Cisco MGX 8850 System - Manual
Cisco MGX 8850 System – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Installing Plastic Motherboard Insulator in an MGX 8850 System; Underside of chassis
- Page 3 – Warning
- Page 4 – This completes the installation of the plastic insulating cover.
Corporate Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706. USA
Copyright © 2000. Cisco Systems, Inc. All rights reserved
.
78-10389-01
Installing Plastic Motherboard Insulator in an
MGX 8850 System
Installing Backplane Plastic Insulating Cover
Use the following procedure to install the insulating cover over a system’s backplane. This procedure
may be done without powering down the system.
Step 1
Open the plastic grill on the front side of the intake plenum, located directly underneath the card cage
or the fan space, using a flat blade screw driver to loosen the two recessed screws. Tilt the plastic grill
forward about 45 degrees, then lift out and set it aside.
Step 2
Hold the plastic cover, shown in the drawing below, so that the 16 short tabs are facing towards you.
43776
3 Tabs
Short tabs
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Installing Plastic Motherboard Insulator in an MGX 8850 System 78-10389-01 Step 3 The next illustration shows the clear plastic backplane cover viewed from the bottom toward the top of the cabinet. Step 4 Slide the clear plastic backplane cover underneath the card cage and toward the bottom of the...
3 Installing Plastic Motherboard Insulator in an MGX 8850 System 78-10389-01 Step 5 Align the two cutouts on the plastic cover with the two sheetmetal flanges located directly behind the backplane. Make sure the three tabs on the plastic cover are hooked inside the sheet metal flange. Warning A high...
4 Installing Plastic Motherboard Insulator in an MGX 8850 System 78-10389-01 Step 6 Press the center of the plastic cover to snap the tabs into the card cage perforations as shown in the illustration below. Keep the plastic cover between your fingers and the motherboard. Step 7 Continue to press the...
