Cisco MEM-C6K-FLC64M - Manual
Cisco MEM-C6K-FLC64M – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Contents; Supervisor Engine Flash PC Cards
- Page 3 – Preventing Electrostatic Discharge Damage; Installing and Removing a Flash PC Card
- Page 6 – Using Flash PC Cards
- Page 8 – Additional Documentation; Obtaining Documentation; Product Documentation DVD
- Page 9 – Ordering Documentation; Documentation Feedback; Cisco Product Security Overview
- Page 10 – Reporting Security Problems in Cisco Products; Obtaining Technical Assistance; Cisco Technical Support & Documentation Website
- Page 11 – Submitting a Service Request; Definitions of Service Request Severity
- Page 12 – Obtaining Additional Publications and Information
Corporate Headquarters:
© 1999–2005 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Catalyst 6500 Series Supervisor Engine Flash PC
Card Installation Note
Product Numbers:
MEM-C6K-FLC16M(=)
MEM-C6K-FLC24M(=)
MEM-C6K-FLC64M(=)
MEM-C6K-ATA-1-64M(=)
This installation note contains the procedure to install a Flash PC card in the Catalyst 6500 series
supervisor engines.
Note
The 64-MB ATA Flash PC card (MEM-C6K-ATA-1-64M) requires Supervisor Engine 2 with ROMMON
software release 7.1(1) or later releases. For ROMMON software upgrade details, refer to
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/relnotes/78_13488.htm.
The ATA Flash PC card is supported on Catalyst 6500 series switches running Cisco IOS Release
12.1(8a)EX or later releases on both the supervisor engine and the Multilayer Switch Feature Card
(MSFC).
The ATA Flash PC card is supported on Catalyst 6500 series switches running Catalyst software
release 7.5(1) or later releases on the supervisor engine and Cisco IOS on the MSFC.
Note
The 64-MB linear Flash PC card (MEM-C6K-FLC64M) is supported only on Supervisor Engine 1 and
requires ROMMON software release 5.3(1) or later releases.
The 64-MB linear Flash PC card is supported on Catalyst 6500 series switches running Cisco IOS
Release 12.1(13)E4 or later releases on both the supervisor engine and the MSFC.
The 64-MB linear Flash PC card is supported on Catalyst 6500 series switches running Catalyst software
release 7.5(1) or later releases on the supervisor engine and Cisco IOS software on the MSFC.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Catalyst 6500 Series Supervisor Engine Flash PC Card Installation Note 78-6507-06 Contents Contents This installation note contains the following sections: • Supervisor Engine Flash PC Cards, page 2 • Preventing Electrostatic Discharge Damage, page 3 • Installing and Removing a Flash PC Card, page...
3 Catalyst 6500 Series Supervisor Engine Flash PC Card Installation Note 78-6507-06 Preventing Electrostatic Discharge Damage Figure 1 Supervisor Engine Flash PC Card Slot For information about using the PCMCIA Flash PC cards, see the “Using Flash PC Cards” section on page 6 . Preventing Electrostat...
6 Catalyst 6500 Series Supervisor Engine Flash PC Card Installation Note 78-6507-06 Using Flash PC Cards Using Flash PC Cards Note An MS-DOS formatted ATA Flash PC card or linear Flash PC card can be accessed successfully(including the dir command) with the Catalyst and Cisco IOS operating systems b...
