Cisco UBR10-FAN-CAB= - Manual

8 Cisco uBR10012 Universal Broadband Router Fan Assembly Module OL-5093-01 Electrical Equipment Guidelines Follow these basic guidelines when working with any electrical equipment: • Before beginning any procedures requiring access to the chassis interior, locate the emergency power-off switch for t...

9 Cisco uBR10012 Universal Broadband Router Fan Assembly Module OL-5093-01 Removing and Replacing the Fan Assembly Module The fan assembly module does not need to be replaced when it is operating normally. If a failure LED comes on, use the following procedure to remove and reinsert the fan assembly...

10 Cisco uBR10012 Universal Broadband Router Fan Assembly Module OL-5093-01 Remove the Fan Assembly Module Step 1 Remove the front cover by lifting it up slightly and then pulling it toward you (see Figure 2 ). Step 2 Loosen the captive screws on each side of the fan assembly module. Step 3 Pull the...

11 Cisco uBR10012 Universal Broadband Router Fan Assembly Module OL-5093-01 Figure 3 Locations of Screws Install the Fan Assembly Module Step 1 Using two hands, align the new fan assembly module in the slot in the chassis, and push it back firmly. Make sure that the connectors on the can assembly se...

12 Cisco uBR10012 Universal Broadband Router Fan Assembly Module OL-5093-01 Remove the Cable To replace the fan assembly cable, perform the following steps: Step 1 Remove the front cover. Step 2 Remove the fan assembly. See the “Remove the Fan Assembly Module” section on page 10 . Step 3 See Figure ...

13 Cisco uBR10012 Universal Broadband Router Fan Assembly Module OL-5093-01 Step 1 Verify which connector goes in the bracket in the back of the chassis and which connector goes into the front connector. Step 2 Bend the cable in a “U” shape at both ends, to facilitate getting the cable into the rear...

14 Cisco uBR10012 Universal Broadband Router Fan Assembly Module OL-5093-01 • The following messages, if displayed, indicate that the system has detected a critical overtemperature condition or out-of-tolerance power inside the chassis: Queued messages: 00:01:19:%ENVM-4-ENVWARN:+2.5 V measured at +2...

15 Cisco uBR10012 Universal Broadband Router Fan Assembly Module OL-5093-01 You can access the Cisco website at this URL: http://www.cisco.com International Cisco websites can be accessed from this URL: http://www.cisco.com/public/countries_languages.shtml Documentation CD-ROM Cisco documentation an...

16 Cisco uBR10012 Universal Broadband Router Fan Assembly Module OL-5093-01 Obtaining Technical Assistance For all customers, partners, resellers, and distributors who hold valid Cisco service contracts, the Cisco Technical Assistance Center (TAC) provides 24-hour-a-day, award-winning technical supp...

17 Cisco uBR10012 Universal Broadband Router Fan Assembly Module OL-5093-01 Priority 4 (P4)—You require information or assistance with Cisco product capabilities, installation, or configuration. There is little or no effect on your business operations. Obtaining Additional Publications and Informati...