Cisco PA-2FE-TX - Manual

Cisco PA-2FE-TX

Cisco PA-2FE-TX – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.

1 Page 1
2 Page 2
3 Page 3
4 Page 4
5 Page 5
6 Page 6
7 Page 7
8 Page 8
9 Page 9
10 Page 10
11 Page 11
12 Page 12
13 Page 13
14 Page 14
15 Page 15
16 Page 16
17 Page 17
18 Page 18
19 Page 19
20 Page 20
21 Page 21
22 Page 22
23 Page 23
24 Page 24
25 Page 25
26 Page 26
27 Page 27
28 Page 28
29 Page 29
30 Page 30
31 Page 31
32 Page 32
33 Page 33
34 Page 34
35 Page 35
36 Page 36
37 Page 37
38 Page 38
39 Page 39
40 Page 40
41 Page 41
42 Page 42
43 Page 43
44 Page 44
45 Page 45
46 Page 46
47 Page 47
48 Page 48
49 Page 49
50 Page 50
51 Page 51
52 Page 52
53 Page 53
54 Page 54
55 Page 55
56 Page 56
57 Page 57
58 Page 58
59 Page 59
60 Page 60
61 Page 61
62 Page 62
63 Page 63
64 Page 64
65 Page 65
66 Page 66
67 Page 67
68 Page 68
69 Page 69
70 Page 70
71 Page 71
72 Page 72
73 Page 73
74 Page 74
75 Page 75
76 Page 76
77 Page 77
78 Page 78
79 Page 79
80 Page 80
81 Page 81
82 Page 82
Page: / 82

Table of Contents:

  • Page 3 – iii; C O N T E N T S; Preface; Overview
  • Page 4 – iv; Preparing for Installation; Removing and Installing Port Adapters; Configuring the PA-2FE
  • Page 5 – Using the show version or show hardware Commands
  • Page 7 – vii; Document Revision History, page vii; Document Revision History; Document Version; Adding Cisco 7201 router information.
  • Page 8 – viii; Objectives; Note; Section
  • Page 9 – ix; Cisco uBR7200 series routers:
  • Page 10 – Cisco 7304 PCI port adapter carrier card in Cisco 7304 router:
  • Page 11 – xi
  • Page 12 – xii
  • Page 13 – Port Adapter Slot Locations on the Supported Platforms, page 1-7; Port Adapter Overview; “Fast Ethernet
  • Page 14 – Fast Ethernet Overview; Cabling Specifications; Parameter
  • Page 15 – Maximum Segment and Network Lengths—100BASE--FX and 100BASE-TX; Data rate
  • Page 16 – LEDs; LED Label
  • Page 17 – RJ-45 Port and Connector; IRJ-45 Port Pinout Information; Pin; Ethernet port
  • Page 18 – Network Management; Definition of Managed Objects for Bridges (RFC 1493)
  • Page 19 – Port Adapter Slot Locations on the Supported Platforms; Cisco 7100 Series Routers Slot Numbering, page 1-7; Cisco 7100 Series Routers Slot Numbering; shows the slot numbering on a Cisco 7120 series router.; Port Adapter Slots in the Cisco 7120 Series Router
  • Page 20 – Port Adapter Slots in the Cisco 7140 Series Router; shows the slot numbering; Port Adapter Slots in the Cisco 7206 Router
  • Page 21 – Cisco uBR7200 Series Router Slot Numbering; shows the slot numbering of; Port Adapter Slots in the Cisco uBR7246VXR Router
  • Page 22 – Cisco 7201 Router Slot Numbering; Port Adapter Slot in the Cisco 7201 Router; Cisco 7301 Router Slot Numbering; Port Adapter Slot in the Cisco 7301 Router; Port adapter slot
  • Page 23 – Cisco 7304 PCI Port Adapter Carrier Card Slot Numbering; Module Slots on the Cisco 7304 Router; shows; Cisco 7304 PCI Port Adapter Carrier Card—Port Adapter Installed
  • Page 24 – Cisco 7401ASR Router Slot Numbering; Port Adapter Slot in the Cisco 7401ASR Router; Cisco 7500 Series Routers with VIP Slot Numbering; shows the slot numbering on a VIP.; VIP Slot Locations; VIP port adapter slot 0
  • Page 25 – VIP Slots in the Cisco 7505 Router
  • Page 26 – VIP Slots in the Cisco 7507 Router
  • Page 27 – VIP Slots in the Cisco 7513 Router
  • Page 28 – Identifying Interface Addresses; Platform
  • Page 29 – Cisco 7120 Router and Cisco 7140 Router Interface Addresses; Identifying Interface Addresses (continued)
  • Page 30 – Cisco uBR7200 Series Routers Interface Addresses
  • Page 31 – Cisco 7500 Series Routers VIP Interface Addresses
  • Page 33 – Software and Hardware Requirements, page 2-2; Required Tools and Equipment; VIP (for installation in Cisco 7500 series chassis only)
  • Page 34 – Software and Hardware Requirements; supported router or switch platforms.; Checking Hardware and Software Compatibility; PA-2FE Software Requirements; Cisco uBR7200 series routers
  • Page 35 – Safety Guidelines; Safety Warnings; Warning Definition
  • Page 37 – INSTRUCCIONES IMPORTANTES DE SEGURIDAD
  • Page 40 – Electrical Equipment Guidelines; Disconnect all power and external cables before moving a chassis
  • Page 41 – Telephone Wiring Guidelines; Never install telephone wiring during a lightning storm.; Preventing Electrostatic Discharge Damage; Following are guidelines for preventing ESD damage:
  • Page 42 – FCC Class A Compliance; Move the equipment farther away from the television or radio.
  • Page 43 – Port Adapter Removal and Installation, page 3-4; Handling Port Adapters
  • Page 44 – Handling a Port Adapter; Online Insertion and Removal; Caution
  • Page 45 – Rapidly scans the system for configuration changes.; Warnings and Cautions
  • Page 46 – Port Adapter Removal and Installation; Cisco 7100 Series—Removing and Installing a Port Adapter, page 3-5
  • Page 47 – Cisco 7100 Series—Removing and Installing a Port Adapter; Unlocked; Guides
  • Page 48 – Port adapter lever
  • Page 49 – Cisco uBR7200 Series Routers—Removing a Port Adapter; Port adapters
  • Page 50 – Cisco uBR7200 Series Routers—Installing a Port Adapter; Inside
  • Page 51 – Cisco 7201 Router—Removing and Installing a Port Adapter
  • Page 52 – Cisco 7301 Router—Removing and Installing a Port Adapter
  • Page 55 – Cisco 7401ASR Router—Removing and Installing a Port Adapter; Locked
  • Page 56 – Remove a module as follows:
  • Page 57 – Removing and Installing the Port Adapter in the VIP Carrier Card
  • Page 58 – Use the following procedure to connect RJ-45 or SC cables:
  • Page 59 – Connecting PA-2FE-FX SC Cables—Horizontal Orientation
  • Page 61 – This chapter contains the following sections:; Using the EXEC Command Interpreter; To configure the new interfaces, proceed to the
  • Page 62 – Configuring the Interfaces; Shutting Down an Interface
  • Page 63 – shows the command syntax for the; Examples of the shutdown Command for the Supported Platforms
  • Page 64 – shutdown
  • Page 66 – Re-enable interfaces by doing the following:; VIP in Cisco 7500 series routers
  • Page 67 – Performing a Basic Interface Configuration; The example is for interface 0 of a PA-2FE in slot 4.
  • Page 68 – Re-enable the interfaces using the no shutdown command. (See the; “Shutting Down an Interface”
  • Page 69 – Checking the Configuration; Using show Commands to Verify the New Interface Status, page 4-9; Using show Commands to Verify the New Interface Status; “Related Documentation” section on page viii; Using show Commands; Command; show diag slot
  • Page 70 – This section includes the following subsections:; when you have finished using the show commands.
  • Page 72 – Cisco 7201 Router—Example Output of the show version Command
  • Page 73 – Cisco 7401ASR Router—Example Output of the show version Command
  • Page 74 – Using the show diag Command
  • Page 75 – Cisco 7100 Series Routers—Example Output of the show diag Command
  • Page 76 – Cisco 7201 Router—Example Output of the show diag Command
  • Page 77 – Cisco 7401ASR Routers—Example Output of the show diag Command
  • Page 78 – Using the show interfaces Command; “Related Documentation” section on
  • Page 80 – Cisco 7201 Router—Example Output of the show interfaces Command
  • Page 81 – Using the ping Command to Verify Network Connectivity; “Related
Loading the manual

