Cisco CISCO1751 - Manual
Cisco CISCO1751 – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – Conventions; boldface; italic; boldface screen font; Installing WAN and Voice Interface Cards; If You Are Installing Voice Interface Cards; Note
- Page 3 – Warning; WIC and VIC Installation Procedure; Follow these steps, and refer to
- Page 4 – If you need more detailed installation instructions, refer to the
- Page 5 – Figure 4; Pin; Ring
- Page 6 – Checking FXS VIC Installation; show voice port
- Page 7 – The card is illustrated in; Connecting the 2-Port ISDN BRI Card; Caution
- Page 8 – ISDN BRI Card LEDs; Table 4; Determining Voice Port Numbering; Figure 8 on page 9; LED
- Page 9 – Example; Cisco Router and Security Device Manager; Cisco Router and Security Device Manager (SDM)
- Page 10 – Configuration Tools; Cisco ConfigMaker Application
- Page 11 – Cisco ConfigMaker; Cisco IOS Command-Line Interface; Series Software Configuration Guide,; Major Voice over IP Configuration Tasks; Cisco 1751 Router Software Configuration Guide
- Page 12 – Information for International Users; cptone; Entering Configuration Mode; yes
- Page 13 – Saving the Configuration; end
- Page 14 – Dial Plan; session target; Wildcards and Number Expansion; Table 5
- Page 15 – You can use the; show; command to see how a telephone number maps to a dial peer.; Configuring FXS Interfaces; Extension
- Page 16 – hostname; “Determining Voice Port Numbering”; Local Dial Peers; Telephone Number; Telephone Number
- Page 17 – voice; destination pattern
- Page 18 – Enter the following commands to configure the local ports on the; These commands are summarized in
- Page 19 – Checking Dial Peer Configuration; no shutdown; Calling Between Routers; Table 9; Remote Location
- Page 20 – dns
- Page 21 – Other Routers on the Network; “Configuring FXS Interfaces”; Checking FXS Configuration; Configuring FXO Interfaces
- Page 23 – Checking FXO Configuration; Configuring E&M Interfaces; Command
- Page 25 – shutdown; Checking E&M Interface Configuration; Tuning Parameters for Real-Time Voice Traffic
- Page 26 – Need for Quality of Service; IP Precedence; Use the; The; ip precedence; voice packets a higher priority over other IP data traffic.
- Page 27 – RSVP; ip rtp reserve; Configuring RSVP; ip rsvp bandwidth; Cisco 1751 Router Software Configuration; Multilink PPP Interleaving
- Page 28 – Configuring Multilink PPP Interleaving; milliseconds; interface virtual-template; RTP Header Compression; Configuring RTP Header Compression; ip rtp; ip rtp header-compression
- Page 29 – Configuring Frame Relay for VoIP
- Page 30 – List of Terms
- Page 31 – remote dial peer; Obtaining Documentation; Ordering Documentation
- Page 32 – Documentation Feedback; We appreciate your comments.; Obtaining Technical Assistance; Cisco Technical Support Website
- Page 33 – For a complete list of Cisco TAC contacts, go to this URL:; Definitions of Service Request Severity; Obtaining Additional Publications and Information; The Cisco
- Page 34 – iQ Magazine
Corporate Headquarters:
Copyright © 2003 Cisco Systems, Inc. All rights reserved.
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Cisco 1751 Voice-over-IP Quick Start Guide
The Cisco 1751 Voice over IP Quick Start Guide explains how to install WAN Interface Cards and Voice
Interface Cards, how to run configuration tools, and how to perform essential Voice-over-IP (VoIP)
configuration tasks.
This document contains the following sections:
•
•
•
Installing WAN and Voice Interface Cards, page 2
•
Cisco Router and Security Device Manager, page 9
•
Configuring Voice-over-IP, page 10
•
•
Obtaining Documentation, page 31
•
Documentation Feedback, page 32
•
Obtaining Technical Assistance, page 32
•
Obtaining Additional Publications and Information, page 33
Audience
This guide is intended primarily for users who configure and maintain routers, but are not necessarily
familiar with tasks, the relationship between tasks, or the commands necessary to perform particular
tasks to configure VoIP. We assume that you are familiar with Cisco IOS software, IP and telephony
networks, and PBX operation for E&M installations.
List of Terms provides definitions for many of the technical terms used in this document.
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
2 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Conventions Conventions This document uses the following conventions: • Commands and keywords are in boldface . • Optional keywords or arguments are in square brackets. • Variables for which you supply values are in italic . • Titles of public...
3 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Installing WAN and Voice Interface Cards Figure 1 Voice Interface Card You should install and cable VICs before performing the software configuration tasks explained later in this guide. Warning Be sure to observe all warnings and safety preca...
4 Cisco 1751 Voice-over-IP Quick Start Guide 78-11259-05 Installing WAN and Voice Interface Cards Figure 2 Inserting a WIC or VIC in the Router If you need more detailed installation instructions, refer to the Cisco WAN Interface Cards Hardware Installation Guide . Connecting the FXS, FXO, and E&...
