Chief PLP Series - Manual
Chief PLP Series – Manual, read for free online in PDF format. We hope this helps you resolve any issues you may have. If you have further questions, please contact us through the contact form.
Table of Contents:
- Page 2 – , and located on the product information page for the mount.; BEFORE YOU BEGIN; IMPORTANT WARNINGS and CAUTIONS!; not follow the corresponding instructions.
- Page 4 – CONTENTS; Drill and drill bit set; PARTS LIST
- Page 5 – PLP INSTALLATION; Select Mounting Location; WARNING: It is the responsibility of the installer to; OR; Figure 2. Use Triangular Hole to Hang the Mount
- Page 6 – Mount the PLP; Holding the PLP against the wall, select the pair of; right of; left; Figure 5. Mounting Holes – 16” Apart on Center
- Page 7 – ATTACH PSB TO THE DISPLAY; INSTALL THE DISPLAY; Figure 8. Install the Display
- Page 8 – TILT ADJUSTMENT; Figure 10. Tilt Display Down
CHIEF MANUFACTURING INC.
8805-000183 Rev F
1-800-582-6480
952-894-6280 FAX 952-894-6918
©
2008 Chief Manufacturing
8401 EAGLE CREEK PARKWAY, STE. 700
SAVAGE, MINNESOTA 55378 USA 03/08
I N S T A L L A T I O N I N S T R U C T I O N S
PLP Series Wall Mount
The PLP Series wall mount accommodates large flat
screens weighing up to 200 lbs (90.72kg). The teardrop
holes in the mount allow for quick connect/disconnect of
the screen, thus simplifying installation and maintena nce
processes.
The top and bottom mounting brackets are adaptable to
supporting framework with wood studs that are 16” on
center or 24”on center.
The mount has integrated lateral shift, allowing for four
different mounting options. For dual wood studs 16” on
center, the lateral shift is
+
4.5 inches. For dual wood
studs 24” on center, the lateral shift is
+
0.5 inches.
The display can be pulled and tilted by hand into any
position in the zero-to-15 degree tilt range and remain
stationary.
The bottom of the mount pulls forward 4” from the wall
and locks into place for installation of cable connections.
The mount also uses Chief’s exclusive Q-Latch™
mounting system, which offers quick connect/disconnect
display mounting. The display is secured to the mount
with a latching flag. For additional security, you can lock
the latching flag in place by adding a padlock.
PLP Series
"Loading the manual" means you need to wait until the file loads and becomes available for online reading. Some manuals are very large, and the time they take to appear depends on your internet speed.
Summary
Installation Instructions PLP Series 2 ! IMPORTANT: If the installation of this product requires OSHPD seismic approval, refer to OSHPD pre-approval documents and drawings before beginning installation. OSHPD documents and drawings are available at www.chiefmfg.com , and located on the product infor...
Installation Instructions PLP Series 4 CONTENTS DIMENSIONAL DRAWING ..................................... 3TOOLS REQUIRED FOR INSTALLATION.............. 4PARTS LIST .............................................................. 4PLP INSTALLATION ................................................ 5 Sel...
Installation Instructions PLP Series 5 PLP INSTALLATION Perform the following procedures to mount the PLP. Select Mounting Location To select the mounting location, do the following: WARNING: It is the responsibility of the installer to verify that the wall to which the mount isanchored will safely ...
