Cisco CISCO1811 - Manual
Cisco CISCO1811 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – How to Connect Your Equipment; For detailed descriptions, see below; Figure 1
- Page 3 – Configure Your Router; Internet Connectivity; DHCP Assignment; anything other than DHCP; some additional configuration is; Go to “Appendix A: CCP Configuration” in this document and; Corporate Network Connectivity; Test your Internet connection.
- Page 4 – Figure 2; must; Figure 3; URL; Figure 4
- Page 5 – After you click; Next; Authenticate yourself.; Figure 5; Figure 6
- Page 6 – Select; Figure 7; Verify that your CVO router has a VPN Light on in the front.; VPN LED; lit; solid green; restart your PC – this will automatically renew its IP address
- Page 7 – Figure 8; Appendix A: CCP Configuration; Figure 9
- Page 9 – Basic Configuration
- Page 10 – SDP for Router Provisioning
- Page 11 – PPPoE
- Page 12 – Static IP Addresses; Choose whether or not to create a default route (
- Page 13 – Default Route; and
- Page 14 – Summary Page PPPoE
- Page 15 – Summary Page Static
Americas Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Cisco Virtual Office – End User Instructions for
Cisco 1811 Router Set Up at Home or Small Office
Introduction
This document describes the end-user instructions to deploy the Cisco Virtual Office (CVO) for home or
small office use.
Cisco Virtual Office (CVO) solution offers a seamless home/small office experience comparable to
working in your company’s central office. CVO features support secure, always-on wired and wireless
(WLAN) data connectivity, voice services, and video capabilities.
Setup Your CVO Hardware
In this section you will be able to identify the basic hardware configuration needed to install the CVO
solution in your home/office. This is a known working configuration to assist you in your initial set-up
and is not intended to cover all variations of home/office network environments. This guide is written
based on Cisco 1811 routers.
Ports on the CVO Router
It is important that you understand which ports on the back of your CVO router are used for what
purposes.
•
FE1 to FE9: LAN Ports FE1 to FE9 are end-user device secure ports. Connect your
PC/Mac/Linux/IP phone equipment here.
•
FE0: Use the WAN/FE0 port to connect your CVO router to your Internet Service Provider (ISP)
device.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Cisco Virtual Office – End User Instructions for Cisco 1811 Router Set Up at Home or Small Office 78-18859-01 SETUP YOUR CVO HARDWARE How to Connect Your Equipment This scenario shows an example of your company’s provided devices and the Internet Service Provider (ISP) device (modem/router) proper...
3 Cisco Virtual Office – End User Instructions for Cisco 1811 Router Set Up at Home or Small Office 78-18859-01 CONFIGURE YOUR ROUTER Configure Your Router Once you have set up your CVO hardware you will need to configure your router so that you can access the Internet and your company’s corporate n...
4 Cisco Virtual Office – End User Instructions for Cisco 1811 Router Set Up at Home or Small Office 78-18859-01 CONFIGURE YOUR ROUTER Figure 2 SDP Authentication If you’re using DHCP, to initiate the SDP process, go to the PC which is connected to the CVO router and open a browser window. Then type ...
