Bus
Latency™ (NoBL
™)
logic, respectively. They are designed to
support unlimited true back-to-back Read/Write operations
with no wait states. The CY7C1354C and CY7C1356C are
equipped with the advanced (NoBL) logic required to enable
consecutive Read/Write operations with data being trans-
ferred on every clock cycle. This feature dramatically improves
the throughput of data in systems that require frequent
Write/Read transitions. The CY7C1354C and CY7C1356C are
pin compatible and functionally equivalent to ZBT devices.
All synchronous inputs pass through input registers controlled
by the rising edge of the clock. All data outputs pass through
output registers controlled by the rising edge of the clock. The
clock input is qualified by the Clock Enable (CEN) signal,
which when deasserted suspends operation and extends the
previous clock cycle.
Write operations are controlled by the Byte Write Selects
(BW
a
–BW
d
for CY7C1354C and BW
a
–BW
b
for CY7C1356C)
and a Write Enable (WE) input. All writes are conducted with
on-chip synchronous self-timed write circuitry.
Three synchronous Chip Enables (CE
1
, CE
2
, CE
3
) and an
asynchronous Output Enable (OE) provide for easy bank
selection and output tri-state control. In order to avoid bus
contention, the output drivers are synchronously tri-stated
during the data portion of a write sequence.
Note:
1. For best-practices recommendations, please refer to the Cypress application note
System Design Guidelines
on www.cypress.com.
A0, A1, A
C
MODE
BW
a
BW
b
WE
CE1
CE2
CE3
OE
READ LOGIC
DQs
DQP
a
DQP
b
DQP
c
DQP
d
D
A
T
A
S
T
E
E
R
I
N
G
O
U
T
P
U
T
B
U
F
F
E
R
S
MEMORY
ARRAY
E
E
INPUT
REGISTER 0
ADDRESS
REGISTER 0
WRITE ADDRESS
REGISTER 1
WRITE ADDRESS
REGISTER 2
WRITE REGISTRY
AND DATA COHERENCY
CONTROL LOGIC
BURST
LOGIC
A0'
A1'
D1
D0
Q1
Q0
A0
A1
C
ADV/LD
ADV/LD
E
INPUT
REGISTER 1
S
E
N
S
E
A
M
P
S
E
CLK
CEN
WRITE
DRIVERS
BW
c
BW
d
ZZ
SLEEP
CONTROL
O
U
T
P
U
T
R
E
G
I
S
T
E
R
S
Logic Block Diagram–CY7C1354C (256K x 36)
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
CY7C1354CCY7C1356C Document #: 38-05538 Rev. *G Page 2 of 28 A0, A1, A C MODE BW a BW b WE CE1CE2CE3 OE READ LOGIC DQsDQP a DQP b D A T A S T E E R I N G O U T P U T B U F F E R S MEMORY ARRAY E E INPUT REGISTER 0 ADDRESS REGISTER 0 WRITE ADDRESS REGISTER 1 WRITE ADDRESS REGISTER 2 WRITE REGISTRY AN...
CY7C1354CCY7C1356C Document #: 38-05538 Rev. *G Page 3 of 28 Pin Configurations A A A A A 1 A 0 V SS V DD A A A A A A V DDQ V SS DQb DQb DQb V SS V DDQ DQb DQb V SS NC V DD DQaDQa V DDQ V SS DQaDQa V SS V DDQ V DDQ V SS DQc DQc V SS V DDQ DQc V DD V SS DQd DQd V DDQ V SS DQdDQdDQd V SS V DDQ A A CE ...
CY7C1354CCY7C1356C Document #: 38-05538 Rev. *G Page 5 of 28 Pin Configurations (continued) 2 3 4 5 6 7 1 A B CD E F G H J K L M N P R TDO NC/576M NC/1G DQP c DQ c DQP d NC DQ d A CE 1 BW b CE 3 BW c CEN A CE2 DQ c DQ d DQ d MODE NC DQ c DQ c DQ d DQ d DQ d NC/36M NC/72M V DDQ BW d BW a CLK WE V SS ...
