Cisco OL-5512-01 - Manual
Cisco OL-5512-01 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Network Configuration Window (Cisco Router Selected); Adding Routers in Cisco WAPMS; Toolset Selector
- Page 3 – Edit an Access Line Window; Click; ASE Setup; The ASE Configuration window, shown in
- Page 4 – ASE Configuration Window; Option
- Page 5 – Configuring ATM and Frame Relay Circuits; Circuits; DLCI Configuration Window for Frame Relay Circuits
- Page 6 – VPI/VCI Configuration Window for ATM Circuits; in the; ATM VC Settings for Cisco Routers; Maximum rate at which cells can be sent over this VPI/VCI.; ATM Adaptation Layer; and
C H A P T E R
6-1
Cisco WAN Access Performance Management System User Guide, 2.1
OL-5512-01
6
Adding Cisco IOS Routers to Cisco WAPMS
This chapter explains how to add Cisco IOS-based routers to Cisco WAPMS using the Network
Configuration application in the PAC.
For more information about using Network Configuration, see
Chapter 3, “Network Configuration,”
the
Cisco WAN Access Performance Management System Client User Guide, 2.1
.
The following topics are discussed in this chapter:
•
“Adding Routers in Network Configuration”
•
“Configuring ATM and Frame Relay Circuits” section on page 6-5
Note
Throughout the Cisco WAPMS documentation, the term ASE refers to Cisco routers running
SAA-ATM/FR and/or Visual Networks ASE probes.
Adding Routers in Network Configuration
In order for Cisco WAPMS to recognize Cisco routers, you must add them to your network using the
Cisco WAPMS PAC Network Configuration Toolset. All configuration tasks for networks, sites, access
lines, ASEs (and routers), and circuits are initiated from the Network Configuration window. See
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
6-2 Cisco WAN Access Performance Management System User Guide, 2.1 OL-5512-01 Chapter 6 Adding Cisco IOS Routers to Cisco WAPMS Adding Routers in Network Configuration Figure 6-1 Network Configuration Window (Cisco Router Selected) As you configure an access line, you can verify settings for the Cis...
6-3 Cisco WAN Access Performance Management System User Guide, 2.1 OL-5512-01 Chapter 6 Adding Cisco IOS Routers to Cisco WAPMS Adding Routers in Network Configuration Step 6 In the Add/Edit an Access Line window, enter the name of the access line and the IP address of the device. Figure 6-2 Edit an...
6-4 Cisco WAN Access Performance Management System User Guide, 2.1 OL-5512-01 Chapter 6 Adding Cisco IOS Routers to Cisco WAPMS Adding Routers in Network Configuration Figure 6-3 ASE Configuration Window Step 8 In the ASE Configuration window for ATM routers, click ATM to verify the WAN link layer p...