Americas Headquarters

Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134-1706
USA
http://www.cisco.com
Tel: 408

526-4000

800 553-NETS (6387)

Fax: 408

527-0883

PA-2FE-TX and PA-2FE-FX Two-Port Fast
Ethernet Port Adapter Installation and
Configuration

Product Number: PA-2FE-TX=, PA-2FE-FX=
Platforms Supported: Cisco 710 0 Series Routers, Cisco 720 0 Series Routers,
Cisco uBR7200 Series Routers, Cisco 7200 VXR Routers, Cisco 7201 Router,
Cisco 7301 Router, Cisco 7304 PCI Port Adapter Carrier Card in the Cisco 7304
Router, Cisco 7401ASR Router, and VIP in the Cisco 7500 Series Routers

Text Part Number: OL-3474-07

"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.

Summary

Page 3 - iii; C O N T E N T S; Preface; Overview

iii PA-2FE-TX and PA-2FE-FX Two-Port Fast Ethernet Port Adapter Installation and Configuration OL-3474-07 C O N T E N T S Preface vii Document Revision History vii Objectives viii Organization viii Related Documentation viii Obtaining Documentation, Obtaining Support, and Security Guidelines xi C H ...

Page 4 - iv; Preparing for Installation; Removing and Installing Port Adapters; Configuring the PA-2FE

Contents iv PA-2FE-TX and PA-2FE-FX Two-Port Fast Ethernet Port Adapter Installation and Configuration OL-3474-07 C H A P T E R 2 Preparing for Installation 2-1 Required Tools and Equipment 2-1 Software and Hardware Requirements 2-2 Checking Hardware and Software Compatibility 2-2 Safety Guidelines ...

Page 5 - Using the show version or show hardware Commands

Contents v PA-2FE-TX and PA-2FE-FX Two-Port Fast Ethernet Port Adapter Installation and Configuration OL-3474-07 Using the show version or show hardware Commands 4-11 Using the show diag Command 4-14 Using the show interfaces Command 4-18 Using the ping Command to Verify Network Connectivity 4-21

Other Cisco Models

All Cisco Other